Melt shear viscosity of PP/Al(OH)3/Mg(OH)2 flame retardant composites at high extrusion rates

Design and Synthesis of Polysiloxane Based Side Chain Liquid Crystal Polymer for Improving the Processability and Toughness of Magnesium Hydrate/Linear Low-Density Polyethylene Composites

In this study, a polysiloxane grafted by thermotropic liquid crystal polymer (PSCTLCP) is designed and synthesized to effectively improve the processability and toughness of magnesium hydroxide (MH)/linear low-density polyethylene (LLDPE) composites. The obtained PSCTLCP is a nematic liquid crystal polymer; the liquid crystal phase exists in a temperature range of 170 to 275 °C, and its initial thermal decomposition temperature is as high as 279.6 °C, which matches the processing temperature of MH/LLDPE composites. With the increase of PSCTLCP loading, the balance melt torque of MH/LLDPE/PSCTLCP composites is gradually decreased by 42% at 5 wt % PSCTLCP loading. Moreover, the power law index of MH/LLDPE/PSCTLCP composite melt is smaller than 1, but gradually increased with PSCTLCP, the flowing activation energy of PSCTLCP-1.0 is lower than that of MH/LLDPE at the same shear rate, indicating that the sensitivity of apparent melt viscosity of the composites to shear rate and to temperature is decreased with the increase of PSCTLCP, and the processing window is broadened by the addition of PSCTLCP. Besides, the elongation at break of MH/LLDPE/PSCTLCP composites increases from 6.85% of the baseline MH/LLDPE to 17.66% at 3 wt % PSCTLCP loading. All the results indicate that PSCTLCP can significantly improve the processability and toughness of MH/LLDPE composites.

Characterization of Cell Damage and Proliferative Ability during and after Bioprinting

When a biomaterial solution containing living cells is subject to bioprinting, the cells experience process-induced stresses, including shear and extensional stresses. These process-induced stresses breach cell membranes and can lead to cell damage, thus reducing cell viability and functioning within the printed constructs. Studies have been conducted to determine the influence of shear stress on cell damage; however, the effect of extensional stress has been typically ignored in the literature until the recently collected evidence of its importance. This paper presents a novel method to characterize and quantify the cell damage caused by both shear and extensional stresses in bioprinting. In this method, cell damage law is first established to relate cell damage to shear stress based on the experiments with a rheometer; the process-induced shear stress experienced by cells in bioprinting is represented, and the established cell damage model is applied to calculate the degree of cell damage caused by shear stress in bioprinting; then cell damage caused by extensional stress is inferred from the difference between the total cell damage and the amount of cell damage attributed to shear stress. With the obtained magnitude of extensional stress from fluidic simulation, the model that relates extensional stress to cell damage is established; the bioprinting process-induced cell damage attributed to both shear and extensional stresses is therefore presented. Schwann cells and myoblasts were used as examples to validate the models. Comparison between experimental and simulation results shows the effectiveness of the models presented in this paper. Moreover, the viability and proliferative ability of cells in the first 72 h after bioprinting is investigated, with the results illustrating that the process-induced forces affect not only cell viability but also their proliferative ability after bioprinting.