Determining under- and oversampling of individual particle distributions in microfluidic electrophoresis with orthogonal laser-induced fluorescence detection

Spherical Dichroic Reflector Improves Limit of Detection in Laser-Induced Fluorescence Detection

A miniature laser-induced fluorescence (mLIF) detector utilizing a novel spherical dichroic reflector (SDR), an unconventional long working distance high magnification objective, an uncommon broadband emission-matched excitation filter pair, and a silicon-based photodiode detector assembly instead of a photomultiplier tube was developed and evaluated. The detection cell was placed at the spherical center of the SDR instead of the regular focus, yielding a 1.8× signal-to-noise ratio (SNR) improvement. Different from previous works, the use of a 40× objective with a long working distance of 5.38 mm and a broadband BP 527-70 nm emission filter with matched BP 450-30 nm excitation filter improved SNR to 4.6× and 1.9×, respectively. By flow injection analysis (FIA) evaluation, the limit of detection (LOD; 3σ method) for fluorescein sodium was 1.5 × 10^-13 M or 8.9 fluorescein molecules in 98 pL detection volume, which was the lowest level of LIFs evaluated by FIA mode. The analysis of three kinds of amino acids with LODs at sub pM to fM level (the lowest levels, hundreds of times lower than previous works using normal capillary) demonstrated the potential of the mLIF in ultratrace analysis of biological and environmental samples, including low copy molecules in a single cell.

A compact and low-cost laser induced fluorescence detector with silicon based photodetector assembly for capillary flow systems

A compact and low-cost laser induced fluorescence (LIF) detector based on confocal structure for capillary flow systems was developed and applied for analysis of Her2 protein on single Hela cells. A low-power and low-cost 450 nm laser diode (LD) instead of a high quality laser was used as excitation light source. A compact optical design together with shortened optical path length improved the optical efficiency and detection sensitivity. A superior silicon based photodetector assembly was used for fluorescence detection instead of a photomultiplier (PMT). The limit of detection (LOD) for fluorescein sodium was 3 × 10^-12 M or 165 fluorescein molecules in detection volume measured on a homemade capillary electroosmotic driven (EOD)-LIF system, which was similar to commercial LIFs. Compared to commercial LIFs, the whole volume of our LIF was reduced to 1/2-1/3, and the cost was less than 1/3 of them.

Identifying indoor environmental patterns from bioaerosol material using HPLC

A substantial portion of the atmospheric particle budget is of biological origin (human and animal dander, plant and insect debris, etc.). These bioaerosols can be considered information-rich packets of biochemical data specific to the organism of origin. In this study, bioaerosol samples from various indoor environments were analyzed to create identifiable patterns attributable to a source level of occupation. Air samples were collected from environments representative of human high-traffic- and low-traffic indoor spaces along with direct human skin sampling. In all settings, total suspended particulate matter was collected and the total aerosol protein concentration ranged from 0.03 to 1.2 μg/m(3). High performance liquid chromatography was chosen as a standard analysis technique for the examination of aqueous aerosol extracts to distinguish signatures of occupation compared to environmental background. The results of this study suggest that bioaerosol "fingerprinting" is possible with the two test environments being distinguishable at a 97% confidence interval.

Evaluation of peak overlap in migration-time distributions determined by organelle capillary electrophoresis: Type-II error analogy based on statistical-overlap theory

Organelles commonly are separated by capillary electrophoresis (CE) with laser-induced-fluorescence detection. Usually, it is assumed that peaks observed in the CE originate from single organelles, with negligible occurrence of peak overlap. Under this assumption, migration-time and mobility distributions are obtained by partitioning the CE into different regions and counting the number of observed peaks in each region. In this paper, criteria based on statistical-overlap theory (SOT) are developed to test the assumption of negligible peak overlap and to predict conditions for its validity. For regions of the CE having constant peak density, the numbers of peaks (i.e., intensity profiles of single organelles) and observed peaks (i.e., maxima) are modeled by probability distributions. For minor peak overlap, the distributions partially merge, and their mergence is described by an analogy to the Type-II error of hypothesis testing. Criteria are developed for the amount of peak overlap, at which the number of observed peaks has an 85% or 90% probability of lying within the 95% confidence interval of the number of peaks of single organelles. For this or smaller amounts of peak overlap, the number of observed peaks is a good approximation to the number of peaks. A simple procedure is developed for evaluating peak overlap, requiring determination of only the peak standard deviation, the duration of the region occupied by peaks, and the number of observed peaks in the region. The procedure can be applied independently to each region of the partitioned CE. The procedure is applied to a mitochondrial CE.