Systematic analysis on the relationship between luminal enhancement, convolution kernel, plaque density, and luminal diameter of coronary artery stenosis: a CT phantom study

Gadolinium K-edge angiography with a spectral photon counting CT in atherosclerotic rabbits

PURPOSE

The purpose of this study was to investigate the feasibility of gadolinium-K-edge-angiography (angio-Gd-K-edge) with gadolinium-based contrast agents (GBCAs) as obtained with spectral photon counting CT (SPCCT) in atherosclerotic rabbits.

MATERIALS AND METHODS

Seven atherosclerotic rabbits underwent angio-SPCCT acquisitions with two GBCAs, with similar intravenous injection protocol. Conventional and angio-Gd-K-edge images were reconstructed with the same parameters. Regions of interest were traced in different locations of the aorta and its branches. Hounsfield unit values, Gd concentrations, signal-to-noise (SNR) and contrast-to-noise (CNR) were calculated and compared. The maximum diameter and the diameter of the aorta in regard to atherosclerotic plaques were measured by two observers. Images were subjectively evaluated regarding vessels' enhancement, artefacts, border sharpness and overall image quality.

RESULTS

In the analyzable six rabbits, Gd-K-edge allowed visualization of target vessels and no other structures. HU values and Gd concentrations were greatest in the largest artery (descending aorta, 5.6 ± 0.8 [SD] mm), and lowest in the smallest (renal arteries, 2.1 ± 0.3 mm). While greater for conventional images, CNR and SNR were satisfactory for both images (all P < 0.001). For one observer there were no statistically significant differences in either maximum or plaque-diameters (P = 0.45 and all P > 0.05 in post-hoc analysis, respectively). For the second observer, there were no significant differences for images reconstructed with the same parameters (all P < 0.05). All subjective criteria scored higher for conventional images compared to K-edge (all P < 0.01), with the highest scores for enhancement (4.3-4.4 vs. 3.1-3.4).

CONCLUSION

With SPCCT, angio-Gd-K-edge after injection of GBCAs in atherosclerotic rabbits is feasible and allows for angiography-like visualization of small arteries and for the reliable measurement of their diameters.

Pill or pump? Nitroglycerin 0.5 mg tablet vs 0.8 mg spray: Effect on proximal vessel diameters at Coronary CT Angiography (CCTA)

INTRODUCTION

The administration of sublingual Nitroglycerin (NTG) prior to CT coronary angiography (CCTA) can be perfomed using pump spray or tablets. Choice of method seems to be based on local preference, rather than published guidelines. This retrospective analysis tested whether proximal coronary diameters differed dependent on the sublingual administration of 0.5 mg Nitroglycerin (NTG) tablets or 0.8 mg NTG spray.

METHODS

287 ECG-gated CCTA studies with optimal image quality and Agatston scores<400 were included in this retrospective analysis. 143 of the patients were dosed with NTG tablets at a dose of 0.5 mg prior to CCTA. 144 patients received 2 puffs of 0.4 mg NTG spray for a total dose of 8 mg. All were scanned on a second-generation Dual Source CT. Diameters of proximal segments of Left Main (LM), Right (RCA), Left Anterior (LAD) and circumflex (CX) coronary arteries were measured using semi-automatic electronic callipers by two blinded readers. Results were summarised as the mean of maximum and minimum diameters. Sex-specific analysis of diameters was carried out using repeated-measures ANOVA for each vessel. Agreement between readers was examined with Bland-Altman analysis and intra-class-correlation coefficient (ICC).

RESULTS

No significant differences in coronary diameters were found except in the RCA for women and LM for men. In both cases, diameters were smaller in the spray group (11 and 9%, respectively). Reader agreement was excellent, with ICC>0.96 for all vessels, and no significant bias, except in CX (0.03 mm).

CONCLUSIONS

We found no evidence for the systematic superiority of either administration method in proximal coronary vessels.

IMPLICATIONS FOR PRACTICE

Choosing between tablet or spray NTG prior to CCTA can be guided by practical, economical and hygienic considerations alone.

Quantification of uncertainty in the assessment of coronary plaque in CCTA through a dynamic cardiac phantom and 3D-printed plaque model

The purpose of this study was to develop a dynamic physical cardiac phantom with a realistic coronary plaque to investigate stenosis measurement accuracy under clinically relevant heart-rates. The coronary plaque model (5 mm diameter, 50% stenosis, and 32 mm long) was designed and 3D-printed with tissue equivalent materials (calcified plaque with iodine-enhanced lumen). Realistic cardiac motion was modeled by converting computational cardiac motion vectors into compression and rotation profiles executed by a commercial base cardiac phantom. The phantom was imaged on a dual-source CT system applying a retrospective gated coronary CT angiography (CCTA) protocol using synthesized motion-synchronized electrocardiogram (ECG) waveforms. Multiplanar reformatted images were reconstructed along vessel centerlines. Enhanced lumens were segmented by five independent operators. On average, stenosis measurement accuracy was 0.9% positively biased for the motion-free condition. Average measurement accuracy monotonically decreased from 0.9% positive bias for the motion-free condition to 18.5% negative bias at 90 beats per minute. Contrast-to-noise ratio, lumen circularity, and segmentation conformity also decreased monotonically with increasing heart-rate. These results demonstrate successful implementation of a base cardiac phantom with a 3D-printed coronary plaque model, relevant motion profile, and coordinated ECG waveform. They further show the utility of the model to ascertain metrics of CCTA accuracy and image quality under realistic plaque, motion, and acquisition conditions.

The Diagnostic Performance of Coronary CT Angiography for the Assessment of Coronary Stenosis in Calcified Plaque

Purpose

To prospectively evaluate the diagnostic performance of coronary CT angiography (CCTA) for the assessment of coronary stenosis in a calcified plaque, by using conventional coronary angiography (CAG) as a standard reference.

Materials and Methods

Eight hundred and ninety-four patients were known to have or have been suspicious of having coronary artery disease, underwent CCTA and conventional coronary angiography (CAG). All the images acquired were assessed. The calcified plaque in CCTA was classified into four types (I-IV) according to the ratio of calcified plaque volume to vessel circumference (RVTC). Overall diagnostic accuracy was made under receiver operating characteristic curve (AUC) analysis. CAG was used as the standard reference.

Results

A total of 12845 segments were evaluated in 894 patients, among which 4955 calcified plaques were detected on 3645(28.4%) segments by CCTA. The overall AUC, sensitivity, specificity, positive predictive value (PPV), and negative predictive value (NPV) were 0.939, 97.8%, 90.1%, 71.2% and 99.4%, respectively. In type I-II calcification, CCTA had high diagnostic performance in AUC (type I: 0.983; type II: 0.976), sensitivity (96.7%; 98.1%), specificity (99.8%; 97.0%), PPV (95.7%; 90.1%), NPV (99.8%; 99.5%) and accuracy (99.6%; 97.3%). In type III-IV calcification, CCTA has high performance in sensitivity (type III: 97.6%; type IV: 97.9%) and NPV (98.3%; 98.7%), moderate performance in AUC (0.877; 0.829), while remarkable decrease in specificity (78.7%; 67.9%), PPV (71.0%; 56.2%) and accuracy (84.9%; 76.8%).

Conclusion

CCTA has highest accuracy in diagnosing the coronary artery stenosis of type I-II calcified plaques, but has a significant decrease in specificity, PPV and accuracy in type III-IV calcified plaque.