Separation of Chlorophenols by Capillary Zone Electrophoresis. The Influence of pH of the Electrophoretic Buffer on Selectivity

Combination of cationic surfactant-assisted solid-phase extraction with field-amplified sample stacking for highly sensitive analysis of chlorinated acid herbicides by capillary zone electrophoresis

This report describes a novel online field-amplified sample stacking (FASS) procedure to analyze 16 chlorinated acid herbicides. By using a poly(vinyl alcohol) (PVA)-coated capillary to reduce electroosmotic flow and introducing a methanol-water plug before sample loading, the sample injection time could be very long without loss of sample and separation efficiency. Under the optimized condition, the FASS procedure could provide great sensitivity enhancement (5000-10 000-fold) and satisfactory reproducibility (relative standard deviations of migration times less than 2.4%, relative standard deviations of peak areas less than 8.0%). Combined with cationic surfactant-assisted solid-phase extraction (CSA-SPE), the limit of detection of the herbicides ranged from 0.269 to 20.3 ppt, which are two orders lower than those of the US Environmental Protection Agency standard method 515.1. The CSA-SPE-FASS-CE method was successfully applied to the analysis of local pond water.

Determination of caffeine and its metabolites in urine by capillary electrophoresis-mass spectrometry

The caffeine content of foods and beverages varies considerably, interfering with our ability to obtain valid interpretations in many human studies with regard to the mechanism of action(s) of caffeine and/or its metabolites. The rate of metabolism of caffeine and other xanthine drugs also varies greatly from one individual to another. Therefore, it is extremely important to develop accurate, reliable analytical methods to quantify caffeine and its metabolites in simple and complex matrixes. A simple method is described for the separation and characterization of caffeine and its major metabolites employing capillary electrophoresis (CE) coupled to ultraviolet-absorption and mass spectrometry (MS) detection. After optimization of the electrophoresis separation conditions, a reliable separation of caffeine and 11 of its major metabolites was achieved in 50 mM ammonium carbonate buffer, pH 11.0. The volatile aqueous electrolyte system used with a normal electroosmotic flow polarity also provided an optimal separation condition for the characterization of the analytes by MS. The CE method achieved baseline resolution for all 12 compounds in less than 30 min. The CE-MS method is suitable for use as a routine procedure for the rapid separation and characterization of caffeine and its metabolites. The usefulness of this method was demonstrated by the extraction, separation, and identification of caffeine and its 11 metabolites from normal urine samples. The urine specimens were first acidified to obtain optimum binding efficiency to the sorbents of the off-line, solid-phase extraction procedure employed here, and an acidified eluent solvent was employed for the desorption step to maximize the recovery of the bound analytes.

Electro-oxidation and amperometric detection of chlorinated phenols at boron-doped diamond electrodes: a comparison of microcrystalline and nanocrystalline thin films

We report on the electro-oxidation and amperometric detection of phenol and chlorinated phenols, the latter coupled with flow injection analysis (FIA) and high performance liquid chromatography (HPLC), using boron-doped microcrystalline and nanocrystalline diamond thin-film electrodes. The low background current, good response without extensive pretreatment, and low susceptibility to fouling are properties that make diamond an attractive new electrode for monitoring this class of pollutants. Cyclic voltammetric studies were performed to evaluate the redox response of phenol, 2-chlorophenol, 3-chlorophenol,4-chlorophenol, and pentachlorophenol (PCP) in phosphate buffer, pH 3.5, as a function of the potential scan rate and cycle number. The diamond electrode performance for the amperometric detection of these contaminants in FIA-EC and HPLC-EC was evaluated in terms of the linear dynamic range, limit of quantitation, sensitivity, response precision, and response stability. Both diamond types yielded low mass limits of quantitation of 100-1000 pg for all the phenolic compounds in FIA-EC, except PCP which was 3 ng, and 100-600 pg for all the compounds in HPLC-EC. In all cases, the S/N was 3 or greater. Both electrode types also exhibited good sensitivity, excellent response reproducibility (av 2.7% for FIA-EC and av 4.2% for HPLC-EC), and superb response stability for all the analytes. The electrodes could be used from days to weeks in the measurement with only a periodic soak in distilled 2-propanol required to maintain optimum performance. Both types of diamond outperformed glassy carbon, which exhibited short-lived responsiveness as a consequence of fouling by reaction products and potential-dependent changes in the electrode's physiochemical properties. The use of the HPLC-EC assay for the determination of 2-chlorophenol in a contaminated soil sample is also demonstrated.

Large-volume stacking with polarity switching and sweeping for chlorophenols and chlorophenoxy acids in capillary electrophoresis

This paper describes approaches for stacking large volumes of sample solutions containing a mixture of chlorophenols and chlorophenoxyacetic acids as their anions in capillary zone electrophoresis, and compares results to standard capillary electrophoresis (CE) and normal stacking modes. In order to increase the amount of sample injected beyond the optimal conditions and maintain high resolution, the sample introduction buffer must be removed after the stacking process is completed. This is achieved by pumping the sample buffer out of the column using polarity switching. Large sample volumes are loaded by hydrodynamic injection, then stacked at the injection buffer/run electrolyte interface, followed by the removal of the large plug of low-conductivity sample matrix from the capillary column using polarity switching and finally the separation of the stacked anions in a basic buffer (pH 8.65). Around 10- and 40-fold improvement of sensitivity was achieved by normal stacking and large-volume stacking with polarity switching, respectively, when compared to the standard CE analysis. Sweeping-micellar electrokinetic capillary chromatography (MEKC) was also investigated for the purpose of comparison to the stacking technique. The method should be suitable for the analysis of these chemical compound classes in industrial chlorophenoxyacetic acid manufacture.

Application of water-soluble polymers as modifiers in electrophoretic analysis of phenols

A review of application of water-soluble cationic, anionic and nonionic polymers as pseudostationary phases in capillary electrophoresis (CE) and micellar electrokinetic capillary chromatography (MEKC) is presented. The effect of the structure of the polymers on the selectivity and efficiency of separation is discussed. A novel specially designed cationic polymer, 2,10-ionene, has been used for the separation of phenols. The polymer has hydrophilic and hydrophobic parts in its backbone. The polymer shows the best selectivity as a modifier in capillary zone electrophoresis (CZE)-mode, which allows the selective determination of both hydrophilic and hydrophobic phenols.

Separation of chlorophenoxyacetic acids and chlorophenols by using capillary zone electrophoresis

In this study, the choice of electrolyte systems for the separation and detection of a range of chlorophenoxyacetic acids and chlorophenols by means of capillary zone electrophoresis (CZE) is discussed. A series of acetate buffers over the buffering capacity pH range 4.03-5.5 were initially chosen for the separation. It was found that chlorophenoxyacetic acids could be separated at pH 4.03 and 4.5 but the most satisfactory separation of chlorophenols was obtained at pH 5.5. The factors affecting separation selectivity, including the addition of organic modifiers, was also studied. The use of 25% 2-butanol, 5% ethylene glycol and 10% acetonitrile as organic solvents resulted in the total separation of both classes of these compounds but poor peak shape of chlorophenols resulted and a number of chlorophenoxyacetic acids were not well separated. A borate-phosphate buffer gave improved peak shape of chlorophenols. Further improved separation of the components of the mixture was obtained by the addition of 2 mM fully methylated-beta-cyclodextrin to the 35 mM borate- 60 mM phosphate buffer at pH 6.5, maintaining good peak shape. In this case, separation of the two compound classes, chlorophenoxyacetic acids and chlorophenols, is achieved, with complete resolution of individual compounds in less than 5 min with high efficiency (of the order of 150,000 plates for the ca. 40 cm column). The method is applied to a commercial 2,4-dichlorophenoxyacetic acid (2,4-D) herbicide mixture.

Capillary electrophoresis-electrospray ion-trap mass spectrometry for the separation of chlorophenols

Eighteen positional isomers of chlorophenols were separated by capillary electrophoresis (CE) and detected on-line by electrospray ionization ion-trap mass spectrometry (MS). Conditions for the coupling of CE to MS, e.g., the concentration of carrier electrolyte, the sheath liquid composition and the sheath gas flow-rate were optimized. Diethylmalonic acid (5 mM) at pH 7.25 and isopropanol-250 mM dimethylamine (80:20) as sheath liquid were used. The activation parameters for ion-trap mass spectrometric analysis of chlorophenols were optimized. The mass spectra, obtained for all the analytes, revealed that the [M-H]- ion was the base peak for all chlorophenols. Moreover, conditions for CE-MS-MS detection were established and [M-H-HCl]- ions were detected.

Highly selective and efficient determination of US Environmental Protection Agency priority phenols employing solid-phase extraction and non-aqueous capillary electrophoresis

Non-aqueous capillary electrophoresis has been used in the separation of a complete list of 26 priority phenols included in the 8041 US Environmental Protection Agency method and the 76/464/EEC European Union directive. A highly selective and efficient separation was obtained when the background electrolyte used was 150 mM ammonium acetate dissolved in N-methylformamide-acetonitrile (75:25). Solid-phase extraction was successfully assayed as an enrichment strategy for the analysis of low-concentration samples. A styrene-divinylbenzene functionalized cartridge provided excellent recoveries of phenols from water samples at neutral pH. The limits of quantification obtained permit the application of the proposed method to the determination of priority phenols in wastewater samples.

Capillary electrophoresis and capillary electrochromatography of organic pollutants

Capillary electrophoresis (CE) has a unique capability for separation of analytes of environmental concern, particularly those that are more polar and ionic, based on the complementary separation principle of electrophoresis. In the past few years, CE has been selectively used to analyze various classes of compounds having current or potential environmental relevance. This review outlines the current status of CE for the determination of environmental pollutants, based predominantly on research results published from the beginning of 1997 to early 1999. Covered are environmental pollutants of all types except pesticides and inorganics. Certain naturally produced toxins are also covered because of their significant impacts upon human health and the environment. CE methods, as with all methods, must be judged on their ability to provide approaches that are reliable, sensitive, selective, and rapid, while meeting "green chemistry" initiatives for pollution prevention. We also compare CE methods to benchmark environmental techniques involving gas chromatography-mass spectrometry (GC-MS), liquid chromatography-mass spectrometry (LC-MS), and high performance liquid chromatography (HPLC).