Trehalose-Induced Variation in Mechanical Properties of Vesicles in Aqueous Solution

Mechanical Properties of 3-Hydroxybutyric Acid-Induced Vesicles

The vesicle mechanical behaviors were studied upon its exposure to 3-hydroxybutyric acid using an atomic force microscope (AFM). Dipalmitoylphosphatidylcholine (DPPC) and 3-hydroxybutyric acid were used to manufacture the vesicles at their desired ratio. The deflection of an AFM probe with respect to its displacement was measured after characterizing the vesicle adsorption. The movement was analyzed with the Hertzian model to understand the physical behavior of the vesicles. However, in the deflection just prior to the first penetration, the model was a good fit, and the vesicle mechanical moduli were calculated. The moduli became lower with the higher ratio of 3-hydroxybutyric acid to DPPC, but the moduli were saturated at 0.5 of the ratio. These results appear to be the basis for the function of the metabolism associated with 3-hydroxybutyric acid, i.e., anesthetization and glycemic control, on the physical properties of cell membranes.

Changes in Mechanical Properties of Vesicles by Mucin in Aqueous Solution

The mechanical properties of vesicles were investigated as they were prepared, according to the ratio of mucin to dipalmitoylphosphatidylcholine (DPPC), using an atomic force microscope (AFM). After the confirmation of the vesicle adsorption on a mica surface, an AFM-tip deflection, caused by the interaction between the tip and the vesicle, was measured. The deflection showed that the tip broke through into the vesicle twice. Each break meant a tip-penetration into the upper and lower portion of the vesicle. Only the first penetration allowed the Hertzian model available to estimate the vesicle mechanical moduli. Two moduli reduced as the ratio of mucin to DPPC increased to 0.5, but the moduli were little changed above the 0.5 ratio. These results seem to be a platform for the effect of the mucin on the plasma-membrane anchoring and cellular signaling.

Ectoine Effect on Mechanical Properties of Vesicles in Aqueous Solution

The mechanical properties of the vesicles incorporated with ectoine were studied using atomic force microscope (AFM). The vesicles were prepared with dipalmitoylphosphatidylcholine (DPPC) by changing only the ratio of the ectoine to DPPC. After the vesicles were adsorbed on the mica substrate and their morphology were characterized, the plot of an AFM tip displacement versus the tip deflection was acquired by monitoring the behavior of the tip into the vesicle. The breakthrough of the tip into the vesicle was observed to occur twice. Each breakthrough represented a penetration of the tip into the top and bottom portions of the vesicle, respectively. The force data between the pre-contact and the first breakthrough were comparable with the Hertzian model to estimate Young's modulus and the bending modulus of the vesicles. Both moduli decreased proportionally with the increase in the ratio of ectoine to lipid up to 0.5. However, above 0.5, the moduli were slightly changed with the increase. These results of the mechanical properties appear to be due to the osmotic and volumetric effect on the headgroup packing disruption.