Analysis of leukocyte binding to depletion filters: role of passive binding, interaction with platelets, and plasma components

Comparative study of quality of leukoreduced packed red blood cell units as assessed by nageotte hemocytometry and flow cytometry

PURPOSE

Assessment of residual white blood cell (rWBC) count is vital to ascertain the quality of leukodepleted (LD) blood components. Automated cell analyzers lack the sensitivity for the assessment of very few leukocytes as found in LD blood components. Flow Cytometry (FC) based methods and Nageotte hemocytometer are the most commonly used techniques for this purpose. The objective of this study was to compare the use of Nageotte hemocytometer and FC for quality control of LD red blood cell units.

MATERIALS AND METHODS

A prospective, observational study was conducted in the Department of Immunohematology and Blood Transfusion of a tertiary care center from September 2018 to September 2020. About 303 LD-packed red blood cell units were tested by FC and Nageotte hemocytometer for rWBCs.

RESULTS

The number of rWBC (mean) detected by flow cytometer and Nageotte's hemocytometer was 1.06 ± 0.43 white blood cell (WBC)/μL and 0.67 ± 0.39 WBC/μL, respectively. Coefficient of variation was 58.37% by Nageotte hemocytometer method and 40.46% by FC. Linear regression analysis did not show any correlation (R2= 0.098, P = 0.001) whereas Pearson's correlation coefficient showed a weak relation (r = 0.31) between the two methods.

CONCLUSION

Flow cytometric technique provides a more precise and accurate objective tool compared to Nageotte hemocytometer which is labor intensive, time consuming, and prone to errors arising out of subjectivity along with reported underestimation bias. In the absence of adequate infrastructure, resources, and trained workforce, Nageotte hemocytometer method is a reliable alternative. Nageotte's chamber could be best used in the resource-constrained setup as it offers a relatively inexpensive, simple, and viable means to enumerate rWBCs.

In-line Leukoreduction Filters; a New Source of Microparticle for Human and Animal Study

INTRODUCTION

The isolation of microparticles (MPs) from leukoreduction filters (LRFs) during cell extraction process introduced LRFs as a precious source of MPs for animal and human study.

METHOD

LRFs were collected from Tehran Blood Transfusion Center. The back-flushing method was used for leukocyte extraction from the LRFs. MPs were isolated through double-step centrifugation. Dynamic light scattering (DLS), electron microscopy (EM), and flow cytometry were performed for the evaluation of MPs size, morphology, and structural properties respectively. Statistical analyses were carried out to evaluation of differences between test and control groups. a p-value less than 0.05 indicates significant differences.

RESULT

DLS analysis showed that the average MP size in the test and control groups was 654.83 nm and 233.68 nm respectively. SEM images showed the spherical, oval, cell fragment, and micro-aggregate particles and TEM images demonstrated the mitochondrial-like body in the MPs. Flow cytometry studies also showed a significant increase in the percent of CD41, and CD14, and a significant decrease in the percent of CD235a in the test group compared to control (P value=0.029, P value=0.035, P value= 0.001 respectively). Moreover, the percentage of CD34 MPs indicated a borderline difference between the two groups (P value= 0.075). Finally count of MPs in the test and control groups was 1202095.34 and 280948.64, respectively and the difference was significant (P value=0.008).

CONCLUSION

It is concluded that LRFs are a potential source of the large volume of various cell MPs with different phenotypical and structural properties for animal and human phase studies. Moreover, the investigation of LRFs as a source of different types of exosomes can shed new light on extracellular vesicle studies.

Effect of membrane parameters and filter structure on the efficiency of leukocyte removal by electrospun poly(ethylene-co-vinyl alcohol) membranes

Electrospinning technology is an experimentally verified tool for the generation of membranes with competing efficiency useful for leukodepletion filter, customarily used in blood banks to lessen the risks with blood transfusions. Even though a few electrospun polymers have been reported to be efficient leukodepletion filter membranes, poly(ethylene-co-vinyl alcohol) (EVAL) being one among, owe to their exceptional advantage of being electrospun from a non-toxic solvent like rubbing alcohol. Besides their excellent blood compatibility, EVAL membranes proffer a leukodepletion performance nearly as same as that of commercial leukodepletion filters. However, the role of various membrane parameters on the leukodepletion efficiency of electrospun EVAL membranes need to be disclosed in advance to their commercialization. Hence this study is an attempt to disclose the ability of electrospinning to being tuned towards the fabrication of filters with different membrane parameters including fiber diameter and pore diameter, with a typical example of EVAL. In addition, the impact of filter design upon the leukodepletion performance was also unveiled by comparing a symmetric filter where all the membranes were of uniform pores with that of an asymmetric filter where the pore sizes of upper and lower layer in the filter was different. The results of blood filtration experiments through the developed prototype filters underline the superiority of asymmetric filters over to symmetric one and, the asymmetric filters wherever the fiber diameter was 1.8 and 3 μm, offered rapid and excellent leukodepletion. Membranes with thinner fibers showed an increased flow resistance. The pore sizes of the membranes being 9 - 29 μm, larger than the size of blood cells, alludes to the direct adhesion of leukocytes to filter membranes as the major mechanism of leukocyte removal. Hence it is concluded that despite the suitability of electrospinning for fabrication of leukodepletion filter media, the use of nano-dimension fibers is not preferred for leukocyte adhesion filter when the material of choice is such a polymer with ideal surface chemistry, wettability and inherent ability for leukocyte binding.

TCR-mediated functions are enhanced in activated peripheral blood T cells isolated from leucocyte reduction systems

Buffy coats are the most common method for the acquisition of activated primary human T cells for research or clinical applications, but recently leukocyte reduction system (LRS) cones have emerged as a viable source for these cells. In this study, we determined if activated human T cells derived from buffy coats or LRS cones had different functionality. No changes in the expression of surface receptors were observed except for a significant increase in CD44 expression on T cells isolated from LRS cones. LRS cone-derived T cells trended towards higher receptor-mediated cytokine production and had significantly increased donor-to-donor variability in IFN-γ production. TCR-induced ERK1/ERK2 and AKT phosphorylation was also increased in T cells isolated from LRS cones. In conclusion, LRS cones are an excellent source of T cells for clinical and research applications, but these cells have subtle functional differences from T cells isolated using standard buffy coats.

Leukocyte depletion for safe blood transfusion

Leukocytes have ability to distinguish between self cells (body own cells) and foreign (allogenic) cells on the basis of human leukocyte antigen (HLA) proteins that are present on the cell membrane and are effectively unique to a person. During allogenic blood transfusion a person receives large number of allogenic donor leukocytes and these are recognized as foreign cells by the recipient immune system which leads to several adverse reactions. To avoid such leukocyte-mediated adverse reactions leukodepleted blood transfusion is required. Leukocytes can be separated on the basis of size, dielectric properties, by affinity separation, freeze-thawing and centrifugation but all these methods are time consuming and costly. Filtration is another method for leukocyte depletion that is comparatively less expensive and more efficient as it gives more than 90% leukodepletion of blood along with minimal cell loss. However, present filtration procedures also have some limitations as they work efficiently with blood components but not with whole blood and show non-specific adhesion of large number of platelets and red blood cells along with leukocytes. All the currently available filters are costly, which has been a major reason for their limited application. Therefore, demand for a more efficient and cost-effective filter is high in medical community and scientists are attenpting to improve the efficiency of currently available filters. The present review gives an overview of the significance of leukodepleted blood transfusion and focuses on different methods for leukocyte depletion and challenges involved in all these technologies.

Storage duration and white blood cell content of red blood cell (RBC) products increases adhesion of stored RBCs to endothelium under flow conditions

BACKGROUND

Adherence of red blood cells (RBCs) to vascular endothelium impairs blood flow and decreases oxygen delivery. Although RBCs may be stored for up to 42 days before transfusion under current blood banking guidelines, little is known of how changes to RBCs during storage may affect their adherence properties. The influence of RBC product storage time and white blood cell (WBC) burden on the adherence of RBCs for transfusion to vascular endothelium under conditions of continuous flow was investigated in this study.

STUDY DESIGN AND METHODS

RBC samples were collected from nonleukoreduced (S-RBC), buffy coat-poor (BCP-RBC), and leukofiltered (LF-RBC) products at fixed time points during storage. Samples were perfused, at controlled shear stress and temperature, across a confluent endothelial cell (EC) monolayer with a parallel-flow chamber mounted to an inverted microscope. RBC-EC interactions were recorded with a digital camera attached to the microscope.

RESULTS

The number of RBCs adhering to the EC layer increased significantly with storage time in all RBC products; however, WBC reduction delayed this increase. LF-RBCs were also significantly less adherent than S-RBC or BCP-RBC products on Day 1 of storage (p < 0.05). The strength of RBC attachment to vascular endothelium was significantly stronger in S-RBC products compared to BCP-RBC and LF-RBC products.

CONCLUSION

Our findings indicate that product storage time and WBC burden increase the number and strength of adhesion of RBCs to vascular endothelium. These results may lead to greater understanding of the interaction of transfused RBCs with recipient endothelium and the biologic consequences of this adherence.