Efficiency of separation of DNA mutations by constant denaturant capillary electrophoresis is controlled by the kinetics of DNA melting equilibrium

Analysis of mutational spectra by denaturing capillary electrophoresis

The point mutational spectrum over nearly any 75- to 250-bp DNA sequence isolated from cells, tissues or large populations may be discovered using denaturing capillary electrophoresis (DCE). A modification of the standard DCE method that uses cycling temperature (e.g., +/-5 degrees C), CyDCE, permits optimal resolution of mutant sequences using computer-defined target sequences without preliminary optimization experiments. The protocol consists of three steps: computer design of target sequence including polymerase chain reaction (PCR) primers, high-fidelity DNA amplification by PCR and mutant sequence separation by CyDCE and takes about 6 h. DCE and CyDCE have been used to define quantitative point mutational spectra relating to errors of DNA polymerases, human cells in development and carcinogenesis, common gene-disease associations and microbial populations. Detection limits are about 5 x 10(-3) (mutants copies/total copies) but can be as low as 10(-6) (mutants copies/total copies) when DCE is used in combination with fraction collection for mutant enrichment. No other technological approach for unknown mutant detection and enumeration offers the sensitivity, generality and efficiency of the approach described herein.

Genetic mutation analysis by CE with LIF detection using inverse-flow derivatization of DNA fragments

Inverse-flow derivatization is a novel approach to obtain fluorescent DNA derivatives in DNA analysis based on CE with LIF detection. In the present work, we want to explore the feasibility of the application of this method into the mutation detection based on constant denaturant capillary electrophoresis (CDCE) and SSCP analysis. The DNA fragments were first amplified by PCR using a pair of common primers without fluorescent label, and then the mutations were determined by CDCE or SSCP analysis based on CE-LIF with inverse-flow derivatization of DNA fragments. The experimental conditions were investigated systematically, and different labeling modes including inverse-flow derivatization, on-column derivatization and fluorescent labeled primer technique were compared. The inverse-flow derivatization was successfully used in the detection of C677T mutation in the methylenetetrahydrofolate reductase gene by CDCE or SSCP analysis. Our preliminary results demonstrate that inverse-flow derivatization is very simple, inexpensive and sensitive and well suitable for the genetic analysis in clinical diagnosis.

Review of denaturant capillary electrophoresis in DNA variation analysis

Analyses of germline and somatic single-nucleotide DNA variations are important in both population genetics research and clinical practice. Reliable and inexpensive methods that are flexible and designed for automation are required for these analyses. Present day DNA sequencing technology is too expensive for testing all 22-25 000 human genes in populations genetics studies or in scanning large numbers of tumors for novel mutations. Denaturant capillary electrophoresis (DCE) has the potential to meet the need for large-scale analysis of DNA variants. Several different analyses can be performed by DCE, including mutation analysis, single-nucleotide polymorphism (SNP) discovery in individual and pooled samples, detection of allelic imbalance, and determination of microhaplotypes. Here we review the theoretical background of the method, its sensitivity, specificity, detection limit, throughput, and repeatability in the light of current literature in the field.

Spatial temperature gradient capillary electrophoresis for DNA mutation detection

A continuous spatial temperature gradient was established in capillary electrophoresis by using a simple temperature control device. The temperature profile along the capillary was predicted by theoretical calculations. A nearly linear spatial temperature gradient was established and applied to DNA mutation detection. By spanning a wide temperature range, it was possible to perform simultaneous heteroduplex analysis for various mutation types that have different melting temperatures.

Applications of constant denaturant capillary electrophoresis/high-fidelity polymerase chain reaction to human genetic analysis

Constant denaturant capillary electrophoresis (CDCE) permits high-resolution separation of single-base variations occurring in an approximately 100 bp isomelting DNA sequence based on their differential melting temperatures. By coupling CDCE for highly efficient enrichment of mutants with high-fidelity polymerase chain reaction (hifi PCR), we have developed an analytical approach to detecting point mutations at frequencies equal to or greater than 10(-6) in human genomic DNA. In this article, we present several applications of this approach in human genetic studies. We have measured the point mutational spectra of a 100 bp mitochondrial DNA sequence in human tissues and cultured cells. The observations have led to the conclusion that the primary causes of mutation in human mitochondrial DNA are spontaneous in origin. In the course of studying the mitochondrial somatic mutations, we have also identified several nuclear pseudogenes homologous to the analyzed mitochondrial DNA fragment. Recently, through developments of the means to isolate the desired target sequences from bulk genomic DNA and to increase the loading capacity of CDCE, we have extended the CDCE/hifi PCR approach to study a chemically induced mutational spectrum in a single-copy nuclear sequence. Future applications of the CDCE/hifi PCR approach to human genetic analysis include studies of somatic mitochondrial mutations with respect to aging, measurement of mutational spectra of nuclear genes in healthy human tissues and population screening for disease-associated single nucleotide polymorphisms (SNPs) in large pooled samples.

Application of constant denaturant capillary electrophoresis (CDCE) to mutation detection in humans

Constant denaturant electrophoresis is a DNA separation technique based on the principle of cooperative melting equilibrium. DNA sequences with distinct high and low melting domains can be utilized to separate and identify molecules differing by only one base pair in the lower melting domain. Combined with capillary gel electrophoresis and when coupled with high fidelity DNA amplification, this approach can detect mutants at a fraction of 10(-6). Modifications to the capillary electrophoretic system have also increased DNA loading capacity which allows for analysis of rare mutations in a large, heterogeneous population such as DNA samples derived from human tissues. Employment of this technology has determined the first mutational spectrum in human cells and tissues in a mitochondrial sequence without phenotypic selection of mutants.

Mitochondrial mutational spectra in human cells and tissues

We have found that human organs such as colon, lung, and muscle, as well as their derived tumors, share nearly all mitochondrial hotspot point mutations. Seventeen hotspots, primarily G --> A and A --> G transitions, have been identified in the mitochondrial sequence of base pairs 10,030-10,130. Mutant fractions increase with the number of cell generations in a human B cell line, TK6, indicating that they are heritable changes. The mitochondrial point mutation rate appears to be more than two orders of magnitude higher than the nuclear point mutation rate in TK6 cells and in human tissues. The similarity of the hotspot sets in vivo and in vitro leads us to conclude that human mitochondrial point mutations in the sequence studied are primarily spontaneous in origin and arise either from DNA replication error or reactions of DNA with endogenous metabolites. The predominance of transition mutations and the high number of hotspots in this short sequence resembles spectra produced by DNA polymerases in vitro.

Mutational spectrometry without phenotypic selection: human mitochondrial DNA

By first separating mutant from nonmutant DNA sequences on the basis of their melting temperatures and then increasing the number of copies by high-fidelity DNA amplification, we have developed a method that allows observation of point mutations in biological samples at fractions at or above 10-6. Using this method, we have observed the hotspot point mutations that lie in 100 base pairs of the mitochondrial genome in samples of cultured cells and human tissues. To date, 19 mutants have been isolated, their fractions ranging from 4x10-4 down to the limit of detection. We performed specific tests to determine if the observed signals were artefacts arising from contamination, polymerase errors during PCR or DNA adducts created during the procedure. We also tested the possibilities that DNA replication mismatch intermediates, or endogenous DNA adducts that were originally present in the cells, were included with true mutants in our separation steps and converted to mutants during PCR. We show that while most of the mutants behave as double-stranded point mutants in the cells, some appear to arise at least in part from mismatch intermediates or cellular DNA adducts. This technology is therefore sufficient for the observation of the spectrum of point mutations in human mitochondrial DNA and is a tool for discovering the primary causes of these mutations.