Chitosan Membrane: Tool for Chromium (III) Recovery from Aqueous Solutions

Chromium(III) Removal from Wastewater by Chitosan Flakes

Chitosan is very effective in removing metal ions through their adsorption. A preliminary investigation of the adsorption of chromium(III) by chitosan was carried out by means of batch tests as a function of contact time, pH, ion competition, and initial chromium(III) concentration. The rate of adsorption was rather rapid (t1/2 < 18 min) and influenced by the presence of other metal ions. The obtained data were tested using the Langmuir and Freundlich isotherm models and, based on R2 values, the former appeared better applicable than the latter. Chitosan was found to have an excellent loading capacity for chromium(III), namely 138.0 mg Cr per g of chitosan at pH = 3.8, but metal ions adsorption was strongly influenced by the pH. About 76% of the recovered chromium was then removed simply by washing the used chitosan with 0.1 M EDTA (Ethylenediaminetetraacetic acid) solution. This study demonstrates that chitosan has the potential to become an effective and low-cost agent for wastewater treatment (e.g., tannery waste) and in situ environmental remediation.

Synthesis and mechanical properties of quaternary salts of chitosan-based films for food application

A novel method is described to synthesize quaternary salts of chitosan with dimethylsulfate and subsequently cast films. In an attempt to improve both mechanical and hydrophobic characteristics, the chitosan was previously modified by N-alkylation, introducing 4, 8 and 12 carbons moieties into the polymeric chain. Analysis by FTIR and solid-state CP-MAS (13)C NMR spectroscopy confirmed the success of both alkylation and quaternization processes. The average degree of quaternization of these N-methylated derivatives was calculated to be 35%. DMA measurements indicated that chitosan and its derivative films are typically brittle materials, exhibiting similar non-linear viscoelastic behaviors. The films of unmodified chitosan have a very small strain (approximately 2.8%), though they were the most resistant films (Young's modulus=2283 MPa; tensile strength >44.0 MPa). In general, the alkyl-chitosan derivatives appear to be more plastic than chitosan films but less resistant, e.g., for butyl chitosan: maximum strain=13.1%; tensile strength=13.4 MPa and Young's modulus=171 MPa. Conversely the quaternization reaction increased the hardness of the parent sample, viz. for quaternary salt of dodecyl chitosan: maximum strain=2.6%; tensile strength=38.3 MPa and Young's modulus=1792 MPa.

A templating route to nanoporous chitosan materials

Nanoporous chitosan materials in both membrane and bulk form with pore diameter ranges of 10-50 nm were prepared by a novel emulsion-mediated templating method. Considering the biocompatibility and versatility of chitosan, the nanoporous chitosan material is expected to have a wide variety of applications in the biotechnological and biomaterials areas.