Optimization of enantioselective resolution of racemic ibuprofen by native lipase from Aspergillus niger

Design of a New Chemoenzymatic Process for Producing Epoxidized Monoalkyl Esters from Used Soybean Cooking Oil and Fusel Oil

The aim of this study was to produce epoxidized monoalkyl esters (EMAE), a valuable class of oleochemicals used in a wide range of products and industries, from used soybean cooking oil (USCO) and fusel oil via a three-step chemoenzymatic process. This process consists of a first enzymatic hydrolysis of USCO to produce free fatty acids (FFA). Here, five microbial lipases with different specificities were tested as biocatalysts. Full hydrolysis of USCO was obtained after a 180 min reaction time under vigorous stirring (1500 rpm) using a non-specific lipase from Candida rugosa (CRL). Then, monoalkyl esters (MAE) were produced via the esterification of FFA and fusel oil in a solvent-free system using the lipase Eversa® Transform 2.0 (ET2.0) immobilized via physical adsorption on poly(styrenene-divinylbenzene) (PSty-DVB) beads as a biocatalyst. Different water removal strategies (closed and open reactors in the presence or absence of molecular sieves at 5% m.m−1) on the reaction were evaluated. Maximum FFA conversions of 64.3 ± 2.3% (open reactor after a 30 min reaction time) and 73.5 ± 0.4% (closed reactor after a 45 min reaction time) were observed at 40 °C, using a stoichiometric FFA:fusel oil molar ratio (1:1), without molecular sieves, and 5 mg of immobilized protein per gram of reaction mixture. Under these conditions, maximum FFA conversion was only 30.2 ± 2.7% after a 210 min reaction time in a closed reactor using soluble lipase. Reusability tests showed better retention of the original activity of immobilized ET2.0 (around 82%) after eight successive batches of esterification reactions conducted in an open reactor. Finally, the produced MAE was epoxidized via the Prilezhaev reaction, a classical chemical epoxidation process, using hydrogen peroxide and formic acid as a homogeneous catalyst. The products were characterized by standard methods and identified using proton nuclear magnetic resonance (1H NMR). Maximum unsaturated bond conversions into epoxy groups were at approximately 33%, with the experimental epoxy oxygen content (OOCexp.) at 1.75–1.78%, and selectivity (S) at 0.81, using both MAEs produced (open or closed reactors). These results show that this new process is a promising approach for value-added oleochemical production from low-cost and renewable raw materials.

The High ‘Lipolytic Jump’ of Immobilized Amano A Lipase from Aspergillus niger in Developed ‘ESS Catalytic Triangles’ Containing Natural Origin Substrates

Lipase Amano A from Aspergillus niger (AA-ANL) is among the most commonly applied enzymes in biocatalysis processes, making it a significant scientific subject in the pharmaceutical and medical disciplines. In this study, we investigated the lipolytic activity of AA-ANL immobilized onto polyacrylic support IB-150A in 23 oils of natural origin containing various amounts of polyunsaturated fatty acids (PUFAs) and monounsaturated fatty acids (MUFAs). The created systems were expressed as an ‘ESS catalytic triangle’. A distinct ‘jump’ (up to 2400%) of lipolytic activity of immobilized AA-ANL compared to free lipase and hyperactivation in mostly tested substrates was observed. There was a ‘cutoff limit’ in a quantitative mutual ratio of ω-PUFAs/MUFAs, for which there was an increase or decrease in the activity of the immobilized AA-ANL. In addition, we observed the beneficial effect of immobilization using three polyacrylic supports (IB-150A, IB-D152, and IB-EC1) characterized by different intramolecular interactions. The developed substrate systems demonstrated considerable hyperactivation of immobilized AA-ANL. Moreover, a ‘lipolytic jump’ in the full range of tested temperature and pH was also observed. The considerable activity of AA-ANL-IB-150A after four reuse cycles was demonstrated. On the other hand, we observed an essential decrease in stability of immobilized lipase after 168 h of storage in a climate chamber. The tested kinetic profile of immobilized AA-ANL confirmed the increased affinity to the substrate relative to lipase in the free form.

Sources, purification, immobilization and industrial applications of microbial lipases: An overview

Microbial lipase is looking for better attention with the fast growth of enzyme proficiency and other benefits like easy, cost-effective, and reliable manufacturing. Immobilized enzymes can be used repetitively and are incapable to catalyze the reactions in the system continuously. Hydrophobic supports are utilized to immobilize enzymes when the ionic strength is low. This approach allows for the immobilization, purification, stability, and hyperactivation of lipases in a single step. The diffusion of the substrate is more advantageous on hydrophobic supports than on hydrophilic supports in the carrier. These approaches are critical to the immobilization performance of the enzyme. For enzyme immobilization, synthesis provides a higher pH value as well as greater heat stability. Using a mixture of immobilization methods, the binding force between enzymes and the support rises, reducing enzyme leakage. Lipase adsorption produces interfacial activation when it is immobilized on hydrophobic support. As a result, in the immobilization process, this procedure is primarily used for a variety of industrial applications. Microbial sources, immobilization techniques, and industrial applications in the fields of food, flavor, detergent, paper and pulp, pharmaceuticals, biodiesel, derivatives of esters and amino groups, agrochemicals, biosensor applications, cosmetics, perfumery, and bioremediation are all discussed in this review.

Lipase-mediated multicomponent synthesis of 1H-Pyrazolo[1,2-b]phthalazine-5,10-dione derivatives in a binary solvent medium

A new method for the synthesis of 1H-pyrazolo[1,2-b]phthalazine-5,10-dione derivatives via lipase from the Aspergillus niger-catalyzed multicomponent reaction of aldehydes, malononitrile, and phthalhydrazide is reported herein for the first time. This novel method holds several advantages, including its efficiency, environmental friendliness, simple workup procedure, and good yield (70-86%). The effects of temperature, organic solvents, and water content were investigated. This protocol has the potential to replace traditional chemical synthesis routes for the synthesis of nitrogen-containing heterocyclic compounds.

Enzymatic synthesis of ibuprofen monoglycerides catalyzed by free Candida antarctica lipase B in a toluene–glycerol biphasic medium

Reactive distillation in the presence of toluene permits the intensification of ibuprofen monoglyceride synthesis by means of aCandida antarcticaindustrial solution, attaining total conversion.

High pressure CO2-controlled reactors: enzymatic chiral resolution in emulsions

Chiral separation of ibuprofen catalyzed by enzyme conducted in CO₂-based micelle makes the reaction more effective and greener.

Response surface analysis for the production of an enantioselective lipase from Aspergillus niger by solid-state fermentation

The lipase produced by the Aspergillus niger strain AC-54 has been widely studied due to its enantioselectivity for racemic mixtures. This study aimed to optimize the production of this enzyme using statistical methodology. Initially a Plackett-Burman (PB) design was used to evaluate the effects of the culture medium components and the culture conditions. Twelve factors were screened: water content, glucose, yeast extract, peptone, olive oil, temperature, NaH(2)P0(4), KH(2)P0(4), MgS0(4)-7H(2)0, CaCl(2), NaCI, and MnS0(4). The screening showed that the significant factors were water content, glucose, yeast extract, peptone, NaH(2)P0(4), and KH(2)P0(4), which were optimized using response surface methodology (RSM) and a mathematical model obtained to explain the behavioral process. The best lipase activity was attained using the following conditions: water content (20%), glucose (4.8%), yeast extract (4.0%), and NaH2P04 (4.0%). The predicted lipase activity was 33.03 U/ml and the experimental data confirmed the validity of the model. The enzymatic activity was expressed as micromoles of oleic acid released per minute of reaction (micromol/min).

Immobilization of lipases on hydrophobilized zirconia nanoparticles: highly enantioselective and reusable biocatalysts

Our study has demonstrated for the first time that zirconia nanoparticles modified by a simple carboxylic surfactant of a very long alkyl chain can significantly enhance the activity of the immobilized lipases for asymmetric synthesis in organic media. Zirconia nanoparticles of ca. 20 nm diameter were grafted with carboxylic surfactant modifiers from Tween 85 and erucic acid. The surface of nanoparticles was successfully changed from hydrophilic to hydrophobic. Lipases from Candida rugosa and Pseudomonas cepacia were immobilized on the modified zirconia nanoparticles by adsorption in aqueous solution. The immobilized lipases were used for the resolution of ( R, S)-ibuprofen and ( R, S)-1-phenylethanol through esterification and acylation, respectively, in isooctane organic solvent. When immobilized on erucic acid-modified zirconia, both lipases gave significantly higher activity and enantioselectivity compared with those from their corresponding crude lipase powders. The nanohybrid biocatalysts are stable and can be reused for eight cycles without loss in activity and selectivity. The interaction between the hydrophobic surface of zirconia support and lipases probably induces the conformational rearrangement of lipases into an active, stable form.

Extremely thermostable esterases from the thermoacidophilic euryarchaeon Picrophilus torridus

Two genes encoding esterases EstA and EstB of Picrophilus torridus were identified by the means of genome analysis and were subsequently cloned in Escherichia coli. PTO 0988, which is encoding EstA, consists of 579 bp, whereas PTO 1141, encoding EstB, is composed of 696 bp, corresponding to 192 aa and 231 aa, respectively. Sequence comparison revealed that both biocatalysts have low sequence identities (14 and 16%) compared to previously characterized enzymes. Detailed analysis suggests that EstA and EstB are the first esterases from thermoacidophiles not classified as members of the HSL family. Furthermore, the subunits with an apparent molecular mass of 22 and 27 kDa of the homotrimeric EstA and EstB, respectively, represent the smallest esterase subunits from thermophilic microorganisms reported to date. The recombinant esterases were purified by Ni2+ affinity chromatography, and the activity of the purified esterases was measured over a wide pH (pH 4.5-8.5) and temperature range (10-90 degrees C). Highest activity of the esterases was measured at 70 degrees C (EstA) and 55 degrees C (EstB) with short pNP-esters as preferred substrates. In addition, esters of the non-steroidal anti-inflammatory drugs naproxen, ketoprofen, and ibuprofen are hydrolyzed by both EstA and EstB. Extreme thermostability was measured for both enzymes at temperatures as high as 90 degrees C. The determined half-life (t1/2) at 90 degrees C was 21 and 10 h for EstA and EstB, respectively. Remarkable preservation of esterase activity in the presence of detergents, urea, and commonly used organic solvents complete the exceptional phenotype of EstA and EstB.