Proteome mapping by two-dimensional polyacrylamide gel electrophoresis in combination with mass spectrometric protein sequence analysis

Purification, biochemical characterization, and bioactive properties of a lectin purified from the seeds of white tepary bean (phaseolus acutifolius variety latifolius)

The present work shows the characterization of Phaseolus acutifolius variety latifolius, on which little research has been published, and provides detailed information on the corresponding lectin. This protein was purified from a semi-domesticated line of white tepary beans from Sonora, Mexico, by precipitation of the aqueous extract with ammonium sulfate, followed by affinity chromatography on an immobilized fetuin matrix. MALDI TOF analysis of Phaseolus acutifolius agglutinin (PAA) showed that this lectin is composed of monomers with molecular weights ranging between 28 and 31 kDa. At high salt concentrations, PAA forms a dimer of 63 kDa, but at low salt concentrations, the subunits form a tetramer. Analysis of PAA on 2D-PAGE showed that there are mainly three types of subunits with isoelectric points of 4.2, 4.4, and 4.5. The partial sequence obtained by LC/MS/MS of tryptic fragments from the PAA subunits showed 90-100% identity with subunits from genus Phaseolus lectins in previous reports. The tepary bean lectin showed lower hemagglutination activity than Phaseolus vulgaris hemagglutinin (PHA-E) toward trypsinized human A and O type erythrocytes. The hemagglutination activity was inhibited by N-glycans from glycoproteins. Affinity chromatography with the immobilized PAA showed a high affinity to glycopeptides from thyroglobulin, which also has N-glycans with a high content of N-acetylglucosamine. PAA showed less mitogenic activity toward human lymphocytes than PHA-L and Con A. The cytotoxicity of PAA was determined by employing three clones of the 3T3 cell line, demonstrating variability among the clones as follows: T4 (DI₅₀ 51.5 µg/mL); J20 (DI₅₀ 275 µg/mL), and N5 (DI₅₀ 72.5 µg/mL).

Characterization of the fluoroacetate detoxication enzymes of rat liver cytosol

Two forms of fluoroacetate-specific defluorinase (FSD) were purified from rat hepatic cytosol. The first form, FSD1 (molecular weight 38 kDa), contained 81% of the total cytosolic fluoroacetate defluorination activity and did not bind to the glutathione-affinity, orange A or mono P columns used in the purification procedures. The second form, FSD2 (molecular weight 27 kDa), contained only 13% of the fluoroacetate defluorination activity, had a pI = 7.8, and exhibited a high glutathione S-transferase (GST)-like activity towards dichloroacetic acid. The FSD1 proteins were identified from peptide mass data and best matched with rat sorbitol dehydrogenase (SDH) (short form), although pure sheep liver SDH enzyme did not possess defluorination activity when subsequently investigated. The FSD2 protein was identified from peptide mass data and best matched with the amino acid sequence of mouse and human Zeta 1 of glutathione S-transferase (GSTZ1) and showed a high GSTZ1 specific activity. This study suggests that the major FSD component (FSD1) represents a new and unique dehalogenating or dehydrogenating enzyme present in rat liver cytosol. The minor FSD component (FSD2) is due to the GSTZ1 present in rat liver cytosol. However, it is not yet clear that FSD1 is indeed SDH and FSD2 is indeed GSTZ1, due to sequence homology being less than 60 and 45%, respectively.

Digital Microfluidics with In-Line Sample Purification for Proteomics Analyses with MALDI-MS

An in-line sample purification method for MALDI-MS, which relies on the electrowetting-on-dielectric (EWOD)-based technique for digital microfluidics, is reported. In this method, a droplet containing peptides and impurities is moved by EWOD and deposited onto a Teflon-AF surface. A droplet of water is subsequently moved over the spot, where it dissolves and removes the impurities. A droplet containing MALDI matrix is then moved to the spot, which is analyzed by MALDI-MS. This purification method reduces the number of salt adduct peaks caused by low concentrations of impurities (e.g., 20 mM sodium phosphate), and reduces or eliminates the catastrophic effects of high concentrations of impurities (e.g., 8 M urea). The method was used to purify spots made by depositing multiple droplets of contaminated peptides. Spectra from the purified spots showed an increase in the S/N ratio as a function of the number of droplets deposited; when not purified, the S/N ratio remained constant regardless of the number of droplets. Finally, the method was used to purify protein digests for peptide mass fragment (PMF) searches, and was shown to be more efficient than the conventional method of purification with reversed-phase-packed pipet tips. We anticipate this new, in-line sample purification technique for EWOD-MALDI-MS will enable development of integrated high-throughput proteomics analysis methodologies.

Integrated sample preparation and MALDI mass spectrometry on a microfluidic compact disk

High-throughput microfluidic processing of protein digests integrated with matrix-assisted laser desorption/ionization (MALDI) mass spectrometry on a compact disk (CD) is described. Centrifugal force moves liquid through multiple microstructures, each containing a 10-nL reversed-phase chromatography column. The CD enables parallel preparation of 96 samples with volumes ranging from one to several microliters. The peptides in the digests are concentrated, desalted, and subsequently eluted from the columns directly into MALDI target areas (200 x 400 microm) on the CD using a solvent containing the MALDI matrix. After crystallization, the CD is inserted into the MALDI instrument for peptide mass fingerprinting and database identification at a routine sensitivity down to the 200-amol level. Detection of proteolytic peptides down to the 50-amol level is demonstrated. The success rate of the CD technology in protein identification is about twice that of the C(18) ZipTips and standard MALDI steel targets. The CDs are operated using robotics to transfer samples and reagents from microcontainers to the processing inlets on the disposable CD and spinning to control the movement of liquid through the microstructures.