Associations with subregional BMD-measurements in patients with rheumatoid arthritis. Rheumatol Int. 2008;29:47-51. [PMID: 18597090 DOI: 10.1007/s00296-008-0638-0]

Hand bone mass in rheumatoid arthritis: A review of the literature

Rheumatoid arthritis (RA) is a common chronic inflammatory disease and periarticular osteoporosis or osteopenia of the inflamed hand joints is an early feature of RA. Quantitative measurement of hand bone loss may be an outcome measure for the detection of joint destruction and disease progression in early RA. This systematic review examines the published literature reporting hand bone mass in patients with RA, particularly those using the dual X-ray absorptiometry (DXA) methods. The majority of the studies reported that hand bone loss is associated with disease activity, functional status and radiological progression in early RA. Quantitative measurement of hand bone mineral density by DXA may be a useful and practical outcome measure in RA and may be predictive for radiographic progression or functional status in patients with early RA.

Periarticular bone gain at proximal interphalangeal joints and changes in bone turnover markers in response to tumor necrosis factor inhibitors in rheumatoid and psoriatic arthritis

OBJECTIVE

Rheumatoid arthritis (RA) and psoriatic arthritis (PsA) are characterized by periarticular bone erosion; periarticular bone formation is a feature in PsA. The effect of anti-tumor necrosis factor-α (TNF-α) on periarticular bone remodeling is unclear in both diseases. Our aim was to assess the response of bone turnover markers (BTM) and hand bone mineral density (BMD) to anti-TNF over 3 years in RA and PsA.

METHODS

We measured serum bone-specific alkaline phosphatase (bone ALP), procollagen type-I N-propeptide (PINP), intact osteocalcin, C-terminal cross-linking telopeptides (CTX-I), urinary N-terminal cross-linking telopeptide of type-I collagen (NTX-I), and free deoxypyridinoline crosslinks (fDPD) at baseline, 1, 12, and 36 months. BMD measurements (hands/spine/hip) were obtained at 3 timepoints.

RESULTS

We recruited 62 patients (RA 35; PsA 27). BTM correlated significantly with hand BMD but not with central BMD. Low hand BMD was associated with RA and increased BTM. Following anti-TNF therapy, hip BMD declined while spine and hand BMD were unchanged. Periarticular BMD at proximal interphalangeal (PIP) joints increased while it decreased at metacarpophalangeal joints. Bone ALP increased steadily and was always higher in PsA. PINP and intact osteocalcin increased to a lesser extent, but resorption markers did not change.

CONCLUSION

At baseline, hand BMD was inversely associated with BTM. Bone formation rather than resorption markers better showed the bone response to anti-TNF. Despite a lack of effect on central BMD, the modest effect of anti-TNF on PIP BMD may provide evidence that BTM reflect specifically bone remodeling activity at periarticular sites of inflammation in RA and PsA.

Development of a technique for cement augmentation of nailed tibiotalocalcaneal arthrodesis constructs

BACKGROUND

Tibiotalocalcaneal arthrodesis with a retrograde nail is an established procedure. Many patients considered for this arthrodesis have poor bone stock, which may make it difficult to obtain construct stability. This study was undertaken to determine whether stability could be enhanced by the cement augmentation of the calcaneal locking screws.

METHODS

A cannulated and perforated screw, and a technique for cement augmentation via this screw, were developed. Eight pairs of human cadaver bones were instrumented with a retrograde intramedullary device (Expert Hindfoot Arthrodesis Nail, Synthes AG, Solothurn, Switzerland). Within each pair, one specimen was randomized to have the nail interlocked in the calcaneus with two conventional screws; while the other specimen was similarly instrumented with the use of two cement-augmented screws. The bone mineral density was determined. In quasi-static tests, the neutral zone and the range of motion of the constructs were determined. Subsequently the specimens were tested in dorsiflexion/plantar flexion until failure occurred. The neutral zone and the range of motion of the constructs were determined every 200 cycles.

FINDINGS

Augmentation resulted in significantly greater stiffness and a significantly smaller range of motion in the quasi-static dorsiflexion/plantar flexion test, and in a significantly smaller neutral zone in all quasi-static tests. With cyclic loading, the number of cycles to failure was significantly larger in the augmented group. In both groups, bone mineral density was significantly correlated with the number of cycles to failure. Two augmented screws broke.

INTERPRETATION

Cement augmentation confers significant mechanical benefit in hindfoot arthrodesis and therefore can be used as a salvage procedure. Further development should be performed to validate the concept.

Intraoperative mechanical bone strength determination in tibiotalocalcaneal fusion: a biomechanical investigation

BACKGROUND

Bone strength is currently measured with indirect techniques. We investigated the use of an intraoperative mechanical measurement for local bone strength determination and prediction of intramedullary-nail fusion failure. We investigated whether intraoperative local bone strength determination may be useful to the surgeon in predicting intramedullary nail hindfoot fusion performance.

MATERIALS AND METHODS

In seven human specimens, bone mineral density (BMD) was determined with qCT. A device (DensiProbe) specially devised for nailed tibiotalocalcaneal arthrodesis (TTCA) was inserted at the intended calcaneal screw sites of an intramedullary nail, and the cancellous break-away torque was measured. The constructs were then cyclically loaded to failure in dorsiflexion-plantarfexion.

RESULTS

The BMD range was wide (42.8 to 185.9 mg HA/cm(3)). The proximal-screw site peak torque was 0.47 to 1.61 Nm; distal-screw site peak torque was 0.24 to 1.06 Nm. The number of cycles to failure correlated with peak torque both proximally (p = 0.021; r(2) = 0.69) and distally (p = 0.001; r(2) = 0.92). Proximally, peak torque did not correlate with BMD (p = 0.060; r(2) = 0.54); distally, it correlated significantly (p = 0.003; r(2) = 0.86).

CONCLUSION

DensiProbe measurements can be used in the hindfoot to assess bone strength. In this study, specimens that failed early could be identified. However, in clinical practice fusion failure is multifactorial in origin, and failure prediction cannot be based upon peak torque measurements alone.

CLINICAL RELEVANCE

The technique described here may be of use to give an intraoperative decision aid to predict intramedullary nail hindfoot fusion performance.