A colorimetric probe based on 4-mercaptophenol and thioglycolic acid-functionalized gold nanoparticles for determination of phytic acid and Fe(III) ions

Microflow injection analysis based on modular 3D platforms and colorimetric detection for Fe(III) monitoring in a wide concentration range

A modular microflow injection analysis (microFIA) system for the determination of Fe(III) in a bioleaching reactor has been designed, developed and validated. The different modules of the analyzer (mixer, diluter, disperser and detector) were 3D-printed. Fe(III) quantification is due by measuring the color intensity of the chelate formed between Fe(III) and salicylic acid at 525 nm. The device has been designed to dilute, disperse and detect high Fe(III) concentrations in the form of an inexpensive multi-step photometric flow cell that uses an light-emitting diode (LED) as a light source and an light-dependent resistor (LDR) as a light intensity detector. This microFIA system has been shown to be suitable for automatic and continuous determination of Fe(III) in the operation of a bioreactor for the oxidation of Fe(II). The device has a good repeatability (less than 5% of coefficient of variation in the whole range of concentrations) and accuracy of around 100%. The analyzer features an exceptional wide linear range, between 25 and 6000 mg·L-1. The device was successfully applied to the determination of Fe(III) in real samples. The obtained results proved that the method is applicable for accurate, precise, rapid, and low-cost colorimetric analysis and didn't show significant differences with a conventional UV-Vis method.

Sulfur Centered Hydrogen Bonding in Thioglycolic Acid and Its Clusters: A Computational Exploration

The conformational landscape of thioglycolic acid (TGA) was investigated by using the CCSD/cc-pVTZ level of theory. The GGC conformer was identified as the global minimum, followed by the GAC conformer. The calculated rotational constant for the GGC conformer exhibited good agreement with the previously reported experimental results. Subsequently, the study delved into the exploration of sulfur-centered hydrogen bonding in TGA's dimer and trimer clusters, employing the CCSD/cc-pVDZ level of theory. These clusters revealed the participation of both oxygen and sulfur atoms in noncovalent H-bonding, contributing to their stability. The presence of these noncovalent interactions in TGA clusters was elucidated through Atoms in Molecule (AIM), reduced density gradient (RDG), and natural bond order (NBO) analysis, while electrostatic potential (ESP) charge and vibrational mode analysis further supported these findings.

Antibacterial and Antibiofilm Activity of Mercaptophenol Functionalized-Gold Nanorods Against a Clinical Isolate of Methicillin-Resistant Staphylococcus aureus

Gold nanorods (AuNRs) were synthesized by the seed-mediated wet chemical method using a binary surfactant system. AuNRs were stabilized with polyethylene glycol, then functionalized with 4-mercaptophenol (4-MPH) ligand by surface ligand exchange. The surface-functionalized AuNRs (4-MPH-AuNRs) exhibited a typical UV–vis spectrum of AuNRs with a slightly shifted longitudinal peak. Furthermore, 4-MPH-AuNRs demonstrated a similar Fourier-Transformed Infrared spectrum to 4-MPH and a fading of the thiol band, which suggests a successful functionalization through thiol-gold binding. The antibacterial and antibiofilm activities of 4-MPH-AuNRs were evaluated against a clinical isolate of Methicillin-Resistant Staphylococcus aureus (MRSA). The results indicate that 4-MPH-AuNRs exhibit a bactericidal activity with a minimum inhibitory concentration (MIC) of ~ 6.25 $$\upmu$$ μ g/mL against a planktonic suspension of MRSA. Furthermore, 4-MPH-AuNRs resulted in a 1.8–2.9 log-cycle reduction of MRSA biofilm viable count over a concentration range of 100–6.0 $$\upmu$$ μ g/mL. The bacterial uptake of the surface-modified nanorods was investigated by inductively coupled plasma-optical emission spectroscopy (ICP-OES) and scanning electron microscopy (SEM) imaging; the results reveal that the nanorods were internalized into the bacterial cells after 6 h (h) of exposure. SEM imaging revealed a significant accumulation of the nanorods at the bacterial cell wall and a possible cellular internalization. Thus, 4-MPH-AuNRs can be considered a potential antibacterial agent, particularly against MRSA strain biofilms.

Mercaptosuccinic-Acid-Functionalized Gold Nanoparticles for Highly Sensitive Colorimetric Sensing of Fe(III) Ions

The development of reliable and highly sensitive methods for heavy metal detection is a critical task for protecting the environment and human health. In this study, a qualitative colorimetric sensor that used mercaptosuccinic-acid-functionalized gold nanoparticles (MSA-AuNPs) to detect trace amounts of Fe(III) ions was developed. MSA-AuNPs were prepared using a one-step reaction, where mercaptosuccinic acid (MSA) was used for both stabilization, which was provided by the presence of two carboxyl groups, and functionalization of the gold nanoparticle (AuNP) surface. The chelating properties of MSA in the presence of Fe(III) ions and the concentration-dependent aggregation of AuNPs showed the effectiveness of MSA-AuNPs as a sensing probe with the use of an absorbance ratio of A530/A650 as an analytical signal in the developed qualitative assay. Furthermore, the obvious Fe(III)-dependent change in the color of the MSA-AuNP solution from red to gray-blue made it possible to visually assess the metal content in a concentration above the detection limit with an assay time of less than 1 min. The detection limit that was achieved (23 ng/mL) using the proposed colorimetric sensor is more than 10 times lower than the maximum allowable concentration for drinking water defined by the World Health Organization (WHO). The MSA-AuNPs were successfully applied for Fe(III) determination in tap, spring, and drinking water, with a recovery range from 89.6 to 126%. Thus, the practicality of the MSA-AuNP-based sensor and its potential for detecting Fe(III) in real water samples were confirmed by the rapidity of testing and its high sensitivity and selectivity in the presence of competing metal ions.

A rapid reduction of Au(I→0) strategy for the colorimetric detection and discrimination of proteins

A gold nanoparticle (AuNP)-based sensing strategy based on rapid reduction of Au(I→0) is proposed. As a proof-of-concept study, the proposed sensing principle is designed for simultaneous and colorimetric detection and discrimination of multiple proteins. In the presence of H₂O₂, the target proteins could reduce Au(I) (i.e. HAuCl₂) to AuNPs with different sizes, shapes and dispersion/aggregation states, thus resulting in rapidly colorimetric identification of different proteins. The optical response (i.e. color) of AuNPs is found to be characteristic of a given protein. The color response patterns are characteristic for each protein and can be quantitatively differentiated by statistical techniques. The sensor array is capable of discriminating proteins at concentrations as low as 0.1 μg/mL with high accuracy. A linear relationship was observed between the total Euclidean distances and protein concentration, providing the potential for protein quantification using this sensor array. The limit of detection (LOD) for catalase (Cat) is 0.08 μg/mL. The good linear range (from 0 to 8 μg/mL) has been used for the quantitative assay of Cat. To show a potentially practical application, this method was used to detect and discriminate proteins in human urine and tear samples. Graphical abstract We report a facile gold nanoparticle (AuNP)-based sensing strategy, that is, "a rapid reduction of Au(I) to Au(0) nanoparticles with different sizes and shapes by analytes that having certain reducing capabilities, resulting in different colours." The proposed sensing principle is designed for simultaneous, colorimetric detection and discrimination of multiple proteins.

Selective colorimetric sensing of deferoxamine with 4-mercaptophenol- and mercaptoacetic acid-functionalized gold nanoparticles via Fe(iii) chelation

The multidentate deferoxamine ligand can selectively aggregate the Fe(iii)-attached AuNPs@(4MP–MAA) colorimetric nanoprobe, whereas other bidentate iron chelators cannot bridge the nanoparticles.