Promoting Effect of Cu on Pd Applied to the Hydrazine Electro-Oxidation and Direct Hydrazine Fuel Cells

Use of liquid fuels in fuel cells is advantageous due to the easier and safer handling, transportation, and storage. Among the different options, hydrazine is of interest since the formation of highly poisoning carbonaceous species is avoided, in addition to its high energy density. In the search for more active direct hydrazine fuel cells (DHFC), this study analyzes the influence of Cu as an auxiliary metal on Pd. Three different PdxCu/C (x = 3, 1, and 0.33) catalysts were prepared by chemical reduction with NaBH4. The materials were physiochemically characterized by X-ray diffraction, energy-dispersive X-ray spectroscopy, transmission electron microscopy, and X-ray photoelectron spectroscopy. Electrochemical analysis in a three-electrode glass cell and a single-cell DHFC was also carried out to study the impact on the electroactivity. Cu exerts a beneficial effect by reducing the adsorption energies of the adsorbed species and donating oxidized species for the completion of the hydrazine electro-oxidation, optimally balanced in the Pd1Cu/C (maximum power density of 180 mW cm−2). As a counterpoint, Cu slightly promotes the non-faradaic decomposition of hydrazine, seen by a larger H2 signal in mass spectroscopy in the anode exhaust at high current densities, which results in a slight loss in faradaic efficiency.

Interface Engineering of SRu-mC3N4 Heterostructures for Enhanced Electrochemical Hydrazine Oxidation Reactions

Hydrazine oxidation in single-atom catalysts (SACs) could exploit the efficiency of metal atom utilization, which is a substitution for noble metal-based electrolysers that results in reduced overall cost. A well-established ruthenium single atom over mesoporous carbon nitride (SRu-mC3N4) catalyst is explored for the electro-oxidation of hydrazine as one of the model reactions for direct fuel cell reactions. The electrochemical activity observed with linear sweep voltammetry (LSV) confirmed that SRu-mC3N4 shows an ultra-low onset potential of 0.88 V vs. RHE, and with a current density of 10 mA/cm2 the observed potential was 1.19 V vs. RHE, compared with mesoporous carbon nitride (mC3N4) (1.77 V vs. RHE). Electrochemical impedance spectroscopy (EIS) and chronoamperometry (i-t) studies on SRu-mC3N4 show a smaller charge-transfer resistance (RCt) of 2950 Ω and long-term potential, as well as current stability of 50 h and 20 mA/cm2, respectively. Herein, an efficient and enhanced activity toward HzOR was demonstrated on SRu-mC3N4 from its synergistic platform over highly porous C3N4, possessing large and independent active sites, and improving the subsequent large-scale reaction.

Palladium-Nickel Electrocatalysts on Nitrogen-Doped Reduced Graphene Oxide Nanosheets for Direct Hydrazine/Hydrogen Peroxide Fuel Cells

In the present work, nitrogen-doped reduced graphene oxide-supported (NrGO) bimetallic Pd–Ni nanoparticles (NPs), fabricated by means of the electrochemical reduction method, are investigated as an anode electrocatalyst in direct hydrazine–hydrogen peroxide fuel cells (DHzHPFCs). The surface and structural characterization of the synthesized catalyst affirm the uniform deposition of NPs on the distorted NrGO. The electrochemical studies indicate that the hydrazine oxidation current density on Pd–Ni/NrGO is 1.81 times higher than that of Pd/NrGO. The onset potential of hydrazine oxidation on the bimetallic catalyst is also slightly more negative, i.e., the catalyst activity and stability are improved by Ni incorporation into the Pd network. Moreover, the Pd–Ni/NrGO catalyst has a large electrochemical surface area, a low activation energy value and a low resistance of charge transfer. Finally, a systematic investigation of DHzHPFC with Pd–Ni/NrGO as an anode and Pt/C as a cathode is performed; the open circuit voltage of 1.80 V and a supreme power density of 216.71 mW cm−2 is obtained for the synthesized catalyst at 60 °C. These results show that the Pd–Ni/NrGO nanocatalyst has great potential to serve as an effective and stable catalyst with low Pd content for application in DHzHPFCs.

Shape-controlled Cu2O nanospheres as bifunctional catalysts boosting the oxidations of glucose and hydrazine

Cuprous oxide (Cu2O) nanoparticles hold promise as low-cost catalysts for the oxidations of both glucose and hydrazine (N2H4). The shape-controlled growth of Cu2O crystals can regulate effectively its catalytic activities.