Microbubble Detektion während der extrakorporalen Zirkulation

Investigation on the ability of an ultrasound bubble detector to deliver size measurements of gaseous bubbles in fluid lines by using a glass bead model

Detectors based on ultrasonic principles are today's state of the art devices to detect gaseous bubbles that may be present in extracorporeal circuits (ECC) for various reasons. Referring to theoretical considerations and other studies, it also seems possible to use this technology to measure the size of detected bubbles, thus offering the chance to evaluate their potential hazardous effect if introduced into a patient's circulation. Based on these considerations, a commercially available ultrasound bubble detector has been developed by Hatteland Instrumentering, Norway, to deliver bubble size measurements by means of supplementary software. This device consists of an ultrasound sensor that can be clamped onto the ECC tubing, and the necessary electronic equipment to amplify and rectify the received signals. It is supplemented by software that processes these signals and presents them as specific data. On the basis of our knowledge and experience with bubble detection by ultrasound technology, we believe it is particularly difficult to meet all the requirements for size measurements, especially if these are to be achieved by using a mathematical procedure rather than exact devices. Therefore, we tried to evaluate the quality of the offered bubble detector in measuring bubble sizes. After establishing a standardized test stand, including a roller pump and a temperature sensor, we performed several sets of experiments using the manufacturers software and a program specifically designed at our department for this purpose. The first set revealed that the manufacturer's recommended calibration material did not meet essential requirements as established by other authors. Having solved that problem, we could actually demonstrate that the ultrasonic field, as generated by the bubble detector, has been correctly calculated by the manufacturer. Simply, it is a field having the strongest reflecting region in the center, subsequently losing strength toward the ECC tubing's edge. The following set of experiments revealed that the supplementary software not only does not compensate for the ultrasonic field's inhomogeneity, but, furthermore, delivers results that are inappropriate to the applied calibration material. In the last set of experiments, we were able to demonstrate that the signals as recorded by the bubble detector heavily depend upon the circulating fluid's temperature, a fact that the manufacturer does not address. Therefore, it seems impossible to resolve all these sensor related problems by ever-increasing mathematical intervention. We believe it is more appropriate to develop a new kind of ultrasound device, free of these shortcomings. This seems to be particularly useful, because the problem of determining the size of gaseous bubbles in ECC is not yet solved.

Significant reduction of air microbubbles with the dynamic bubble trap during cardiopulmonary bypass

Air microbubbles mostly occur unnoticed during cardiopulmonary bypass and are predominantly responsible for serious postoperative psychoneurological dysfunction. A dynamic bubble trap (DBT), which removes air microbubbles from the arterial blood, was tested in a clinical study. The aim was to evaluate the efficiency of microbubble removal under clinical conditions. As blood passes through the DBT, which is placed in the arterial line between the arterial filter and arterial cannula, it is converted into a rotating stream. The bubbles are directed to the centre of the blood flow and are collected in the distal end of the DBT, from where they are returned to the cardiotomy reservoir. Doppler ultrasonography was used to detect the microbubbles before and after the DBT, and also the number of high-intensity transient signals (HITS) in the right and left middle cerebral artery during extracorporeal circulation. A significant reduction of microbubbles in the arterial line (3,990 before DBT, 537 after, p < 0.001) and HITS in the brain (51 in the DBT group, 77 in the placebo group, p = 0.04) was measured.

Reduced release of tissue factor by application of a centrifugal pump during cardiopulmonary bypass

The application of a centrifugal pump might lead to a reduced release of tissue factor (TF) due to less blood cell damage. This could result in a decrease in activation of the extrinsic pathway of coagulation and embolus formation. In the present study, 60 patients undergoing coronary artery bypass grafting were randomly assigned to a centrifugal or a roller pump. Plasma concentrations of TF, thrombin-antithrombin complex (TAT), and prothrombin fragments F1 + 2 were investigated before, during, and after cardiopulmonary bypass (CPB). Embolus detection was performed at the arterial line of CPB and transcranially by Doppler ultrasound. The centrifugal pump group revealed a lower TF release (area under the curve during CPB) when compared with the roller pump group [5661 (696-10359) vs 12681 (6383-17538) microg x min/l; median (lower - upper quartiles); P = 0.009]. In contrast, TAT and F1 + 2 formation did not differ between the groups, and neither did the total embolus count of both Doppler systems. Embolus counts did not correlate with TAT or F1 + 2 formation. In conclusion, the reduction in TF release by the application of a centrifugal pump seems to have little consequence on total thrombin formation. Since the applied Doppler systems seem to detect mainly microbubbles, conclusions regarding differences between the two pumps in the formation of thrombofibrinous clots cannot be drawn.