Utilization of waste tire derived activated carbon as CO2 capture and photocatalyst for CO2 conversion

The aims of this research were to prepare activated carbon (AC) impregnated with tetraethylenepentamine (TEPA) for use in carbon dioxide (CO2) capture and to then develop the AC-TEPA sorbent with titanium dioxide (TiO2) as a catalyst for photocatalytic reduction. The AC was impregnated with TEPA at three loading levels (2.5, 5, and 10% [w/w]) and then examined for its CO2 adsorption capacity under an ambient temperature and atmospheric pressure. The use of 5% (w/w) TEPA-impregnated AC (AC_5T) provided the highest CO2 adsorption capacity and long-term operation with a regeneration ability for up to 10 cycles. Then, AC_5T-doped TiO2 (AC_5T-TiO2) was prepared as a photocatalytic reduction catalyst, since the presence of carbon and nitrogen in AC_5T could reduce the band gap energy and so enhance the photocatalytic reduction. In addition, the CO2-saturated AC_5T was used as a CO2 source that could be directly converted to valuable chemicals using the AC_5T-TiO2 catalyst under photocatalytic reduction. Products were obtained in both the liquid (methanol) and gaseous (methane, carbon monoxide, and hydrogen) phases. Accordingly, the challenge of this research was to make valuable products from CO2 and to manage waste tires, following the circular economy concept.

Green preparation of CaO-based CO2 adsorbent by calcium-induced hydrogenation of shell wastes at room/moderate temperature

Capturing CO2 using clamshell/eggshell-derived CaO adsorbent can not only reduce carbon emissions but also alleviate the impact of trash on the environment. However, organic acid was usually used, high-temperature calcination was often performed, and CO2 was inevitably released during preparing CaO adsorbents from shell wastes. In this work, CaO-based CO2 adsorbent was greenly prepared by calcium-induced hydrogenation of clamshell and eggshell wastes in one pot at room/moderate temperature. CO2 adsorption experiments were performed in a thermogravimetric analyzer (TGA). The adsorption performance of the adsorbents obtained from the mechanochemical reaction (BM-C/E-CaO) was superior to that of the adsorbents obtained from the thermochemical reaction (Cal-C/E-CaO). The CO2 adsorption capacity of BM-C-CaO at 650 °C is up to 36.82 wt%, but the adsorption decay rate of the sample after 20 carbonation/calcination cycles is only 30.17%. This study offers an alternative energy-saving method for greenly preparing CaO-based adsorbent from shell wastes.