Photoelectrochemical and XPS characterisation of oxide layers on 316L stainless steel grown in high-temperature water

Stress-Affected Oxygen Reduction Reaction Rates on UNS S13800 Stainless Steel

This work investigates the previously unexplored impact of tensile stress on oxygen reduction reaction (ORR) kinetics of a precipitation-hardened, stainless-steel fastener material, UNS S13800. ORR is known to drive localized and galvanic corrosion in aircraft assemblies and greater understanding of this reaction on structural alloys is important in forecasting component lifetime and service requirements. The mechano-electrochemical behavior of UNSS13800 was examined using amperometry to measure the reduction current response to tensile stress. Mechanical load cycles within the elastic regime demonstrated reversible electrochemical current shifts under chloride electrolyte droplets that exhibited a clear potential dependence. Strain ramping produced current peaks with a strain rate dependence, which was distinct from the chronoamperometric shifts during static tensile load conditions. Finally, mechanistic insight into the dynamic and static responses was obtained by deoxygenation, which demonstrated ORR contributions that were distinct from other reductive processes.

Calculation of Oxygen Diffusion Coefficients in Oxide Films Formed on Low-Temperature Annealed Zr Alloys and Their Related Corrosion Behavior

The growth of oxide film, which results from the inward oxygen diffusion from a corrosive environment, is a critical consideration for the corrosion resistance of zirconium alloys. This work calculates the oxygen diffusion coefficients in the oxide films formed on zirconium alloys annealed at 400~500 °C and investigates the related corrosion behavior. The annealed samples have a close size for the second-phase particles but a distinctive hardness, indicating the difference in substrate conditions. The weight gain of all samples highly follows parabolic laws. The weight gain of the sample annealed at 400 °C has the fastest increase rate at the very beginning of the corrosion test, but its oxide film has the slowest growth rate as the corrosion proceeds. By contrast, the sample annealed at 500 °C shows the lowest weight gain but the highest corrosion rate constant. Such a corrosion behavior is attributed to the amount of defects existing in the oxide film formed on the annealed samples; fewer defects would provide a lower fraction of short-circuit diffusion in total diffusion, resulting in a lower diffusion coefficient of oxygen in the oxide film, thereby producing better corrosion resistance. This is consistent with the calculated diffusion coefficients of oxygen in the oxide films: 3.252 × 10−11 cm2/s, 3.464 × 10−11 cm2/s and 3.740 × 10−11 cm2/s for the samples annealed at 400 °C, 450 °C, and 500 °C, respectively.