The Adsorption of Oxygen and Coadsorption of CO and Oxygen on Structurally Well-Defined PdAg Surface Alloys

Stability, electronic properties and CO adsorption properties of bimetallic PtAg/Pt(111) surfaces

Aiming at a better fundamental understanding of the chemistry of bimetallic PtAg/Pt(111) surfaces, we have investigated the stability, electronic properties and CO adsorption properties of bimetallic PtAg surfaces, including pseudomorphic Ag film covered Pt(111) surfaces and PtxAg1-x/Pt(111) monolayer surface alloys, using periodic density functional theory calculations. The data provide detailed insights into the relative stabilities of different surface configurations, as indicated by their formation enthalpies and surface energies, and changes in their electronic properties, i.e., in the projected local densities of states and shifts in the d-band center. The adsorption properties of different Ptn ensembles were systematically tested using CO as a probe molecule. In addition to electronic ligand and strain effects, we were particularly interested in the role of different adsorption sites and of the local COad coverage, given by the number of CO molecules per Pt surface atom in the Ptn ensemble. Different from PdAg surfaces, variations in the adsorption energy with adsorption sites and with increasing local coverage are small up to one COad per Pt surface atom. Finally, formation of multicarbonyl species with more than one COad per Pt surface atom was tested for separated Pt1 monomers and can be excluded at finite temperatures. General trends and aspects are derived by comparison with comparable data for PdAg bimetallic surfaces. Fundamental insights relevant for applications of bimetallic Pt catalysts, specifically PtAg catalysts, are briefly discussed.

PdAg/Ag(111) Surface Alloys: A Highly Efficient Catalyst of Oxygen Reduction Reaction

In this article, the behavior of various Pd ensembles on the PdAg(111) surfaces was systematically investigated for oxygen reduction reaction (ORR) intermediates using density functional theory (DFT) simulation. The Pd monomer on the PdAg(111) surface (with a Pd subsurface layer) has the best predicted performance, with a higher limiting potential (0.82 V) than Pt(111) (0.80 V). It could be explained by the subsurface coordination, which was also proven by the analysis of electronic properties. In this case, it is necessary to consider the influence of the near-surface layers when modeling the single-atom alloy (SAA) catalyst processes. Another important advantage of PdAg SAA is that atomic-dispersed Pd as adsorption sites can significantly improve the resistance to CO poisoning. Furthermore, by adjusting the Pd ensembles on the catalyst surface, an exciting ORR catalyst combination with predicted activity and high tolerance to CO poisoning can be designed.

Regeneration of Active Surface Alloys during Cyclic Oxidation and Reduction: Oxidation of H2 on Pd/Ag(111)

The surface morphology and composition of a catalyst during excursions between oxidizing and reducing conditions can change substantially, especially in bimetallic alloys. Both thermodynamic and kinetic factors play a role in determining the properties of alloy surfaces where the active phase may be a metastable state. Previously, Ag oxide reduction was shown to be dramatically enhanced when Pd is on the surface; however, Pd is more stable when dissolved in Ag, raising the question as to whether a highly active Pd surface state will persist over multiple reaction cycles, a requirement for catalytic function. Experiments herein demonstrate that the enhanced chemical functionality due to the presence of Pd on the surface is retained, based on the enhanced rate of silver oxide reduction over multiple oxidation/reduction cycles for a Pd/Ag(111) model. Repeated oxidation and reduction promote PdAg alloying, and reversible structural and compositional changes are detected using X-ray photoelectron spectroscopy. This study establishes that metastable phases can persist in reactive processes on surfaces, indicating their potential in heterogeneous catalysis.

Pt–Au/CeO2 catalysts for the simultaneous removal of carbon monoxide and formaldehyde

A series of Pt–Au/CeO₂ catalysts were prepared via the impregnation deposition–precipitation (IDP) and reduction–deposition precipitation (RDP) methods.