Dielectric properties of potassium carbonate-impregnated cempedak peel for microwave-assisted activation

Dielectric Properties of Materials Used for Microwave-Based NOx Gas Dosimeters

Nitrogen oxides (NOx), primarily generated from combustion processes, pose significant health and environmental risks. To improve the coordination of measures against excessive NOx emissions, it is necessary to effectively monitor ambient NOx concentrations, which requires the development of precise and cost-efficient detection methods. This study focuses on developing a microwave- or radio frequency (RF)-based gas dosimeter for NOx detection and addresses the optimization of the dosimeter design by examining the dielectric properties of LTCC-based (Low-Temperature Co-fired Ceramics) sensor substrates and barium-based NOx storage materials. The measurements taken utilizing the Microwave Cavity Perturbation (MCP) method revealed that these materials exhibit more pronounced changes in dielectric losses when storing NOx at elevated temperatures. Consequently, operating such a dosimeter at high temperatures (above 300 °C) is recommended to maximize the sensor signal. To evaluate their high-temperature applicability, LTCC substrates were analyzed by measuring their dielectric losses at temperatures up to 600 °C. In terms of NOx storage materials, coating barium on high-surface-area alumina resolved issues related to limited NOx adsorption in pure barium carbonate powders. Additionally, the adsorption of both NO and NO2 was enabled by the application of a platinum catalyst. The change in dielectric losses, which provides the main signal for an RF-based gas dosimeter, only depends on the stored amount of NOx and not on the specific type of nitrogen oxide. Although the change in dielectric losses increases with the temperature, the maximum storage capacity of the material decreases significantly. In addition, at temperatures above 350 °C, NOx is mostly weakly bound, so it will desorb in the absence of NOx. Therefore, in the future development of a reliable RF-based NOx dosimeter, the trade-off between the sensor signal strength and adsorption behavior must be addressed.

Recent progress in biomass-derived carbonaceous composites for enhanced microwave absorption

Carbonaceous microwave absorbing materials are in vital demand due to the extensive electromagnetic pollution in 5G network era and urgent requirements for stealth technology in national defense domain. Rather than the complicated vapor deposition method, a simple biomass-derived approach sheds light on the mass production of carbon materials for its ubiquitous, environmental-friendly, cost-off, and sustainable advantages. Herein, a concise review of recent advances in designing carbonaceous materials for EM attention is provided with particular stress on the biomass categories and the synthetic method. The three dimensional (3D) interconnected network of carbon materials are highlighted in analysis regarding the biomass selection, functional process, pore-forming strategy and the microwave absorption performance of the corresponding composites. Nature fiber-derived carbon materials, possessing high-aspect ratio fiber structure, are also discussed due to their potential in weaving manufacture and diverse application for flexible cloaking fabric. In the end, the current challenge and the directional perspective for utilizing biomass-derived carbon absorbing materials with effective EM properties are outlined.