A Revision of Current Models for Environmental and Human Health Impact and Risk Assessment for Application to Emerging Chemicals

Trace gas emissions from municipal solid waste landfills: A review

Trace gas emissions from municipal solid waste (MSW) landfills have received increasing attention in recent years. This paper reviews literature published between 1983 and 2019, focusing on (i) the origin and fate of trace gas in MSW landfills, (ii) sampling and analytical techniques, (iii) quantitative emission measurement techniques, (iv) concentration and surface emission rates of common trace compounds at different landfill units and (v) the environmental and health concerns associated with trace gas emissions from MSW landfills. Trace gases can be produced from waste degradation, direct volatilisation of chemicals in waste products or from conversions/reactions between other compounds. Different chemical groups dominate the different waste decomposition stages. In general, organic sulphur compounds and oxygenated compounds are connected with fresh waste, while abundant hydrogen sulphide, aromatics and aliphatic hydrocarbons are usually found during the methane fermentation stage. Selection of different sampling, analytical and emission rate measurement techniques might generate different results when quantifying trace gas emission from landfills, and validation tests are needed to evaluate the reliability of current methods. The concentrations of trace gases and their surface emission rates vary largely from site to site, and fresh waste dumping areas and uncovered waste surfaces are the most important fugitive emission sources. The adverse effects of trace gas emission are not fully understood, and more emission data are required in future studies to assess quantitatively their environmental impacts as well as health risks.

Effects of heat recovery for district heating on waste incineration health impact: a simulation study in Northern Italy

The construction of waste incinerators in populated areas always causes substantial public concern. Since the heat from waste combustion can be recovered to power district heating networks and allows for the switch-off of domestic boilers in urbanized areas, predictive models for health assessment should also take into account the potential benefits of abating an important source of diffuse emission. In this work, we simulated the dispersion of atmospheric pollutants from a waste incinerator under construction in Parma (Italy) into different environmental compartments and estimated the potential health effect of both criteria- (PM(10)) and micro-pollutants (PCDD/F, PAH, Cd, Hg). We analyzed two emission scenarios, one considering only the new incinerator, and the other accounting for the potential decrease in pollutant concentrations due to the activation of a district heating network. We estimated the effect of uncertainty in parameter estimation on health risk through Monte Carlo simulations. In addition, we analyzed the robustness of health risk to alternative assumptions on: a) the geographical origins of the potentially contaminated food, and b) the dietary habits of the exposed population. Our analysis showed that under the specific set of assumptions and emission scenarios explored in the present work: (i) the proposed waste incinerator plant appears to cause negligible harm to the resident population; (ii) despite the net increase in PM(10) mass balance, ground-level concentration of fine particulate matter may be curbed by the activation of an extensive district heating system powered through waste combustion heat recovery and the concurrent switch-off of domestic/industrial heating boilers. In addition, our study showed that the health risk caused by waste incineration emissions is sensitive to assumptions about the typical diet of the resident population, and the geographical origins of food production.