Use of multivariate analysis for optimization of separation parameters and prediction of migration time, resolution, and resolutionper unit time in micellar electrokinetic chromatography

Application of polymeric surfactants in chiral micellar electrokinetic chromatography (CMEKC) and CMEKC coupled to mass spectrometry

The use of amino acid-based polymeric surfactants (a.k.a. molecular micelles) in chiral micellar electrokinetic chromatography (CMEKC) has been shown to be a successful separation mode for capillary electrophoresis (CE). In this mode, chiral compounds can be enantioseparated with high efficiency, high chiral selectivity, and versatility. This chapter describes the state-of-the art studies published in the past 5 years in CMEKC using polymeric surfactants. Recent trends in the compatibility of chiral polymeric surfactants with mass spectrometric (MS) detection suggest that this type of chiral selector may be the most promising ones for chiral CE-MS applications. The synthesis of new anionic and cationic MS-compatible polymeric surfactants and their utility in CMEKC and CMEKC-MS are demonstrated. Examples of how to run a typical CMEKC-MS experiment using univariate and multivariate optimization of CMEKC and MS parameters are discussed.

Achiral and chiral separations using MEKC, polyelectrolyte multilayer coatings, and mixed mode separation techniques with molecular micelles

Mixed mode (MM) separation using a combination of MEKC and polyelectrolyte multilayer (PEM) coatings is herein reported for the separation of achiral and chiral analytes. Many analytes are difficult to separate by MEKC and PEM coatings alone. Therefore, the implementation of a MM separation provides several advantages for overcoming the limitations of these well-established methods. In this study, it was observed that achiral separations using MEKC and PEM coatings individually resulted in partial resolution of eight very similar aryl ketones when the molecular micelle (sodium poly(N-undecanoyl-L-glycinate)) concentration was varied from 0.25 to 1.00% w/v and the bilayer number varied from 2 to 4. However, when MM separation was introduced, baseline resolution was achieved for all eight analytes. In the case of chiral separations, temazepam, aminoglutethimide, benzoin, benzoin methyl ether, and coumachlor were separated using the three separation techniques. For chiral separations, the chiral molecular micelle, sodium poly(N-undecanoyl-L-leucylvalinate), was employed at concentrations of 0.25-1.50% w/v for both MEKC and PEM coatings. Overall, the results revealed partial separation with MEKC and PEM coatings individually. However, MM separation enabled baseline separation of each chiral mixture. The separation of achiral and chiral compounds from different compound classes demonstrates the versatility of this MM approach.

Multivariate approach for the enantioselective analysis in MEKC-MS: II. Optimization of 1,1'-binaphthyl-2,2'-diamine in positive ion mode

Enantiomeric separation and detection of 1,1'-binaphthyl-2,2'-diamine (BNA) has been successfully optimized by MEKC-ESI-MS using a polymeric surfactant polysodium N-undecenoxycarbonyl-L-leucinate (poly-L-SUCL) as a pseudostationary phase. In the first step, MEKC conditions were optimized by a five-factor three-level central composite design (CCD) of experiment. All five MEKC factors (buffer pH, percentage of ACN in the running buffer, concentration of surfactant, concentration of ammonium acetate (NH4OAc), and voltage) were found significant to the responses (measured as the chiral resolution and analysis time). The interactions between MEKC factors were further evaluated using a quadratic model equation which allowed the generation of 3-D response surface image to reach the optimum conditions. To obtain the best S/N, sheath liquid composition and spray chamber parameters were successfully optimized using the same strategy. Baseline enantiomeric resolution in less than 20 min and optimum MS signal of BNA enantiomers (S/N = 45 at 0.4 mg/mL) were ultimately achieved at the optimized conditions. The adequacy of the model was validated by experimental runs at the optimal predicted conditions. The predicted results were found to be in good agreement with the experimental data.

Optimized separation of beta-blockers with multiple chiral centers using capillary electrochromatography-mass spectrometry

This work focuses on the simultaneous analysis of beta-blockers with multiple stereogenic centers using capillary electrochromatography-mass spectrometry (CEC-MS) with a vancomycin stationary phase. The critical mobile phase variables (composition of organic solvents, acid/base ratios) as well as column temperature and electric field strength, effecting enantioresolution and analysis time were first optimized sequentially. Next, to achieve global optimum a multivariate D-optimal design was used. Although multivariate approach did not improve enantioresolution any further, analysis time was significantly reduced. Under optimum CEC-MS conditions, all stereoisomers were resolved with resolution in the range 1.0-3.1 in less than 60 min with an average signal-to-noise (S/N) greater than 1000. The developed CEC-MS method has the potential to emerge as a screening method for analysis of multiple chiral compounds using a single protocol using the same column and mobile phase conditions, thus reducing the operation time and cost.

Multivariate approach for the enantioselective analysis in micellar electrokinetic chromatography-mass spectrometry. I. Simultaneous optimization of binaphthyl derivatives in negative ion mode

A mixture of two molecular micelles polysodium N-undecenoxy carbonyl-L-leucinate, (poly-L-SUCL) and polysodium N-undecanoyl leucylvalinate, (poly-L-SULV) was utilized in micellar electrokinetic chromatography-electrospray ionization-mass spectrometry (MEKC-ESI-MS) to simultaneously separate and detect enantiomers of binaphthyl derivatives. Separation parameters such as background buffer composition, voltage, temperature, and nebulizer pressure were optimized using a multivariate central composite design (CCD). Baseline enantioseparation for both analytes was achieved. The CCD was also used in the optimization of sheath liquid and spray chamber parameters to achieve optimum ESI-MS response. The results demonstrate that CCD is a powerful tool for the optimization of MEKC-MS parameters and the response surface model analysis can provide in-depth statistical understandings of the significant factors required to achieve maximum enantioresolution and ESI-MS sensitivity.

Electrokinetic chromatography with polymeric pseudostationary phases

Recent research and development efforts concerning polymeric pseudostationary phases (PSPs) for electrokinetic chromatography are reviewed. The introduction of new materials, characterization of structural effects on performance and selectivity, applications, and the use of polymeric PSPs with mass spectrometric detection are considered. Very interesting results concerning the effects of polymer structure have been reported. Significant developments have also been reported in the development of novel applications of polymeric PSPs, particularly for sample preconcentration using micellar affinity gradient focusing. The use of mass spectrometric detection with electrokinetic chromatography has seen significant development, and recent reports indicate that this is a robust and sensitive approach.