1,1'-Bis-(diphenylphosphino)ferrocene appended d8- and d10-configuration based thiosquarates: the molecular and electronic configurational insights into their sensitization and co-sensitization properties for dye sensitized solar cells

Three new d8- and d10-configuration based 1,1'-bis-(diphenylphosphino)ferrocene (dppf) appended thiosquarates complexes with general composition [M(mtsq)2dppf] (M = Ni2+ (NiL2); Zn2+ (ZnL2) and Cd2+ (CdL2)) (mtsq = 3-ethoxycyclobutenedione-4-thiolate) have been synthesized and characterized spectroscopically as well as in case of NiL2 by single crystal X-ray diffraction technique. The single crystal X-ray analysis reveals square planar geometry around Ni(II) in NiL2, where Ni(II) coordinates with two sulfur centres of two mtsq ligands in monodentate fashion and two phosphorus of a dppf ligand in chelating mode. The supramolecular architecture of NiL2 is sustained by intermolecular C-H⋯O interactions to form one-dimensional chain. Further, the application of these newly synthesized complexes as sensitizers and co-sensitizers/co-absorbents with ruthenium based N719 sensitizer in dye-sensitized solar cells (DSSCs) have been explored. The DSSC set-up based on NiL2 offers best photovoltaic performance with photovoltaic efficiency (η) 5.12%, short-circuit current (Jsc) 11.60 mA cm-2, open circuit potential (Voc) 0.690 V and incident photon to current conversion efficiency (IPCE) 63%. In co-sensitized DSSC set-up, ZnL2 along with state-of-the-art N719 dye displays best photovoltaic performance with η 6.65%, Jsc 14.47 mA cm-2, Voc 0.729 V and IPCE 69%, thereby showing an improvement by 15.25% in photovoltaic efficiency in comparison to the photovoltaic efficiency of N719 sensitized DSSC set-up. Variation in co-sensitization behaviour have been ascribed to the differences in the excited state energy level of co-sensitizers. The ZnL2 and CdL2 have a higher energy level position than N719 dye, allowing efficient electron transfer to N719 during light irradiation, while excited state of NiL2 is lower than N719 dye, preventing photoexcited electron transfer to N719, resulting in its lowest overall efficiency among the three co-sensitized DSSC setups.

A Fascinating Trip into Iron and Copper Dyes for DSSCs

The production of electricity in a greener and more sustainable way by employing renewable sources is a great challenge in modern times. Photovoltaic systems represent an important possibility because sunlight is the most abundant renewable source. In this review article, recent studies (from 2018 to the present) involving novel iron and copper complexes employed as dyes in Dye-Sensitized Solar Cells (DSSCs) are reported; mono- and bimetallic Fe complexes, Cu-based dyes, and devices presenting both metals are discussed, together with the performances of the DSSCs reported in the papers and the corresponding values of the main parameters employed to characterize such solar cells. The feasibility of DSSCs employing copper and iron dyes, alone or in combination with other earth-abundant metals, is demonstrated. The proper optimization of the sensitizers, together with that of the electrolyte and of the semiconducting layer, will likely lead to the development of highly performing and cheap photovoltaic devices for future applications on a much larger scale.