Joint distraction force changes the three-dimensional articulation of the femur and tibia in total knee arthroplasty: a cadaveric study

Ligament Tension and Balance before and after Robotic-Assisted Total Knee Arthroplasty - Dynamic Changes with Increasing Applied Force

The optimal force applied during ligament balancing in total knee arthroplasty (TKA) is not well understood. We quantified the effect of increasing distraction force on medial and lateral gaps throughout the range of knee motion, both prior to and after femoral resections in tibial-first gap-balancing TKA. Twenty-five consecutive knees in 21 patients underwent robotic-assisted TKA. The posterior cruciate ligament was resected, and the tibia was cut neutral to the mechanical axis. A digital ligament tensioning tool recorded gaps and applied equal mediolateral loads of 70 N (baseline), 90 N, and 110 N from 90 degrees to full extension. A gap-balancing algorithm planned the femoral implant position to achieve a balanced knee throughout flexion. After femoral resections, gap measurements were repeated under the same conditions. Paired t-tests identified gap differences between load levels, medial/lateral compartments, and flexion angle. Gaps increased from 0 to 20 degrees in flexion, then remain consistent through 90 degrees of flexion. Baseline medial gap was significantly smaller than lateral gap throughout flexion (p <0.05). Increasing load had a larger effect on the lateral versus medial gaps (p <0.05) and on flexion versus extension gaps. Increasing distraction force resulted in non-linear and asymmetric gap changes mediolaterally and from flexion to extension. Digital ligament tensioning devices can give better understanding of the relationship between joint distraction, ligament tension, and knee stiffness throughout the range of flexion. This can aid in informed surgical decision making and optimal soft tissue tensioning during TKA.

Posterior cruciate ligament resection under minimum medial collateral ligament release changes tibial internal rotation, joint center gap, and varus ligament balance on joint distraction force at flexion in total knee arthroplasty

BACKGROUND

The purpose of this study was to assess the effect of posterior cruciate ligament resection under minimum medial collateral ligament release on the joint center gap, varus ligament balance, and the rotational change of the femur and tibia.

METHODS

This study included 75 knees with varus osteoarthritis that underwent total knee arthroplasty. After minimum medial collateral ligament releases and bone resection of the distal femur and proximal tibia, the joint center gap and varus ligament balance were measured before and after posterior cruciate ligament resection using a digital tensor with a joint distraction force of 89, 133, 178 N. The rotational changes under a distraction force of 200 N were captured using a navigation system.

FINDINGS

The joint center gap and varus ligament balance at 90° and 120° of flexion significantly increased after posterior cruciate ligament resection with distraction forces of 89 N (90°: 0.4 mm / 0.9° and 120°: 0.5 mm / 0.8°), 133 N (90°: 0.9 mm / 1.3° and 120°: 0.9 mm / 1.1°), 178 N (90°: 1.5 mm / 1.9° and 120°: 1.5 mm / 1.5°). Tibial internal rotation significantly increased after posterior cruciate ligament resection at 90° (1.9°) and 120° (2.2°).

INTERPRETATION

Joint distraction forces after posterior cruciate ligament resection increased the tibial internal rotation, joint center gap, and varus ligament balance at flexion. These findings indicate that posterior cruciate ligament resection should increase the lateral gap more than the medial gap due to tibial internal rotation at flexion. (245 words).