Pressure-Induced Intersite BiM (M=Ru, Ir) Valence Transitions in Hexagonal Perovskites

Harvesting High-Quality White-Light Emitting and Remarkable Emission Enhancement in One-Dimensional Halide Perovskites Upon Compression

The pressure induced emission (PIE) behavior of halide perovskites has attracted extensive interest due to its potential application in pressure sensors and trademark security. However, the PIE phenomenon of white-light-emitting hybrid perovskites (WHPs) is rare, and that at pressures above 10.0 GPa has never been reported. Here, we effectively adjusted the perovskite to emit high-quality "cold" or "warm" white light and successfully realized pressure-induced emission (PIE) upon even higher pressure up to 35.1 GPa in one-dimensional halide perovskite C₄N₂H₁₄PbCl₄. We reveal that the degree of structural distortion and the rearrangement of the multiple self-trapped states position are consistent with the intriguing photoluminescence variation, which is further supported by in situ high-pressure synchrotron X-ray diffraction experiments and time-resolved photoluminescence decay dynamics data. The underlying relationship between octahedron behavior and emission plays a key role to obtain high-quality white emission perovskites. We anticipate that this work enhances our understanding of structure-dependent self-trapped exciton (STE) emission characteristics and stimulates the design of high-performance WHPs for next generation white LED lighting devices.

Squeezing electrons out of 6s2 lone-pairs in perovskite-type oxides

Having identified a set of conditions that predispose a solid-state ionic compound to a pressure-induced valence transition, we investigated a series of Bi(iii) perovskite oxides. We found such a transition below 10 GPa in every case, including one that we synthesised for the first time (double perovskite-type Ba2BiOsO6).

Transformation of Perovskite BaBiO3 into Layered BaBiO2.5 Crystals Featuring Unusual Chemical Bonding and Luminescence

Engineering oxygen coordination environments of cations in oxides has received intense interest thanks to the opportunities for the discovery of novel oxides with unusual properties. Herein, the synthesis of stoichiometric layered BaBiO_2.5 by a nontopotactic phase transformation of perovskite BaBiO₃ is presented. By analyzing the synchrotron X-ray diffraction data by the maximum-entropy method/Rietveld technique, it was found that Bi is involved in an unusual chemical bonding situation with four oxygen atoms featuring one ionic bond and three covalent bonds, which results in an asymmetric coordination geometry. Photophysical characterization revealed that this peculiar structure shows near-infrared luminescence differing from that of conventional Bi-containing compounds. Experimental and theoretical results led to the proposal of an excitonic nature of the luminescence. This work highlights that synthesizing materials with uncommon Bi-O bonding and Bi coordination geometry provides a pathway to the discovery of systems with new functionalities. This could inspire interest in the exploration of a range of materials containing heavier p-block elements with prospects for finding systems with unusual properties.

Manipulation of successive crystalline transformations to control electron transfer and switchable functions

Electron transfer in solid is crucial to switchable magnetic, electrical, optical and mechanical properties. However, it is a formidable challenge to control electron-transfer behaviors via manipulation of crystalline phases, especially through dynamic crystalline transformation. Herein, three crystalline phases of an {Fe2Co2} compound were obtained via enhancement of intermolecular π···π interactions inducing successive single-crystal-to-single-crystal transformations, from solvated 1·2CH3OH·4H2O, to desolvated 1 and its polymorph 1a accompanying electron transfer. 1·2CH3OH·4H2O showed thermally induced reversible intermetallic electron transfer in mother liquor. No electron-transfer behavior was observed in 1. 1a showed reversible intermetallic electron transfer upon thermal treatment or alternative irradiation with 808- and 532-nm lasers at cryogenic temperatures. The electron-transfer behaviors significantly change the magnetic and optical properties, providing a strategy to realize different electron-transfer behaviors and switchable functions via π···π interactions manipulated dynamic crystalline transformation.

Systematic charge distribution changes in Bi- and Pb-3d transition metal perovskites

Charge distribution changes in Bi- and Pb-3d transition metal perovskite type oxides were examined. The change in the depth of the d level of the transition metal causes the intermetallic charge transfer.

Structural and Magnetic Transitions in CaCo3V4O12 Perovskite at Extreme Conditions

We investigated the structural, vibrational, magnetic, and electronic properties of the recently synthesized CaCo₃V₄O₁₂ double perovskite with the high-spin (HS) Co²⁺ ions in a square-planar oxygen coordination at extreme conditions of high pressures and low temperatures. The single-crystal X-ray diffraction and Raman spectroscopy studies up to 60 GPa showed a conservation of its cubic crystal structure but indicated a crossover near 30 GPa. Above 30 GPa, we observed both an abnormally high "compressibility" of the Co-O bonds in the square-planar oxygen coordination and a huge anisotropic displacement of HS-Co²⁺ ions in the direction perpendicular to the oxygen planes. Although this effect is reminiscent of a continuous HS → LS transformation of the Co²⁺ ions, it did not result in the anticipated shrinkage of the cell volume because of a certain "stiffing" of the bonds of the Ca and V cations. We verified that the oxidation states of all the cations did not change across this crossover, and hence, no charge-transfer effects were involved. Consequently, we proposed that CaCo₃V₄O₁₂ could undergo a phase transition at which the large HS-Co²⁺ ions were pushed out of the oxygen planes because of lattice compression. The antiferromagnetic transition in CaCo₃V₄O₁₂ at 100 K was investigated by neutron powder diffraction at ambient pressure. We established that the magnetic moments of the Co²⁺ ions were aligned along one of the cubic axes, and the magnetic structure had a 2-fold periodicity along this axis, compared to the crystallographic one.

Pressure-induced conductivity and yellow-to-black piezochromism in a layered Cu-Cl hybrid perovskite

Pressure-induced changes in the electronic structure of two-dimensional Cu-based materials have been a subject of intense study. In particular, the possibility of suppressing the Jahn-Teller distortion of d(9) Cu centers with applied pressure has been debated over a number of decades. We studied the structural and electronic changes resulting from the application of pressures up to ca. 60 GPa on a two-dimensional copper(II)-chloride perovskite using diamond anvil cells (DACs), through a combination of in situ powder X-ray diffraction, electronic absorption and vibrational spectroscopy, dc resistivity measurements, and optical observations. Our measurements show that compression of this charge-transfer insulator initially yields a first-order structural phase transition at ca. 4 GPa similar to previous reports on other Cu(II)-Cl perovskites, during which the originally translucent yellow solid turns red. Further compression induces a previously unreported phase transition at ca. 8 GPa and dramatic piezochromism from translucent red-orange to opaque black. Two-probe dc resistivity measurements conducted within the DAC show the first instance of appreciable conductivity in Cu(II)-Cl perovskites. The conductivity increases by 5 orders of magnitude between 7 and 50 GPa, with a maximum measured conductivity of 2.9 × 10(-4) S·cm(-1) at 51.4 GPa. Electronic absorption spectroscopy and variable-temperature conductivity measurements indicate that the perovskite behaves as a 1.0 eV band-gap semiconductor at 39.7 GPa and has an activation energy for electronic conduction of 0.232(1) eV at 40.2 GPa. Remarkably, all these changes are reversible: the material reverts to a translucent yellow solid upon decompression, and ambient pressure powder X-ray diffraction data taken before and after compression up to 60 GPa show that the original structure is maintained with minimal hysteresis.

Nitrogen content and morphology dependent field emission properties of nitrogen-doped SiC nanowires and density functional calculations

N-Doped SiC NWs with varying N content have been synthesized via a one-step CVR, and they exhibit excellent FE properties.

Tuning the giant magnetoelastic transition in Ba3BiIr2O9 and Ba3BiRu2O9

We have experimentally investigated the effects of pressure on the magnetoelastic transitions associated with the opening of spin-gaps in Ba3BiIr2O9 and Ba3BiRu2O9. For both compounds, reducing the unit cell volume by either external physical and internal chemical pressure was found to reduce the temperature T(*) of the transition and, to a lesser extent, the magnitude of the associated negative thermal volume expansion. The results yield the latent heat associated with the transitions, -3.34(3) × 10(2) J mol(-1) for Ba3BiIr2O9 and -7.1(5) × 10(2) J mol(-1) for Ba3BiRu2O9. The transition in Ba3BiRu2O9 is significantly more robust than in Ba3BiIr2O9, requiring an order of magnitude higher pressures to achieve the same reduction in T(*). The differing responses of the two compounds points to differences between the 4d and 5d metals and hence to the importance of spin-orbit coupling, which is expected to be much stronger in the Ir compound.