Using thermodesorption-GC/cryocondensation-FT-IR for the measurement of biogenic VOC emissions

Degradation of alpha-pinene on Tenax during sample storage: effects of daylight radiation and temperature

The behavior of alpha-pinene sampled on adsorption cartridges filled with Tenax TA has been investigated in relation to different storage conditions, focusing on daylight radiation and temperature. After sampling, the respective cartridges containing the terpene were placed in sunlight on the windowsill for up to 1 month. Corresponding samples have been wrapped in aluminum foil to prevent the influence of daylight radiation. Additional sample cartridges with alpha-pinene were stored in the refrigerator at 4 degrees C and a freezer at -18 degrees C. All cartridges were analyzed using thermodesorption injection onto a gas chromatograph, and the compounds were detected using either a cryocondensation-interface to a Fourier transform infrared-spectrometer (GC/FT-IR) or the flame ionization detector (FID). In summary, 12 compounds were detected and identified, from which eight were products that were formed on Tenax through different mechanisms. Two compounds seemed to be formed under the influence of daylight radiation, while the others appear to be mainly autoxidation products. Estimates after 1 month of storage showed recoveries of over 99% for wrapped samples, while for unwrapped cartridges only about 88% of alpha-pinene was found. A pattern of up to five compounds was found that can be used as an indicator for storage reactions.

Application of gas chromatography-cryocondensation-Fourier transform infrared spectroscopy and gas chromatography-mass spectrometry to the identification of gas phase reaction products from the alpha-pinene/ozone reaction

The gas phase reaction of alpha-pinene with the atmospheric oxidant ozone was investigated by using the capabilities of both gas chromatography-cryocondensation-Fourier transform infrared spectroscopy (GC-FT-IR) and gas chromatography-mass spectrometry (GC-MS), for the identification of the reaction products formed. The reaction was carried out in a flow reaction chamber from where the compounds were sampled on Tenax-containing adsorption cartridges. The reaction mixture was injected onto the column after thermodesorption and analyzed using both GC-IR and GC-MS. Twenty compounds could be detected, including the reactant alpha-pinene and it's impurities tricyclene and camphene. Eleven compounds were identified by spectra comparison with either reference data or spectra obtained from commercial standards. Four compounds were tentatively identified from their IR and MS spectra, while from the remaining two compounds the nature of basic functional groups could be established.