Dihydroxy bezladely derivatives functionalized mesoporous silica SBA-15 for the sorption of U(VI)

The simultaneous removal of co-contaminants pyrene and Cu (II) from aqueous solutions by Fe/Mn bimetallic functionalized mesoporous silica

In recent years, the co-contamination of heavy metals (HMs) and polycyclic aromatic hydrocarbons (PAHs) has attracted more and more attention, and finding efficient and coordinated removal method has been the hot focus. In this study, Fe/Mn-SBA15 bimetallic mesoporous silica adsorbent (Fe/Mn-SBA15) was prepared by hydrothermal method with the functional groups Fe and Mn simultaneously doped into the framework structure of SBA15. Fe/Mn-SBA15 was systematically characterized by XRD, TEM, and BET and used in removal of typical PAHs-pyrene and heavy metal-Cu (II) from aqueous solutions simultaneously. The single and binary adsorption behaviors were studied by kinetics, isotherm, pH, and ionic strength. The results showed that the functional groups of Fe and Mn were successfully loaded into the structure of SBA15 and the prepared adsorbent was still a typical mesoporous adsorbent. The adsorption of pyrene and Cu (II) onto Fe/Mn-SBA15 was fast and the adsorption equilibrium was achieved in 100 min. The Langmuir model fitted the adsorption isotherm better and the maximum adsorption capacities for pyrene and Cu (II) were 120 mg/g and 10.52 mg/g, respectively. The increase of ionic strength could enhance and decrease the adsorption capacity of pyrene and Cu (II), which may be attributed to salting-out effect and potassium competitive. With the increase of pH values, the negative charge on the surface of the adsorbent increased, resulting in the decrease and increase of adsorption capacity of pyrene and Cu (II) onto Fe/Mn-SBA15. In addition, Fe/Mn-SBA15 was found to have a synergistic effect on the adsorption of pyrene and Cu (II). This result is mainly due to the formation of hydration complex by pyrene-Cu (II) through cation-π interaction, which increases the adsorption capacity by occupying each other's adsorption sites of adsorbent. This study provides a new method for the synergistic removal of PAHs and HMs from aqueous solutions.

Facile Synthesis of Diatomite/β-Cyclodextrin Composite and Application for the Adsorption of Diphenolic Acid from Wastewater

Diphenolic acid (DPA) is a kind of endocrine-disrupting compound, which brings serious health problems to humans and animals. An eco-friendly and cost-effective adsorbent was prepared through a simple method, in which the β-Cyclodextrin(β-CD) was crosslinked onto the surface of diatomite (DA), the as-prepared DA/β-CD composite showed higher adsorption efficiency for DPA than DA as the host–guest interaction between DPA and β-CD. DA is a kind of biosilica with a hierarchical pore structure that provides enough surface area for the DA/β-CD. The surface area and pore size of DA/β-CD were investigated by nitrogen adsorption and desorption. The DA/β-CD composite illustrated a good adsorption capability, and was used for removing DPA from wastewater. The adsorption ratio of DPA could achieve 38% with an adsorption amount of 9.6 mg g−1 under room temperature at pH = 6. The adsorption isotherm curves followed the Langmuir (R2 = 0.9867) and Freundlich (R2 = 0.9748) models. In addition, the regeneration rate of the DA/β-CD was nearly at 80.32% after three cycles of regeneration. These results indicated that the DA/β-CD has the potential for practical removal of the EDC contaminants from wastewater.