Lipid production by Cryptococcus albidus using biowastes hydrolysed by indigenous microbes

Controlling the Formation of Foams in Broth to Promote the Co-Production of Microbial Oil and Exopolysaccharide in Fed-Batch Fermentation

A large amount of foam is generated in the production of microbial oil and exopolysaccharide (EPS) by Sporidiobolus pararoseus JD-2, which causes low efficiency in fermentation. In this study, we aimed to reduce the negative effects of foams on the co-production of oil and EPS by controlling the formation of foams in broth. As we have found, the formation of foams is positively associated with cell growth state, air entrapment, and properties of broth. The efficient foam-control method of adding 0.03% (v/v) of the emulsified polyoxyethylene polyoxypropylene pentaerythritol ether (PPE) and feeding corn steep liquor (CSL) at 8–24 h with speed of 0.02 L/h considerably improved the fermentation performance of S. pararoseus JD-2, and significantly increased the oil and EPS concentrations by 8.7% and 12.9%, respectively. The biomass, oil, and EPS concentrations were further increased using a foam backflow device combined with adding 0.03% (v/v) of the emulsified PPE and feeding CSL at 8–24 h, which reached to 62.3 ± 1.8 g/L, 31.2 ± 0.8 g/L, and 10.9 ± 0.4 g/L, respectively. The effective strategy for controlling the formation of foams in fermentation broth reported here could be used as a technical reference for producing frothing products in fed-batch fermentation.

A bioreactor and nutrient balancing approach for the conversion of solid organic fertilizers to liquid nitrate-rich fertilizers: Mineralization and nitrification performance complemented with economic aspects

Due to the high water- and nutrient-use efficiency, hydroponic cultivation is increasingly vital in progressing to environment-friendly food production. To further alleviate the environmental impacts of synthetic fertilizer production, the use of recovered nutrients should be encouraged in horticulture and agriculture at large. Solid organic fertilizers can largely contribute to this, yet their physical and chemical nature impedes application in hydroponics. This study proposes a bioreactor for mineralization and nitrification followed by a supplementation step for limiting macronutrients to produce nitrate-based solutions from solid fertilizers, here based on a novel microbial fertilizer. Batch tests showed that aerobic conversions at 35 °C could realize a nitrate (NO₃^--N) production efficiency above 90% and a maximum rate of 59 mg N L^-1 d^-1. In the subsequent bioreactor test, nitrate production efficiencies were lower (44-51%), yet rates were higher (175-212 mg N L^-1 d^-1). Calcium and magnesium hydroxide were compared to control the bioreactor pH at 6.0 ± 0.2, while also providing macronutrients for plant production. A mass balance estimation to mimic the Hoagland nutrient solution showed that 92.7% of the NO₃^--N in the Ca(OH)₂ scenario could be organically sourced, while this was only 37.4% in the Mg(OH)₂ scenario. Besides, carbon dioxide (CO₂) generated in the bioreactor can be used for greenhouse carbon fertilization to save operational expenditure (OPEX). An estimation of the total OPEX showed that the production of a nutrient solution from solid organic fertilizers can be cost competitive compared to using commercially available liquid inorganic fertilizer solutions.

Volatile Fatty Acids from Lipid-Extracted Yeast Provide Additional Feedstock for Microbial Lipid Production

Microbial lipid production from oleaginous yeasts is a promising process for the sustainable development of the microbial biodiesel industry. However, the feedstock cost poses an economic problem for the production of microbial biodiesel. After lipid extraction, yeast biomass can be used as an organic source for microbial biodiesel production. In this study, volatile fatty acids (VFAs), produced via anaerobic digestion of a lipid-extracted yeast (LEY) residue, were utilized as a carbon source for the yeast Cryptococcus curvatus. The response surface methodology was used to determine the initial pH and inoculum volume for the optimal VFA production. The experimental result for VFA concentration was 4.51 g/L at an initial pH of 9 and an inoculation 25%. The optimization results from the response surface methodology showed that the maximal VFA concentration was 4.58 g/L at an initial pH of 8.40 and an inoculation of 39.49%. This study indicates that VFAs from LEY can be used as a carbon source for microbial biodiesel production, with the potential to significantly reduce feedstock costs.

Biodiesel Production From Lignocellulosic Biomass Using Oleaginous Microbes: Prospects for Integrated Biofuel Production

Biodiesel is an eco-friendly, renewable, and potential liquid biofuel mitigating greenhouse gas emissions. Biodiesel has been produced initially from vegetable oils, non-edible oils, and waste oils. However, these feedstocks have several disadvantages such as requirement of land and labor and remain expensive. Similarly, in reference to waste oils, the feedstock content is succinct in supply and unable to meet the demand. Recent studies demonstrated utilization of lignocellulosic substrates for biodiesel production using oleaginous microorganisms. These microbes accumulate higher lipid content under stress conditions, whose lipid composition is similar to vegetable oils. In this paper, feedstocks used for biodiesel production such as vegetable oils, non-edible oils, oleaginous microalgae, fungi, yeast, and bacteria have been illustrated. Thereafter, steps enumerated in biodiesel production from lignocellulosic substrates through pretreatment, saccharification and oleaginous microbe-mediated fermentation, lipid extraction, transesterification, and purification of biodiesel are discussed. Besides, the importance of metabolic engineering in ensuring biofuels and biorefinery and a brief note on integration of liquid biofuels have been included that have significant importance in terms of circular economy aspects.

Comparative study of lipid production from cellulosic ethanol fermentation wastewaters by four oleaginous yeasts

The biochemical treatment of cellulosic ethanol wastewater (CEW) is considered to be an ideal green process. To screen out the best oleaginous yeastfor the utilization of cellulosic ethanol wastewater, four oleaginous yeasts (Trichosporon cutaneum, Rhorosporidium toruloides, Cryptococcus albidus and T. coremiiforme) were compared to assess their abilities for lipid production in terms of biomass production, lipid content and lipid yield. Furthermore, thechemical oxygen demand (COD) conversion rate, COD degradation and fatty acid composition were calculated to analyze the effect of wastewaters treatment. According to the fermentation results, the highest biomass and lipid yield of T. cutaneum in CEW were 20.945 and 1.56 g/L, respectively, while the R. toruloides reached the highest lipid content (17.32%). The maximum conversion rates of T. cutaneum are 73.64 and 6.06%, respectively, in terms of conversion yield of biomass/COD and lipids/COD. The content of fatty acids showed that after six days' fermentation, T. coremiiforme obtained the highest unsaturated fatty acid content, the content of C18:1 and C18:2 was 57.64%. This study suggests that T. cutaneum has great potential for lipid production and wastewaters treatment from cellulosic ethanol fermentation.