Electron capture negative ion and positive ion chemical ionization mass spectrometry of polychlorinated phenoxyanisoles

Gas chromatography coupled to electron capture negative ion mass spectrometry with nitrogen as the reagent gas--an alternative method for the determination of polybrominated compounds

Gas chromatography in combination with electron capture negative ion mass spectrometry (GC/ECNI-MS) is a sensitive method for the determination of polybrominated compounds in environmental and food samples via detection of the bromide ion isotopes m/z 79 and 81. The standard reagent gas for inducing chemical ionization in GC/ECNI-MS is methane. However, the use of methane has some drawbacks as it promotes carbonization of the filament and ion source. In this study, we explored the suitability of nitrogen as reagent gas for the determination of brominated flame retardants (polybrominated diphenyl ethers (PBDEs), polybrominated biphenyls (PBBs), allyl-2,4,6-tribromophenyl ether (ATE) and 2,3-dibromopropyl-2,4,6-tribromophenyl ether (DPTE)) and halogenated natural products (for instance, methoxylated tetrabrominated diphenylethers and polybrominated hexahydroxanthene derivatives). An ion source temperature of 250 degrees C and a nitrogen pressure of 7 Torr in the ion source gave the highest response for m/z 79 and 81 of virtually all investigated polybrominated compounds. Using these conditions, nitrogen-mediated GC/ECNI-MS usually gave higher sensitivity than the method with methane previously used in our lab. In addition, the ion source was not contaminated to the same degree and the lifetime of the filament was significantly increased. Moreover, the response factors of the different polybrominated compounds with the exception of 2,4,6-tribromophenol were more uniform than with methane. Nitrogen is available at very high purity at relatively low price.

Gas chromatography and mass spectrometry of methoxylated polybrominated diphenyl ethers (MeO-PBDEs)

Twenty-six methoxylated polybrominated diphenyl ethers (MeO-PBDEs) were characterized by gas chromatography (GC) on four different GC columns with different lengths and polarities, as well as by mass spectrometry using three ionization techniques, electron ionization (EI), electron capture negative ionization (ECNI) and positive ion chemical ionization (PICI). MeO-PBDE congeners with similar retention times on a nonpolar GC column were separated when analyzed on a polar GC column. EI can be used to determine the position of the methoxy substituent (ortho, meta or para) relative to the diphenyl ether oxygen in the MeO-PBDEs. The PICI ionization technique is shown to be valuable to generate structural information of the MeO-PBDEs, i.e. the degree of bromination on both the methoxy-substituted ring and the entirely brominated phenyl ring can be obtained. This structure information can also be achieved for certain MeO-PBDEs with the methoxy group in ortho position to the diphenyl ether bond in ECNI mode. Like other brominated compounds ECNI is preferable when analyzing environmental samples for quantification of MeO-PBDEs because of the formation of bromide ions, which enables low detection limits.

Enhanced sensitivity in the analysis of trace organochlorine compounds by negative-ion mass spectrometry with ammonia as reagent gas

A comparison of the performances of ammonia and methane as reagent gases for the analysis of trace organochlorine compounds by gas chromatography coupled to negative-ion chemical ionization mass spectrometry is performed in the present study. Examples of standard mixtures and human blood samples analyzed with both reagents in scan and selected-ion monitoring mode are shown. Important advantages are observed as a consequence of the use of ammonia. These concern detection and quantitation limits and the lower dependence of sensitivity on the degree of chlorine substitution of the compounds.