Electrochemical determination of rusted steel surface stability

Wetting and swelling behaviour of N-acetylated thin chitosan coatings in aqueous media

Chitosan nanocoatings (thickness range of 120-540 nm) were produced on glass, zinc and silicon substrates with dip-coating and spin coating techniques to study their pH-dependent wetting and swelling behaviour. The coatings were N-acetylated with the methanolic solution of acetic anhydride to increase the degree of acetylation from 36 % to 100 % (according to ATR-FTIR studies). The measured contact angles of Britton-Robinson (BR) buffer solutions (pH 6.0, 7.4 and 9.0) were lower on the acetylated surfaces (ca. 50°), than that of their native counterparts (ca. 70°) and does not depend on the pH. Contrary, contact angles on the native coating deteriorated 10°-15° with increasing the pH. In addition, for native coatings, the decrease of the contact angles over time also showed a pH dependence: at pH 9.0 the contact angle decreased by 7° in 10 min, while at pH 6.0 it decreased by 13° and at a much faster rate. The constraint swelling of the coatings in BR puffer solutions was studied in situ by scanning angle reflectometry. The swelling degree of the native coatings increased significantly with decreasing pH (from 250 % to 500 %) due to the increased number of protonated amino groups, while the swelling degree of acetylated coatings was ca. 160 % regardless of the pH. The barrier properties of the coatings were studied by electrochemical tests on zinc substrates. The analysis of polarization curves showed the more permeable character of the acetylated coatings despite the non-polar character of the bulk coating matrix. It can be concluded that in the case of native coatings, 49 % of the absorbed water is in bound form, which does not assist ion transport, while in the case of acetylated coatings, this value is only 33 %.

Accumulation of 2-Acetylamino-5-mercapto-1,3,4-thiadiazole in chitosan coatings for improved anticorrosive effect on zinc

Chitosan (Chit) coatings were applied on zinc substrates by the dip-coating method. Subsequently, the coatings were impregnated with a corrosion inhibitor, 2-Acetylamino-5-mercapto-1,3,4-thiadiazole (AcAMT) to obtain an increased anticorrosive effect. The coating thickness and the AcAMT accumulation were determined using UV-Vis spectroscopy on glass and quartz substrates, respectively. The surface morphology and coverage were investigated with atomic force microscopy. Electrochemical impedance spectroscopy and potentiodynamic polarization techniques were used to investigate the protective properties of the impregnated coatings. The chitosan coatings facilitated the accumulation of the corrosion inhibitor inside the polymeric matrix (a multiplication of 380 times compared to the impregnating solution concentration was calculated), channeling high amounts of AcAMT to the Zn surface, which resulted in an inhibition efficiency of >90%. This effect demonstrates the applicability of chitosan coatings as carriers for corrosion inhibitors, significantly reducing the amount of inhibitor needed to achieve good anticorrosive effects.