Rheology of thermo-gelling capillary suspensions

How bulk liquid viscosity shapes capillary suspensions

HYPOTHESIS

Capillary suspensions offer a new approach to generate novel materials. They are ternary liquid-liquid-solid systems characterized by particles connected by liquid bridges of one fluid suspended in a second immiscible bulk fluid. The viscosity of the bulk liquid can be modulated to customize the structure and rheological properties of capillary suspensions. Experiments and simulations: Using experiments and numerical simulations, we investigated capillary suspensions in the pendular state, using silica particles and water as a bridging liquid. To modulate the viscosity of the bulk fluid, we use different ratios of either dodecane and diisononyl phthalate, or silicone oils with varying chain lengths as bulk liquids. The rheological behavior was characterized using the maximum storage and loss moduli and the yielding behavior. This was related to structural changes of the systems, which was visualized using confocal laser scanning microscopy. In addition, we used Molecular Dynamics (MD) simulations to gain more insights into the behavior of two particles connected by a liquid bridge for various bulk liquids.

FINDINGS

Experiments show that higher bulk liquid viscosity reduces strength, yield stress, and yield strain in capillary suspensions, which is partly attributed to a reduced inter-connectivity of the percolating network. This is caused by the breakup of liquid bridges occurring at shorter distances in the presence of highly viscous bulk liquids, as indicated by numerical simulations.

Rheological implications of pH induced particle-particle association in aqueous suspension of an anisotropic charged clay

Kaolinite particles are geometrically anisometric and electrostatically anisotropic. Until recently, the charge of both basal faces of kaolinite was assumed to be independent of pH, and the isoelectric point (IEP) of the edge surface was thought to occur at pH 4-6. Therefore, kaolinite suspensions were expected to have an edge-face association at low pH. However, recent atomic force microscopy (AFM) studies have shown that the kaolinite alumina basal face and edge surface carry a pH-dependent surface charge with an IEP at pH 5-6 and ∼ 3, respectively. Here, we revisit the modes of particle association in kaolinite suspensions and apply Derjaguin-Landau-Verwey-Overbeek (DLVO) theory to study the rheological implications of surface charges of various kaolinite faces from recent AFM-based studies. Specifically, aging within the linear viscoelastic region, small amplitude oscillatory shear behavior (strain amplitude and frequency response), and critical stress behavior were studied as a function of pH. Kaolinite suspensions (40 wt%) exhibited two-step structure recovery after shear rejuvenation and two-step yielding at pH less than the IEP of the alumina basal face. In addition, the storage modulus (G') and critical stress required to stabilize the flow followed non-monotonic behavior as a function of pH. At low pH, the silica face-alumina face mode of association was expected to be dominant rather than the edge-face microstructure. A peak in the G'vs. pH curve at pH 4.5-5 was correlated with the silica face-alumina face attraction estimated from DLVO theory, which passes through a maximum at approximately the same pH. Based on these observations, we propose a qualitative state diagram for kaolinite suspensions in the pH-concentration space.