Determination of Rare Earth Elements in Natural Water Samples by Rapid Sequential High-Resolution Continuum Source Flame Atomic Absorption Spectrometry (HR CS FAAS) and inductively Coupled Plasma-Mass Spectrometry (ICP-MS)

The highly selective green colorimetric detection of yttrium ions in biological and environmental samples using the synergistic effect in an optical sensor

A new eco-friendly method for creating an optical sensor membrane specifically designed to detect yttrium ions (Y3+) has been developed. The proposed sensor membrane is fabricated by integrating 4-(2-arsonophenylazo) salicylic acid (APASA), sodium tetraphenylborate (Na-TPB), and tri-n-octyl phosphine oxide (TOPO) into a plasticized poly(vinyl chloride) matrix with dimethyl sebacate (DMS) as the plasticizer. In this sensor membrane, APASA functions dually as an ionophore and a chromoionophore, while TOPO enhances the complexation of Y3+ ions with APASA. The composition of the sensor membrane has been meticulously optimized to achieve peak performance. The current membrane exhibits a linear dynamic range for Y3+ ions from 8.0 × 10-9 to 2.3 × 10-5 M, with detection and quantification limits of 2.3 × 10-9 and 7.7 × 10-9 M, respectively. No interference from other potentially interfering cations and anions was observed in the determination of Y3+. The membrane showed strong stability and a swift response time of about 3.0 minutes, with no signs of APASA leaching. This sensor is highly selective for Y3+ ions and can be renewed by treating it with 0.15 M HNO3. It has been effectively applied to measure Y3+ in nickel-based alloys, as well as in biological and environmental samples.

Presence of other rare earth metals in gadolinium-based contrast agents

Gadolinium-based contrast agents (GBCA) are widely used to enhance tissue contrast during magnetic resonance imaging (MRI) procedures. However, free Gadolinium (Gd) is undesirable as a drug substance, due to its high toxicity. Consequently, a coordinating ligand is required to keep it in solution and to increase tolerance. In order to achieve an adequate performance, GBCA must be administered in relatively large amounts. Chelate amounts are around 13-20 g and for Gd alone, this may amount to 3.3 g. Taking into account the route of administration, impurities in GBCA may be significant. Gadolinium occurs in nature along with 16 other elements known collectively as rare earth metals (RE), which are found throughout the earth's crust in minerals such as monazite. Gadolinium oxide corresponds to 0.7-4.0% of the RE present in minerals, and the sum concentration of RE in minerals is around 4%. Rare earth metals are difficult to separate, as the chemical and physical properties of one RE are significantly similar to those of others. In this study, the presence of other RE in GBCA formulations was investigated. Different lots of Magnevist®, Viewgam®, OptiMARK®, Omniscan®, Dotarem®, and Gadovist® were analyzed. Inductively-coupled plasma mass spectrometry and atomic absorption spectrometry were used for RE determination. Procedure optimization included sample decomposition and method validation for element determination. The results showed that Sc, Y, La, Ce, Pr, Nd, Eu, Tb, Tm, Dy, Ho, and Er were present in the 22 samples analyzed. Terbium, Thulium, Europium, and Lanthanum were, on average, found in the highest amounts, which were 0.42 mg/L, 0.17 mg/L, 0.17 mg/L, and 0.16 mg/L, respectively. These results could be attributed to the similarity among Europium, Gadolinium, and Terbium. They are in sequence in the periodic table and therefore present very close ionic radii, restricting their separation. Considering the sum of all RE, Viewgam® was the most contaminated formulation (mean of 2.16 mg/L) and Magnevist® the least (mean of 0.64 mg/L). Although the RE are chemically similar, the other RE do not perform as Gd as a contrast agent; therefore, their presence in formulations may be a matter of concern.