Capillary electrochromatography-mass spectrometry of cationic surfactants

Development of a fritless packed column for capillary electrochromatography-mass spectrometry

A novel procedure was developed for the fabrication of a fritless packed column for the coupling of capillary electrochromatography (CEC) to mass spectrometry (MS). The process involved the formation of internal tapers on two separate columns. Once the internal tapers are formed and the columns are packed, the untapered ends of each column were joined together by a commercially available connector. Several advantages of the fritless columns are described. First, the design used here eventually eliminates the need for any frits thus reducing the possibility of bubble formation seen with fritted packed columns. In addition, this is the first report in which the internal tapers are formed at both the inlet and outlet column ends making the fritless CEC-MS column more robust compared to only one report with externally tapered counterparts. Second, a comparison of internally tapered single frit packed CEC-MS (previously developed in our laboratory) column versus fritless CEC-MS column reported here shows that the latter provides better efficiency, suggesting no dead volume with equally good sensitivity and chiral resolution of (±)-aminoglutethimide. The fritless column procedure is universal and was used to prepare a series of columns with a variety of commercially available packing material (mixed mode strong cation exchange, SCX; mixed mode strong anion exchange, SAX; C-18) for the separation and MS detection of short chain non-chromophoric polar amines, long chain nonchromophic anionic surfactant as well as oligomers of non-chromophoric non-ionic surfactants, respectively. The fritless columns showed good intra-day repeatability and inter-day reproducibility of retention times, chiral and achiral resolutions and peak areas. Very satisfactory column-to-column and operator-to-operator reproducibility was demonstrated.

CEC-atmospheric pressure ionization MS of pesticides using a surfactant-bound monolithic column

A surfactant bound poly (11-acrylaminoundecanoic acid-ethylene dimethacrylate) monolithic column was simply prepared by in situ co-polymerization of 11-acrylaminoundecanoic acid and ethylene dimethacrylate with 1-propanol, 1,4-butanediol and water as porogens in 100 microm id fused-silica capillary in one step. This column was used in CEC-atmospheric pressure photoionization (APPI)-MS system for separation and detection of N-methylcarbamates pesticides. Numerous parameters are optimized for CEC-APPI-MS. After evaluation of the mobile phase composition, sheath liquid composition and the monolithic capillary outlet position, a fractional factorial design was selected as a screening procedure to identify factors of ionization source parameters, such as sheath liquid flow rate, drying gas flow rate, drying gas temperature, nebulizing gas pressure, vaporizer temperature and capillary voltage, which significantly influence APPI-MS sensitivity. A face-centered central composite design was further utilized to optimize the most significant parameters and predict the best sensitivity. Under optimized conditions, S/Ns around 78 were achieved for an injection of 100 ng/mL of each pesticide. Finally, this CEC-APPI-MS method was successfully applied to the analysis of nine N-methylcarbamates in spiked apple juice sample after solid phase extraction with recoveries in the range of 65-109%.

[Recent advances in capillary electrochromatography and its coupling techniques]

As a novel micro-separation technique, capillary electrochromatography (CEC) has the merits of high efficiency, high selectivity, high resolution and rapid analysis. However, the small-volume injection manipulated in capillary dimensions poses a great challenge for detectors in achieving high sensitivity. Currently, one of the major researches into CEC involves the development of some sensitive detection modes. The general introduction, which includes the historical perspectives and the principles of CEC, is briefly described. The recent advances about CEC coupled with various detectors and its applications in the separation of complex samples are summarized. A total of 141 references are reviewed.

Development of in-tube solid-phase microextraction coupled to pressure-assisted CEC and its application to the analysis of propranolol enantiomers in human urine

A successful hyphenation of in-tube solid-phase microextraction (SPME) and pressure-assisted CEC (pCEC) was developed by installing a poly(methacrylic acid-co-ethylene glycol dimethacrylate) monolithic capillary to the six-port valve in a CEC system. The device designed was appropriate for on-line in-tube SPME coupled to pCEC or muHPLC. The evaluation of this hyphenation was first carried out for in-tube SPME-muHPLC with analytical capillaries packed with 3 microm octadecyl silica (ODS). Theobromine (TB), theophylline (TP), and caffeine (CA) were chosen as model drugs for an easy comparison with the results obtained by in tube SPME-HPLC. The detection limits of these three analytes were improved more than 100 times when compared with the direct analysis by muHPLC. Then in-tube SPME-pCEC with CEC capillaries packed with perphenylcarbamoylated beta-CD-bonded silica particles was applied to the determination and analysis of propranolol enantiomers in human urine. Under optimal extraction and separation conditions, the experimental LODs were 4 and 7 ng/mL for (S)-propranolol and (R)-propranolol, respectively. The calibration curves showed good linearity for both (S)-propranolol (R(2) = 0.9997) and (R)-propranolol (R(2) = 0.9996) over the concentration range from 20 to 5000 ng/mL. Reproducibility of the method was also investigated with intra- and interday precisions lower than 10% for both enantiomers at different concentration levels.