The influence of target stoichiometry on early cell adhesion of co-sputtered calcium-phosphate surfaces

An easy and straightforward synthesized nano calcium phosphate for highly capture of multiply phosphorylated peptides

Multisite phosphorylation of proteins regulates various cellular life activities, however, the capture of low abundance multi-phosphopeptides from biosamples and identification of phosphorylation sites are largely limited due to the limited enrichment materials and their unclear interactions with multi-phosphopeptides. Here we propose using two cheap raw materials (CaCl₂·2H₂O and Na₂HPO₄·12H₂O) in 10 min at room temperature to synthesize the structurally simple Nanometric Calcium Phosphate (CaP) to resolve this challenge. The current results showed that the "simple" CaP has good selection specificity, high sensitivity and stability for multi-phosphopeptides enrichment and the identification of phosphorylation sites, which facilitate the popularization and application of phosphoproteomics research. Further, the interaction of CaP and multi-phosphopeptides were qualitatively characterized at the molecular/atomic level and the high affinity between them was quantified by the isothermal titration microcalorimeter based on the laws of thermodynamics. The results indicated that the interaction was a spontaneous (ΔG < 0) exothermic reaction with enthalpy reduction (ΔH < 0) and driven mainly by hydrogen bond and electrostatic interaction process.

The deposition of strontium-substituted hydroxyapatite coatings

Strontium substituted hydroxyapatite (SrHA) coatings have received a lot of interest recently as strontium (Sr) has been shown to have the dual benefit of promoting bone formation and reducing bone resorption, in vivo. In this work, SrHA coatings were deposited onto polycrystalline titanium surfaces using radio frequency (RF) magnetron co-sputtering and compared to those deposited from HA alone. In particular, the influence of different levels of Sr-substitution of the sputtering targets (5 and 13% Sr-substituted HA targets) on the properties of the deposited coatings produced at a low discharge power level (150 W) were investigated using FTIR, XPS, XRD, ToFSIMS and AFM techniques (both before and after annealing at 500 °C). The results show that Sr could be successfully incorporated into the HA lattice to form SrHA coatings and that they contained no other impurities. However, the coating produced from the 13% Sr-substituted target had a higher Ca+Sr/P ratio (1.95±0.14) and Sr content when compared to the coating produced from the 5% Sr-substituted target (1.58±0.20). The deposition rate also decreased with increasing Sr content of the sputtering targets. Furthermore, as the Sr content of the coatings increased, so did the preferred 002 orientation of the coating along with increased surface roughness and heterogeneity of the surface features. Therefore, this study has shown that RF magnetron sputtering offers a means to control attendant properties of Sr-substituted HA, such as the crystallinity, stoichiometry, phase purity and surface topography.