Performances of poly(vinylidene fluoride-co -hexafluoropropylene) ultrafiltration membranes modified with poly(vinyl pyrrolidone)

Noncovalently Functionalized Sulfated Castor Oil-Graphene Oxide-Strengthened Polyetherimide Composite Membranes for Superior Separation of Organic Pollutants and Their Fouling Mitigation

A novel sulfated castor oil (SCO)-graphene oxide (GO)-strengthened polyetherimide (PEI) membrane was prepared for the first time via phase inversion process for the efficient separation of multiple organic pollutants with superior long-term antifouling stability. X-ray diffraction, attenuated total reflectance-Fourier transfer infrared spectroscopy, X-ray photoelectron spectroscopy, scanning electron microscopy, and mechanical strength studies revealed that the SCO and GO were successfully incorporated into the PEI membrane with enhanced mechanical strength. The water flux of the PEI/SCO@GO membrane (410.6 L m^-2 h^-1) was about 50 times that of bare PEI (7.8 L m^-2 h^-1) and about 6 times that of PEI/SCO (64.5 L m^-2 h^-1) membranes. The surface hydrophilicity of the PEI/SCO@GO membrane was significantly increased in terms of the decrease of the water contact angle from 98.5° (bare PEI) to 40.4°. The PEI/SCO@GO membrane separation efficiency was found to be greater than 99.0%, particularly for both the oil-in-water emulsion and the humic acid solution, respectively. Because of the higher flux recovery ratio and the lower total fouling rate of the PEI/SCO@GO membrane, a comprehensive antifouling performance was observed during the long-term foulant filtration cycle analyses. Hence, the incorporation of both SCO and GO into the PEI matrix would render the highly hydrophobic PEI material as the suitable and desirable antifouling membrane toward the treatment of various organic foulants in wastewater.

Mechanical, thermal, and morphological properties of nanoporous reinforced polysulfone membranes

The effect of three different diphenols including 1,1′-thiobis(2-naphthol) (TBN), 2,2′-thiobis(4-methyl phenol) (TBMP) and curcumin (CUR) used in the preparation of sulfonated poly(ether sulfide sulfone) (SPESS) on the mechanical, thermal, and morphological properties of polysulfone (PSf) membranes was studied. In this regard, the morphological characteristics of the nanoporous membranes were explored by developed image analyzer program. Based on the obtained results, PSf membrane modified by SPESS-TBN copolymer showed the best nominal tensile strength in comparison to the other samples with the value of 206 MPa. The optimum real tensile strength with the value of 322 MPa was observed for SPESS-TBMP membrane. It was found that the addition of SPESS, improved the mechanical and thermal properties as well as the performance of membranes. Inspections of scanning electron microscopic images for evaluation of the void properties of membranes revealed that there were 42.3, 8.76, 41.45 and 15.92% of void contents within the structures of neat PSf membrane, SPESS-CUR, SPESS-TBMP and SPESS-TBN, respectively. Moreover, some conceptual relations between morphological and mechanical properties were presented. Finally, the effect of the membrane chemical structure on the mechanical, thermal, and morphological properties was discussed in this study.