Kinetic study of the reactions ofp-nitrophenyl acetate andp-nitrophenyl benzoate with oximate nucleophiles

Environmental role of aromatic carboxylesterases

The carboxylesterases (EC 3.1.1.x) are widely distributed and form an important yet diverse group of hydrolases catalysing the ester bond cleavage in a variety of substrates. Besides acting on plant cell wall components like cutin, tannin and feruloyl esters, they are often the first line of defence to metabolize drugs, xenobiotics, pesticides, insecticides and plastic. But for the promiscuity of some carboxylesterases and cutinases, very few enzymes act exclusively on aromatic carboxylic acid esters. Infrequent occurrence of aromatic carboxylesterases suggests that aromatic carboxylesters are inherently more difficult to hydrolyse than the regular carboxylesters because of both steric and polar effects. Naturally occurring aromatic carboxylesters were rare before the anthropogenic activity augmented their environmental presence and diversity. An appraisal of the literature shows that the hydrolysis of aromatic carboxylic esters is a uniquely difficult endeavour and hence deserves special attention. Enzymes to hydrolyse such esters are evolving rapidly in nature. Very few such enzymes are known and they often display much lower catalytic efficiencies. Obviously, the esters of aromatic carboxylic acids, including polyethylene terephthalate waste, pose an environmental challenge. In this review, we highlight the uniqueness of aromatic carboxylesters and then underscore the importance of relevant carboxylesterases.

Synthesis and disinfection effect of the pyridine-4-aldoxime based salts

A set of new quaternary ammonium compounds based on pyridine-4-aldoxime was synthesized, characterized with analytical data (NMR, EA, HPLC, MS) and tested for in vitro antimicrobial activity (antibacterial, antifungal) and cytotoxicity. Quaternary pyridinium-4-aldoxime salts with length of alkyl side chain from C8 to C20 and belonging to the group of cationic surfactants were investigated in this work. An HPLC experimental protocol for characterization of mixtures of all homologues has been found. Antimicrobial evaluation found that yeast-type fungi were most sensitive towards C₁₄ and C₁₆ analogues, whereas the C₁₆ analogue was completely ineffective against filamentous fungi. Antibacterial assessment showed versatility of C₁₄ and relatively high efficacy of C₁₆ against G+ strains and C₁₄ against G− strains. Notably, none of the studied compounds exceeded the efficacy and versatility of the benzalkonium C₁₂ analogue, and benzalkonium analogues also exhibited lower cytotoxicity in the cell viability assay.

Montmorillonite functionalized with pralidoxime as a material for chemical protection against organophosphorous compounds

Montmorillonite K-10 functionalized with α-nucleophilic 2-pralidoxime (PAM) and its zwitterionic oximate form (PAMNa) is introduced as a versatile material for chemical protection against organophosphorous (OP) compounds such as pesticides and chemical warfare agents (CWA). Upon inclusion into the montmorillonite interlayer structure, the pyridinium group of PAMNa is strongly physisorbed onto acidic sites of the clay, leading to shrinking of the interplanar distance. Degradation of diethyl parathion by PAMNa-functionalized montmorillonite in aqueous-acetonitrile solutions occurred primarily via hydrolytic conversion of parathion into diethylthio phosphoric acid, with the initial stages of hydrolysis observed to be pseudo-first-order reactions. Hydrolysis catalyzed by the clay intercalated by PAMNa was 10- and 17-fold more rapid than corresponding spontaneous processes measured at 25 and 70 °C, respectively. Hydrolytic degradation of diisopropyl fluorophosphate (DFP), a CWA simulant, was studied on montmorillonite clay functionalized by PAMNa and equilibrated with water vapor at 100% relative humidity by ³¹P high-resolution magic angle spinning NMR and was observed to be rather facile compared with the untreated montmorillonite, which did not show any DFP hydrolysis within 24 h. The incorporation of the functionalized clay particles into elastomeric film of polyisobutylene was shown to be a means to impart DFP-degrading capability to the film, with clay particle content exceeding 18 wt %.