On the problem of the purity of solvents in HPTLC

Potentiometric flow injection analysis of mebeverine hydrochloride in serum and urine

Four PVC membrane electrodes for the determination of mebeverine hydrochloride (MvCl) were fabricated and fully characterized in terms of composition, life span, usable pH range, working concentration range and temperature. The membranes of these electrodes consist of mebeverinium-silicotungstate (Mv-ST), silicomolybdate (Mv-SM), phosphotungstate (Mv-PT), or phosphomolybdate (Mv-PM) ion-associations dispersed in PVC matrix with dibutyl phthalate plasticizer. The electrodes showed near-Nernstian response over the concentration range of 4.0 x 10(-6) to 1.0 x 10(-2)M MvCl and were applied to the potentiometric determination of mebeverinium ion in pharmaceutical preparations, serum and urine in steady state and flow injection (FI) conditions with average recoveries of 96.4-102 % and relative standard deviations of 0.132-1.86%. The electrodes exhibit good selectivity for MvCl with respect to a large number of inorganic cations, organic cations, sugars and amino acids. The sensitivities of these electrodes are high enough to measure as low as 1.86 microg/ml of MvCl which permit the determination of the Ksp values of the ion-associates used. The proposed potentiometric methods offer the advantages of simplicity, accuracy, automation feasibility and applicability to turbid and colored sample solutions.

Simultaneous Determination of Mebeverine Hydrochloride and Sulpiride Using the First Derivatives of Ratio Spectra and Chemometric Methods

Two methods are described for the simultaneous determination of mebeverine hydrochloride (MB) and sulpiride (SU) in their combinations. The first method depends on the first derivative of the ratio spectra by measurement of the amplitudes at 263.7 and 234.9 nm for MB and SU, respectively. The linear ranges and detection limits are 4.0-40.0 and 0.72 microg/ml for MB and 1.0-10.0 and 0.34 microg/ml for SU. In the second case, a chemometric (classical least squares) method was developed. The concentration data matrices were obtained by using different concentrations of pure drugs in 0.1 M HCl. The absorbance data matrix corresponding to each concentration data matrix was obtained by the measurements of absorbances in the range 200-300 nm in their zero order spectra; then calibration was obtained by using the absorbance data matrix and the concentration data matrix for the prediction of the unknown concentrations of MB and SU in their mixture. The numerical values were calculated by using Matlab R12 version 6.0 and Origin 5.0 software. The procedures do not require any separation steps. These two methods were successfully applied for assaying the pharmaceutical formulation, of Colona tablets.

Application of first-derivative UV-spectrophotometry, TLC-densitometry and liquid chromatography for the simultaneous determination of mebeverine hydrochloride and sulpiride

Three methods are described for the simultaneous determination of mebeverine hydrochloride (MB) and sulpiride (SU) in combined pharmaceutical tablets. The first method depends on first-derivative ultraviolet spectrophotometry, with zero-crossing measurement method. The first derivative amplitudes at 214.2 and 221.6 nm were selected for the assay of MB and SU, respectively. Calibration graphs follow Beer's law in the range of 10-30 and 2-8 microg/ml(-1), and the linearity was satisfactory (r = 0.9999), for MB and SU, respectively. The second method was based on the application of the thin layer chromatographic separation of both drugs followed by the densitometric measurements of their spot areas. After separation on silica gel GF254 plates, using ethanol: diethyl ether: triethylamine (70:30:1 v/v) as the mobile phase, the chromatographic zones corresponding to the spots of MB and SU were scanned at 262 and 240 nm, respectively. The calibration function was established in the ranges of 4-12 microg for MB and 2-8 microg for SU. The third method was an internal standard procedure based on high performance liquid chromatographic separation of the two drugs on a reversed-phase, Bondapak CN column. The detection was done at 243 nm using buclizine hydrochloride as internal standard. All chromatographic methods showed good linearity, precision and reproducibility. No spectral or chromatographic interference from the tablet excipients were found. The proposed methods were successfully applied to the assay of commercial tablets and content uniformity test. The procedures were rapid, simple and suitable for quality control application.