Stable isotope dilution method for the determination of serum glucose using discharge-assisted thermospray liquid chromatography/mass spectrometry

An LC-MS/MS- and hURAT1 cell-based approach for screening of uricosuric agents

Urate anion exchanger 1 (URAT1) expressed in the proximal renal tubules is responsible for about 90% of the reabsorption of uric acid. URAT1 is identified as an important target of uricosuric drugs. Here we present an LC-MS/MS-based approach, combined with URAT1-transgenic MDCK cells, for the assessment of uric acid. Cell lysis was executed with 50 mM NaOH to release uric acid. 1,3-¹⁵N₂ uric acid was employed as the internal standard. The harvested uric acid, along with the stable isotope-labeled uric acid, was analyzed by LC-MS/MS in multiple reactions monitoring and negative modes. Validation, i.e. determination of selectivity, precision, accuracy, extraction recovery, and matrix effect, and feasibility was evaluated by use of the approach developed. The linearity was observed in the range of 1.0-250 μM (r = 0.9960) with limit of detection of 50 nM and limit of quantitation of 200 nM. The precision and accuracy were found to be RSD ≤ 20% and 80-120% of the nominal value, respectively. Uric acid uptake showed concentration and time dependency in URAT1-transgenic cells. The observed inhibitory effects of three URAT1-targeted uricosuric drugs were consistent with those reported in literature. The stable isotope dilution-based approach was proven to be selective, sensitive, and convenient, which is a good in vitro model for URAT1-targeted drug candidate screening.

Detection of hydroxyethylstarch (HES) in human urine by liquid chromatography–mass spectrometry

The objective of this study was to establish the possibility of using liquid chromatography coupled to mass spectrometry for the detection of hydroxyethylstarch (a corn starch derived product) in urine as an alternative to the current time consuming GC-MS methods. Analyses were performed using an ion trap instrument after acidic hydrolysis. Ionization was carried out using atmospheric pressure chemical ionisation (APCI) operated in negative ionization mode and detection was performed using MS(2). The results indicate that the developed method can successfully be applied as a fast and reliable method for the detection and identification of hydroxyethylstarch.

Sensitive LC MS quantitative analysis of carbohydrates by Cs+ attachment

The development of a sensitive assay for the quantitative analysis of carbohydrates from human plasma using LC/MS/MS is described in this paper. After sample preparation, carbohydrates were cationized by Cs(+) after their separation by normal phase liquid chromatography on an amino based column. Cesium is capable of forming a quasi-molecular ion [M + Cs](+) with neutral carbohydrate molecules in the positive ion mode of electrospray ionization mass spectrometry. The mass spectrometer was operated in multiple reaction monitoring mode, and transitions [M + 133] --> 133 were monitored (M, carbohydrate molecular weight). The new method is robust, highly sensitive, rapid, and does not require postcolumn addition or derivatization. It is useful in clinical research for measurement of carbohydrate molecules by isotope dilution assay.

A liquid chromatography-mass spectrometry method to measure stable isotopic tracer enrichments of glycerol and glucose in human serum

Stable isotopes are commonly used as tracers for the measurement of glycerol and glucose kinetics in metabolic studies. Traditionally, the analysis of these isotopes has been performed using gas chromatography-mass spectrometry, which requires that the analytes first be derivatized. The derivatization process adds considerable complexity to the method. Liquid chromatography-mass spectrometry (LCMS) can measure many metabolites directly with limited sample preparation. We present a novel analytical method for the measurement of [1,1,2,3,3-(2)H(5)]glycerol (d(5)-glycerol) and [6,6-(2)H(2)]glucose (d(2)-glucose) isotopic tracer enrichments in human serum in a single run by LCMS. After a simple extraction step, the sample is separated isocratically by HPLC, and the isotopes are measured using positive electrospray ionization with selected ion monitoring of the sodium-adduct ions. The method is linear over a wide range of d(2)-glucose and d(5)-glycerol enrichments. The within-day standard deviation of measurement of serum samples was 0.05 mole% excess (MPE) for d(2)-glucose and 0.25 MPE for d(5)-glycerol. The variation of tracer enrichment among days was about double that measured within 1 day.

Determination of serum creatinine by isotope dilution method using discharge-assisted thermospray liquid chromatography/mass spectrometry

A discharge-assisted thermospray (plasmaspray) liquid chromatography/mass spectrometric method for the determination of serum creatinine is described. The method incorporates stable isotope dilution using (D3)creatinine as an internal standard. Separation is performed in reversed-phase high-performance liquid chromatography using 0.01 M aqueous ammonium acetate as a flow solvent. Effluents are directly introduced to the mass spectrometer and [MH]+ ions are monitored during LC/MS using the selected ion monitoring method. Satisfactory agreement between the analytical result and the certified value of the serum sample of standard reference material and relative standard deviation ranging from 0.6% to 1.2% was obtained.

Determination of serum cholesterol by stable isotope dilution method using discharge-assisted thermospray liquid chromatography/mass spectrometry

A discharge-assisted thermospray (plasmaspray) liquid chromatography/mass spectrometric method for the determination of total serum cholesterol is described. The method incorporates stable isotope dilution using (3,4-13C)cholesterol as an internal standard. Liquid chromatographic separation is performed using methanol as a flow solvent and effluents are directly introduced to the mass spectrometer. [MH-H2O]+ ions are monitored during liquid chromatography/mass spectrometry using the selected ion monitoring method. Satisfactory agreement between the analytical result and the certified value of the National Institute of Standards and Technology (formerly National Bureau of Standards) standard reference material serum is obtained with a relative standard deviation of 0.6%.