Comparative assessment of the sealing ability of Nd:YAG laser versus a new desensitizing agent in human dentinal tubules: a pilot study

Combined Effects of Glutaraldehyde-based Desensitizer and Nd: YAG Laser on Dentinal Tubules Occlusion

AIM

The aim of this study was to assess the impact of Nd:YAG laser, glutaraldehyde-based desensitizer (GD), or their combination on occluding dentinal tubules.

MATERIALS AND METHODS

Fifty dentin samples were obtained from non-carious human third molars and randomly divided into five groups (n = 10): (1) Control group treated with 37% phosphoric acid, (2) GD group, (3) Nd:YAG laser group (1064 nm, 100 µs, 10 Hz, 300 µm fiber, 1 W power, 100 mJ energy, and 85 J/cm2 energy density), (4) GD followed by Nd:YAG laser group, and (5) Nd:YAG laser followed by GD group. Scanning electron microscopy (SEM) was used to capture five images from each sample for analysis of dentinal tubules using Image J software. SEM/EDX elemental analysis was performed to determine the main mineral contents. Data analyzed using one-way ANOVA and Tukey's post hoc test for statistical comparisons.

RESULTS

Laser and combination groups showed a significant decrease in dentinal tubule counts compared with the control and GD groups (p < 0.0001). There were no significant differences in open dentinal tubule counts between the control and GD groups, as well as between the laser and combination groups. However, significant differences were observed in the total area, average size of the tubules, and percentage area between the control group and the treatment groups (GD, laser, GD + laser, laser + GD). No significant difference was found in the Ca/P ratio between the tested groups.

CONCLUSION

The use of Nd:YAG laser alone or in combination with GD was more effective in occluding dentinal tubules compared to GD alone.

CLINICAL SIGNIFICANCE

This study has shown that Nd:YAG laser alone and in combination with GD has superior dentinal tubule occlusion in vitro. Its clinical use in the treatment of dentinal hypersensitivity may overcome the drawback of conventional treatment approaches for dentin hypersensitivity needing repeated applications to achieve continuous relief from pain since acidic diet and toothbrushing result in the continuing elimination of precipitates and surface coatings. How to cite this article: Alzarooni AH, El-Damanhoury HM, Aravind SS, et al. Combined Effects of Glutaraldehyde-based Desensitizer and Nd: YAG Laser on Dentinal Tubules Occlusion. J Contemp Dent Pract 2024;25(1):52-57.

Evaluation of the effectiveness of different treatment approaches in preventing coronal discoloration caused by regenerative endodontic treatment

OBJECTIVES

This study aimed to evaluate the effectiveness of Teethmate desensitizer, a dentin bonding agent (DBA), Nd:YAG laser, and Er:YAG laser, which provides dentin tubule occlusion in the pulp chamber with different mechanisms, in preventing tooth discoloration due to regenerative endodontic treatment.

MATERIALS AND METHODS

One hundred five extracted maxillary human incisors with single roots and single canals were included in the study. The apical third of each tooth was resected below the enamel-cementum junction (CEJ) to obtain a standard root length as 10 ± 1 mm. Root canal preparation was performed using the ProTaper Next files up to X5. Root canals were prepared with Gates Glidden (# 2-4) burs to simulate the immature root apex and an apical diameter of 1.1 ± 0.1 mm was obtained. The teeth were randomly divided into 7 groups (n = 15): DBA, Teethmate, Nd:YAG, Er:YAG, Biodentine, Blood, and Negative Control. Relevant dentin tubule occlusion methods were applied to DBA, Teethmate, Nd:YAG, and Er:YAG groups. Following dentin tubule occlusion procedures, Biodentine was placed on the blood clot after filling the root canals with blood up to 4 mm below the CEJ. No dentin tubule occlusion procedure was applied for Blood and Biodentine groups. Color measurement was performed with the spectrophotometer Vita Easyshade Advance before treatment, immediately after treatment, and at days 7, 30, and 90. Data were converted to L*a*b color values of Commission International de I'Eclairage (CIE L*a*b) and ΔE values were calculated. Two-way ANOVA and post hoc Tukey test (p = 0.05) were performed for statistical analysis.

RESULTS

A clinically detectable color change was observed in all groups except for the negative control (ΔE ≥ 3,3). It was observed that Biodentine used alone has a potential for discoloration. It was determined that as the contact time with blood increased, tooth discoloration increased. However, no significant difference was found between dentin tubule occlusion methods in preventing color change (p > 0.05).

CONCLUSIONS

It was determined that no dentin tubule occlusion method could 100% prevent discoloration caused by RET.

CLINICAL RELEVANCE

DBA and Teethmate, which do not have a significant difference in terms of preventing color change, are considered to be suitable for dentin tubule occlusion due to their ease of application and low cost compared to Nd:YAG laser and Er:YAG laser.

The Effect of Desensitizing Agent on Shear Bond Strength to Dentin using Three Self-etching Bonding Systems at Different Time Intervals. An In Vitro Study

Objectives: To investigate the shear bond strength of dentin surfaces using different self-etching bonding systems after treating with a desensitizing agent at different time intervals.   Materials and methods: 63 sound upper premolars were used, the ‎occlusal aspect was sectioned at the middle in a ‎vertical direction into buccal and ‎palatal halves. Each ‎specimen was mounted and a flat dentin surface was ‎prepared at the middle third of each specimen. The sectioned samples were divided into 3 groups according to the bonding agent n=42. One-half of each tooth was treated with desensitizing agent Quadrant FiniSense then both halves were bonded with one of the three self-etching bonding systems (G-Premio bonding‎,  i Bond,  Clearfil S3 bound plus). ‎After adhesive procedures, a composite resin was applied against the tooth to form ‎a cylinder ‎(2mm×4mm) and cured. From each group 14 specimens were stored in distilled water at 37° C for 24 ‎hours, 7 days, and 72 days.  At the end of each interval, the samples were tested for the shear bond strength using a universal testing machine (Instron). Data were analyzed using the Independent t-test and One Way ANOVA Test and Duncan’s Multiple Range Test.   Results: All bonding systems showed lower bonding strength when samples were treated with desensitizer with a significant difference at all time intervals except for the i bond group which showed no significant difference in bond strength at a period of 7 and 72 days in treated and without desensitizer treated samples.    Conclusion: Obliteration of dentinal by dentin desensitizer may have a negative effect on the bonding strength of the self-etching bonding systems.

Laser-assisted treatment of dentinal hypersensitivity: a literature review

The purpose of this literature review was to evaluate the effectiveness of the laser-assisted treatment of dentinal hypersensitivity. A review with inclusion and exclusion criteria was performed from January 2009 to December 2014 with electronic data-bases: MedLine via PubMed, Science Direct and Cochrane Library. Research of paper magazines by hand was not considered. Forty-three articles were selected between literature reviews, in vitro studies, clinical trials, pilot and preliminary studies. The items were divided into laser-used groups for an accurate description, and then the reading of results into various typologies. Laser-assisted treatment reduces dentinal hypersensitivity-related pain, but also a psychosomatic component must be considered, so further studies and more suitable follow-ups are necessary.

Short-term response of three resin-based materials as desensitizing agents under oral environmental exposure

OBJECTIVE

This paper focuses on clinical responses after 7 days of oral exposure to two resin-based materials as desensitizing agents compared to a fluoride varnish and on morphological and analytical study as a means to elucidate the mechanism of action.

MATERIALS AND METHODS

The elemental composition of Vertise™ Flow (VF), Universal Dentine Sealant (UDS) and Flor-Opal® Varnish (FOV) were investigated by using an X-ray energy dispersive spectrometer (EDX) in conjunction with a scanning electron microscope (SEM). SEM morphology of the material-treated dentine surfaces and pain reduction ability according to the Visual Analogue Scale (VAS) were evaluated in selected hypersensitive teeth. Post treatments and 7 day controls were recorded with SEM and VAS measurements. Clinical data was analysed with the Student's t-test for paired data, with a 5% significance level.

RESULTS

Silicon, ytterbium and alumina were the most present elements in VF, whilst calcium, chloride, silicon and alumina were highest in UDS. Within a 7 day oral environment all the tested materials modified the treated-dentine surfaces showing tubular occlusion of different morphology. Clinically, the efficacy of all materials was similar after a 7-day examination. However, VAS scores were significantly reduced if compared with the baseline (p < 0.05).

CONCLUSIONS

Within the limits of this study, data indicate that both resins are effective in sealing tubules and reducing VAS. A resin-related effect on the dentine's morphology was observed, which may influence the long-term response of the resins in the treatment of dental hypersensitivity, which requires further investigation.