Applying grazing incidence X-ray reflectometry (XRR) to characterising nanofilms on mica

Molecularly smooth mica has hitherto not been widely used as a substrate for the X-ray reflectometry (XRR) technique. That is largely due to the difficulty of achieving flatness over a sufficiently large area of mica. Here we show that this difficulty can be overcome by slightly bending the mica substrate over an underlying cylinder; the enhanced rigidity of the bent mica sheet along the axis of the cylinder provides sufficient flatness along this axis for XRR measurements. To test this method, we have employed it to characterise three types of nanofilms on mica in air: (A) Cr-Au thin films; (B) a surface-grown zwitterionic polymer brush; and (C) a Langmuir-Blodgett (LB) phospholipid monolayer, using a table-top X-ray reflectometer. Fitting the obtained reflectivity curves with the standard Parratt algorithm allows us to extract the structural information of the nanofilms (both thickness and apparent roughness). Our simple method points to how XRR may be exploited as a useful characterisation tool for nanofilms on mica.

Boundary lubrication under water

Boundary lubrication, in which the rubbing surfaces are coated with molecular monolayers, has been studied extensively for over half a century. Such monolayers generally consist of amphiphilic surfactants anchored by their polar headgroups; sliding occurs at the interface between the layers, greatly reducing friction and especially wear of the underlying substrates. This process, widespread in engineering applications, is also predicted to occur in biological lubrication via phospholipid films, though few systematic studies on friction between surfactant layers in aqueous environments have been carried out. Here we show that the frictional stress between two sliding surfaces bearing surfactant monolayers may decrease, when immersed in water, to as little as one per cent or less of its value in air (or oil). We attribute this to the shift of the slip plane from between the surfactant layers, to the surfactant/substrate interface. The low friction would then be due to the fluid hydration layers surrounding the polar head groups attached to the substrate. These results may have implications for future technological and biomedical applications.

Effect of end-group sticking energy on the properties of polymer brushes: Comparing experiment and theory

Using surface force balance measurements we have established that polystyrene chains bearing three zwitterionic groups have a higher end-group sticking energy than equivalent chains bearing a single zwitterionic group. In a good solvent, polystyrene chains end-functionalized with three zwitterionic groups form brushes of a higher surface coverage than those bearing a single zwitterion. The increase in surface coverage is slow compared with the initial formation of the brush. Measurements of the refractive index allow us to directly quantify the variation of surface coverage, permitting comparison with models for the kinetics of brush formation based on scaling theory and an analytical self-consistent field. We find qualitative support for associating the kinetic barrier with the energy required for an incoming chain to stretch as it penetrates the existing brush.