Isolation and characterization of a thermophilic lipase from bacillus thermoleovorans ID-1

Optimization of a thermostable lipase from Bacillus stearothermophilus P1: overexpression, purification, and characterization

An expression library was generated from a partial NcoI and HindIII digest of genomic DNA from the thermophilic bacterium, Bacillus stearothermophilus P1. The DNA fragments were cloned into the expression vector pQE-60 and transformed into Escherichia coli M15[EP4]. Sequence analysis of a lipase gene showed an open reading frame of 1254 nucleotides coding a 29-amino-acid signal sequence and a mature sequence of 388 amino acids. The expressed lipase was isolated and purified to homogeneity in a single chromatographic step. The molecular mass of the lipase was determined to be approximately 43 kDa by SDS-PAGE and mass spectrometry. The purified lipase had an optimum pH of 8.5 and showed maximal activity at 55 degrees C. It was highly stable in the temperature range of 30-65 degrees C. The highest activity was found with p-nitrophenyl ester-caprate as the synthetic substrate and tricaprylin as the triacylglycerol. Its activity was strongly inhibited by 10 mM phenylmethanesulfonyl fluoride and 1-hexadecanesulfonyl chloride, indicating that it contains a serine residue which plays a key role in the catalytic mechanism. In addition, it was stable for 1 h at 37 degrees C in 0.1% Chaps and Triton X-100.

Over-expression and properties of a purified recombinant Bacillus licheniformis lipase: a comparative report on Bacillus lipases

The gene coding for an extracellular lipase of Bacillus licheniformis was cloned using PCR techniques. The sequence corresponding to the mature lipase was subcloned into the pET 20b(+) expression vector to construct a recombinant lipase protein containing 6 histidine residues at the C-terminal. High-level expression of the lipase by Escherichia coli cells harbouring the lipase gene-containing expression vector was observed upon induction with IPTG at 30 degrees C. A one step purification of the recombinant lipase was achieved with Ni-NTA resin. The specific activity of the purified enzyme was 130 units/mg with p-nitrophenyl-palmitate as substrate. The enzyme showed maximum activity at pH 10-11.5 and was remarkably stable at alkaline pH values up to 12. The enzyme was active toward p-nitrophenyl esters of short to long chains fatty acids but with a marked preference for esters with C(6) and C(8) acyl groups. The amino acid sequence of the lipase shows striking similarities to lipases from Bacillus subtilis and Bacillus pumilus. Based on the amino acid identity and biochemical characteristics, we propose that Bacillus lipases be classified into two distinct subfamilies of their own.

A novel extracellular esterase from Bacillus subtilis and its conversion to a monoacylglycerol hydrolase

A novel gene lipB, which encodes an extracellular lipolytic enzyme, was identified in the Bacillus subtilis genomic DNA sequence. We have cloned and overexpressed lipB in B. subtilis and Escherichia coli and have also purified the enzyme from a B. subtilis culture supernatant to electrophoretic homogeneity. Four different lipase assays were used to determine its catalytic activity: pH-stat, spectrophotometry, fluorimetry and the monomolecular film technique. LipB preferentially hydrolysed triacylglycerol-esters and p-nitrophenyl-esters of fatty acids with short chain lengths of </= 10 carbon atoms. Triolein, which is a typical substrate for true lipases, was not hydrolysed at all. These results led us to classify LipB as an esterase rather than a lipase. The catalytic triad of LipB consists of residues Ser78, Asp134, and His157 as demonstrated by amino-acid sequence alignments and site-directed mutagenesis. The nucleophile Ser78 is located in a lipase-specific consensus sequence, which is Ala-X-Ser-X-Gly for most Bacillus lipases. All other bacterial lipases contain a glycine residue instead of the alanine at position-2 with respect to the catalytic serine. We have investigated the role of this alanine residue by constructing LipB variant A76G, thereby restoring the lipase-specific consensus motif. When compared with LipB this variant showed a markedly reduced thermostability but an increased stability at pH 5-7. Determination of the specific activities of wild-type LipB and variant A76G using a monomolecular film of the substrate monoolein revealed an interesting result: the A76G substitution had converted the esterase LipB into a monoacylglycerol hydrolase.

Cloning, sequencing and expression in Escherichia coli of a thermophilic lipase from Bacillus thermoleovorans ID-1

A thermophilic lipase of Bacillus thermoleovorans ID-1 was cloned and sequenced. The lipase gene codes 416 amino acid residues and contains the conserved pentapeptide Ala-X-Ser-X-Gly as other Bacillus lipase genes. The optimum temperature of the lipase is 75 degrees C, which is higher than other known Bacillus lipases. For expression in Escherichia coli, the lipase gene was subcloned in pET-22b(+) vector with a strong T7 promoter. Lipase activity was approximately 1.4-fold greater than under the native promoter.

Enzymatic degradation of cellulose acetate plastic by Novel degrading bacterium Bacillus sp. S2055

Cellulose acetate (CA)-degrading bacteria were isolated from samples obtained from environments at a population size of 6.7 x 10(1) to 1.0 x 10(8) halo-forming cfu/ml-water or g-solid, suggesting their ubiquitous presence. The classification of 35 isolated strains of CA-degrading bacteria into 15 genera indicates that CA-degrading activity is over a wide range of taxonomical groups. From these isolates, Bacillus sp. S2055 was found to be the most efficient CA-degrading bacterium, and its CA-degrading enzyme(s) was partially characterized. The weight loss of CA plastic film (degree of substitution (DS)=1.7) in the culture of S2055 was less than 12% after a 35-d culture while that in the crude enzyme solution extracted from the culture supernatant reached 62% after the same period. Lipase and cellulase activities were detected in the culture supernatant of strain S2055. The crude enzyme solution contained three major protein fractions that have different mean molecular weights (MWs). Fraction I with the highest MW exhibited both lipase and cellulase activities, while fraction II and III exhibited only lipase activity. Fraction I significantly deacetylated CA (DS 1.5) and fragmented CA plastic film into pieces while the other fractions failed to do so even when used in combination with commercially-available cellulases and lipases. The lipase activity of fraction I against various substrates differed considerably from those of known lipases. It was thus suggested that deacetylation of CA mediated by an enzyme with such a peculiar lipase-like activity is a requisite for the efficient biodegradation of CA plastics.