Functionalized graphene–polyaniline nanocomposite as electrode material for asymmetric supercapacitors

The high-efficiency coupling of a Ni2+ coordinated/uncoordinated pyridine N-COF self-supporting nanofilm as an asymmetric supercapacitor

A large-area COFTAPB-BPY film with a pore size of 3.9 nm was prepared on a gas-liquid interface by the virtue of the limiting and guiding functions of sodium dodecylbenzene sulfonate, followed by modification by Ni2+ ions with the reversible redox reaction of Ni(II/III), where Ni2+ was evidently anchored on the N in BPY. The obtained COFTAPB-BPY and Ni-COFTAPB-BPY nanofilms could avoid the inevitable aggregation and stacking of bulk COFTAPB-BPY, which facilitated a high specific capacitance of 0.26 mF cm-2 for the COFTAPB-BPY nanofilm and 0.38 mF cm-2 for the Ni-COFTAPB-BPY nanofilm at 0.001 mA cm-2. Considering the pseudocapacitance and double-layer capacitance traits of Ni-COFTAPB-BPY and COFTAPB-BPY nanofilms, the asymmetric Ni-COFTAPB-BPY//COFTAPB-BPY film supercapacitor was assembled with a symmetric COFTAPB-BPY//COFTAPB-BPY film device as a control. The asymmetric Ni-COFTAPB-BPY//COFTAPB-BPY film supercapacitor could enhance the energy density of 273.9 mW h cm-3 at 14.09 W cm-3 from 85.2 mW h cm-3 at 4.38 W cm-3 for the symmetric COFTAPB-BPY//COFTAPB-BPY film device. This work provides a new perspective on the application of self-supporting COF nanofilms as film asymmetric supercapacitors.

S/N-codoped carbon nanotubes and reduced graphene oxide aerogel based supercapacitors working in a wide temperature range

Among many supercapacitor electrode materials, carbon materials are widely used due to their large specific surface area, good electrical conductivity and high economic efficiency. However, carbon-based supercapacitors face the challenges of low energy density and limited operating environment. This work reports a facile self-assembled method to prepare three-dimensional carbon nanotubes/reduced graphene oxide (CNTs/rGO) aerogel material, which was applied as both positive and negative electrodes in a symmetric superacapacitor. The fabricated supercapacitor exhibited prominent capacitive performance not only at room temperature, but also at extreme temperatures (-20 ∼ 80 °C). The specific capacitances of the symmetric supercapacitors based on CNTs/rGO at a weight ratio of 2:5 respectively reached 107.8 and 128.2 F g^-1 at 25 °C and 80 °C with KOH as the electrolyte, and 80.0 and 144.6 F g^-1 at -20 °C and 60 °C with deep eutectic solvent as the electrolyte. Notably, the capacitance retention and coulombic efficiency of the assembled supercapacitors remained almost unchanged after 20,000 cycles of charge/discharge test over a wide temperature range. The work uncovered a possibility for the development of high-performance supercapacitors flexibly operated at extreme temperatures.

Study on Direct Synthesis of Energy Efficient Multifunctional Polyaniline-Graphene Oxide Nanocomposite and Its Application in Aqueous Symmetric Supercapacitor Devices

The synthesis of promising nanocomposite materials can always be tricky and depends a lot on the method of synthesis itself. Developing such synthesis routes, which are not only simple but also can effectively catch up the synergy of the compositing material, is definitely a worthy contribution towards nanomaterial science. Carbon-based materials, such as graphene oxide, and conjugative polymers, such as conductive polyaniline, are considered materials of the 21st century. This study involves a simple one pot synthesis route for obtaining a nanocomposite of polyaniline and graphene oxide with synergistic effects. The study was carried out in a systematic way by gradually changing the composition of the ingredients in the reaction bath until the formation of nanocomposite took place at some particular reaction parameters. These nanocomposites were then utilized for the fabrication of electrodes for aqueous symmetric supercapacitor devices utilizing gold or copper as current collectors. The device manifested a good capacitance value of 264 F/g at 1 A/g, magnificent rate performance, and capacitance retention of 84.09% at a high current density (10 A/g) when gold sheet electrodes were used as the current collectors. It also showed a capacitance retention of 79.83% and columbic efficiency of 99.83% after 2000 cycles.

Achieving Ultrahigh Cycling Stability and Extended Potential Window for Supercapacitors through Asymmetric Combination of Conductive Polymer Nanocomposite and Activated Carbon

Conducting polymers and carbon-based materials such as graphene oxide (GO) and activated carbon (AC) are the most promising capacitive materials, though both offer charge storage through different mechanisms. However, their combination can lead to some unusual results, offering improvement in certain properties in comparison with the individual materials. Cycling stability of supercapacitors devices is often a matter of concern, and extensive research is underway to improve this phenomena of supercapacitive devices. Herein, a high-performance asymmetric supercapacitor device was fabricated using graphene oxide–polyaniline (GO@PANI) nanocomposite as positive electrode and activated carbon (AC) as negative electrode. The device showed 142 F g⁻¹ specific capacitance at 1 A g⁻¹ current density with capacitance retention of 73.94% at higher current density (10 A g⁻¹). Most importantly, the device exhibited very high electrochemical cycling stability. It retained 118.6% specific capacitance of the starting value after 10,000 cycles at 3 Ag⁻¹ and with coulombic efficiency of 98.06 %, indicating great potential for practical applications. Very small solution resistance (Rs, 0.640 Ω) and charge transfer resistance (Rct, 0.200 Ω) were observed hinting efficient charge transfer and fast ion diffusion. Due to asymmetric combination, potential window was extended to 1.2 V in aqueous electrolyte, as a result higher energy density (28.5 Wh kg⁻¹) and power density of 2503 W kg⁻¹ were achieved at the current density 1 Ag⁻¹. It also showed an aerial capacitance of 57 mF cm⁻² at current 3.2 mA cm⁻². At this current density, its energy density was maximum (0.92 mWh cm⁻²) with power density (10.47 W cm⁻²).

Graphene-based nano composites and their applications. A review

The purpose of the current review article is to present a comprehensive understanding regarding pros and cons of graphene related nanocomposites and to find ways in order to improve the performance of nanocomposites with new designs. Nanomaterials including GR are employed in industrial applications such as supercapacitors, biosensors, solar cells, and corrosion studies. The present article has been prepared in three main categories. In the first part, graphene types have been presented, as pristine graphene, graphene oxide and reduced graphene oxide. In the second part, nanocomposites with many graphene, inorganic and polymeric materials such as polymer/GR, activated carbon/GR, metal oxide/GR, metal/graphene and carbon fibre/GR have been investigated in more detail. In the third part, the focus in on the industrial applications of GR nanocomposite, including super capacitors, biosensors, solar cells, and corrosion protection studies.