An optically coupled sensor for the measurement of currents induced by MRI gradient fields into endocardial leads

[MR safety assessment of active implanted medical devices. German version]

BACKGROUND

Increasing numbers of patients with active implantable medical devices (AIMDs) require magnetic resonance (MR) examinations. The manufacturers are continuing to improve the MR compatibility of their AIMDs. To this end, a variety of measurement methods and numerical simulations are used to evaluate the risks associated with magnetic resonance imaging (MRI).

OBJECTIVE

In this article, test methods used to investigate interactions between AIMDs with radio frequency fields and time-varying magnetic gradient fields are reviewed.

MATERIALS AND METHODS

A literature review of known test methods for radio frequency and gradient field exposure of AIMDs with leads, in particular for neurostimulators, cochlear implants, and implanted infusion pumps, is presented. The state of the art and promising methods are discussed.

RESULTS

ISO/TS 10974 describes the design of high frequency and gradient injection setups to test conductive materials. A large number of sensor designs have been published to measure the induced voltages and currents through radio frequency and gradient fields and for monitoring AIMDs during MR examinations in in vitro tests.

CONCLUSION

The test methods should be planned to be as conservative as possible to cover the worst case scenario. However, in vitro measurements and computer simulation are far from being able to cover all possible configurations in their complexity and uniqueness. For safer MR examinations, current research recommends in vivo testing prior to MR, parallel radiofrequency transmission techniques, and new sequences with reduced energy input in the presence of AIMDs.

MR safety assessment of active implantable medical devices

BACKGROUND

Increasing numbers of patients with active implantable medical devices (AIMDs) require magnetic resonance (MR) examinations. The manufacturers are continuing to improve the MR compatibility of their AIMDs. To this end, a variety of measurement methods and numerical simulations are used to evaluate the risks associated with magnetic resonance imaging (MRI).

OBJECTIVE

In this article, test methods used to investigate interactions between AIMDs with radio frequency fields and time-varying magnetic gradient fields are reviewed.

MATERIALS AND METHODS

A literature review of known test methods for radio frequency and gradient field exposure of AIMDs with leads, in particular for neurostimulators, cochlear implants, and implanted infusion pumps, is presented. The state of the art and promising methods are discussed.

RESULTS

ISO/TS 10974 describes the design of high frequency and gradient injection setups to test conductive materials. A large number of sensor designs have been published to measure the induced voltages and currents through radio frequency and gradient fields and for monitoring AIMDs during MR examinations in in vitro tests.

CONCLUSION

The test methods should be planned to be as conservative as possible to cover the worst case scenario. However, in vitro measurements and computer simulation are far from being able to cover all possible configurations in their complexity and uniqueness. For safer MR examinations, current research recommends in vivo testing prior to MR, parallel radiofrequency transmission techniques, and new sequences with reduced energy input in the presence of AIMDs.

Magnetic Resonance Examinations of Patients With Implanted Active Devices. A Low-Cost Approach in Slew Rate Evaluation

Time-varying magnetic field gradients involved in magnetic resonance examinations can damage implanted electronic systems. The quantity related to this side effect is the gradient slew rate, which is usually not directly available on magnetic resonance console. The present study proposes a low-cost approach in slew rate assessment, which is useful in risks versus benefits evaluation as well as in sequences optimization. The experimental method is based on an analog circuit, which senses the output voltage of the scanner waveform generator. This allows taking easy and reliable slew rate measurements, even during clinical examinations on patients. Whereas previous studies required managing a considerable amount of data, the present work addresses only the maximal slew rate of any clinical sequence. Experimental results show that the smooth gradient mode, selectable on the two scanners examined, is very effective in patient safety improvement. In particular, it reduces slew rate values in the range from 52.4 up to 132.4 T m^-1 s^-1 , i.e. far below the interval 216-346 T m^-1 s^-1 , indicated as slew rate tolerance limit of modern implanted electronic devices. Bioelectromagnetics. 2019;40:512-521. © 2019 Bioelectromagnetics Society.

A novel MR-compatible sensor to assess active medical device safety: stimulation monitoring, rectified radio frequency pulses, and gradient-induced voltage measurements

PURPOSE

To evaluate the function of an active implantable medical device (AIMD) during magnetic resonance imaging (MRI) scans. The induced voltages caused by the switching of magnetic field gradients and rectified radio frequency (RF) pulse were measured, along with the AIMD stimulations.

MATERIALS AND METHODS

An MRI-compatible voltage probe with a bandwidth of 0-40 kHz was designed. Measurements were carried out both on the bench with an overvoltage protection circuit commonly used for AIMD and with a pacemaker during MRI scans on a 1.5 T (64 MHz) MR scanner.

RESULTS

The sensor exhibits a measurement range of ± 15 V with an amplitude resolution of 7 mV and a temporal resolution of 10 µs. Rectification was measured on the bench with the overvoltage protection circuit. Linear proportionality was confirmed between the induced voltage and the magnetic field gradient slew rate. The pacemaker pacing was recorded successfully during MRI scans.

CONCLUSION

The characteristics of this low-frequency voltage probe allow its use with extreme RF transmission power and magnetic field gradient positioning for MR safety test of AIMD during MRI scans.