Structural and Optical Characteristic of Cu-Doped TiO2 Thin Film

Influence of defects on the linear and nonlinear optical properties of Cu-doped rutile TiO2 microflowers

Defects and disorder work as controlling parameters to alter the electronic structure of nanostructures and significantly influence their electronic, magnetic, and nonlinear optical (NLO) properties. In this study, we found that defect engineering is an effective strategy for tailoring the linear and nonlinear optical properties of Cu-doped titanium oxide (TiO2) flower-shaped nanostructures. The concentration of chemical doping of Cu in the TiO2 lattice creates intermediate defect states that impact electronic bandgap reduction and tunable defect luminescence. The estimation of the bandgap from density functional theory calculation follows the same trend of bandgap narrowing with Cu doping. The XPS study reveals that oxygen defects are responsible for bandgap narrowing and quenching of the PL intensity. A single-beam Z-scan technique with open and closed aperture configurations using ultrashort pulses centered at 532 nm excitation wavelength was used to study the NLO measurements. The open aperture reveals saturable absorption, whereas the closed aperture shows self-focusing behavior. The nonlinear absorption coefficient and refractive index extracted from NLO measurements demonstrate the linear dependence on the defect concentration and bandgap. The effects of heterogeneous dopants and lattice disorder on the nonlinear absorption behavior of these nanostructures are discussed in comparison with the figure of merit, non-linear refractive index, and absorption coefficient. The tunable NLO properties achieved by controlling such dopant-induced defects boost the scope of these nanostructures as optical limiting, optical switching, and optical photodiode applications.

Photocatalytic Evaluation of TiOx Films Produced by Cathodic Arc-PVD with Silver Addition by UVC Photo-Reduction Method

A titanium (Ti) commercial cathode material and high purity Ar and O2 were used in the cathodic arc physical vapor deposition (arc-PVD) process. The TiOx coating was deposited on the three sets of Raschig rings using decreasing ratios of Ar/O2:440/60, 400/100 and 300/100. The cross sections of the TiOx PVD coating were analyzed using field emission scanning electron microscopy (FE-SEM), X-ray energy dispersive spectroscopy (EDS), and X-ray diffraction (XRD). A homogeneous layer of Ti with small O content was observed, and the data suggest that a thin TiOx oxide film was deposited. For this reason, a thermal treatment was applied to the coating to oxidize it and form the rutile phase of TiO2 in the coating, which was demonstrated by grazing incidence XRD. In addition, the TiOx coatings absorb radiation, which was observed by diffuse reflectance band gap energy measurement. Silver (Ag) was added by the photo-reduction method, using UVC light to activate the TiO2 coating, and the band gap energy was analyzed by diffuse reflectance. The photocatalytic activities of the films were evaluated by degradation of the model dye rhodamine B and in the removal of fecal coliforms using two matrices, water from a secondary treatment effluent, and synthetic water.