Domination of methylene blue over rhodamine B during simultaneous photocatalytic degradation by TiO2 nanoparticles in an aqueous binary solution under UV irradiation

Efficient Photodegradation of Dyes from Single and Binary Aqueous Solutions Using Copper(II) Coordination Polymers

The present study reports the application of three copper(II) coordination polymers, namely 1∞[Cu3L2(N3)] CH3COO (CP1), 1∞[Cu3L2(NO3)]NO3·2CH3OH·2H2O (CP2), and 1∞[Cu3L2(H2O)](ClO4)2 (CP3), where H2L stands for N,N'-bis[(2-hydroxybenzilideneamino)propyl]-piperazine) as catalysts for photocatalytic degradation of Acid Orange 7 and Methyl Orange dyes from single and binary aqueous solutions. The influence of the photocatalyst nature, hydrogen peroxide presence, reaction time, dye concentration, and catalyst dose on the photodegradation efficiency was studied. Under visible light irradiation, complex CP1 demonstrated the highest photodegradation efficiency of 92.40% and 80.50% towards Acid Orange 7 and Methyl Orange, respectively. The kinetic studies indicated that the photodegradation process followed a pseudo-first-order kinetics. The highest rate of the degradation process was obtained when CP1 is used, and the necessary time for the degradation of the dyes increases with increasing concentration of the dye solutions. The degradation efficiency of more than 75% after five recycling/reuse cycles of CP1 and the yields higher than 72% obtained for the degradation of dyes from the binary system demonstrate the photocatalytic capacity of CP1. A photocatalytic oxidation mechanism was proposed and the stability of the CP1 complex before and after the photodegradation process of dyes, both from simple and binary solutions, was investigated and confirmed.

Dynamics of Diffusion- and Immobilization-Limited Photocatalytic Degradation of Dyes by Metal Oxide Nanoparticles in Binary or Ternary Solutions

Photocatalytic degradation employing metal oxides, such as TiO2 nanoparticles, as catalysts is an important technique for the removal of synthetic dyes from wastewater under light irradiation. The basic principles of photocatalysis of dyes, the effects of the intrinsic photoactivity of a catalyst, and the conventional non-fundamental factors are well established. Recently reported photocatalysis studies of dyes in single, binary, and ternary solute solutions opened up a new perspective on competitive photocatalytic degradation of the dyes. There has not been a review on the photocatalytic behavior of binary or ternary solutions of dyes. In this regard, this current review article summarizes the photocatalytic behavior of methylene, rhodamine B, and methyl orange in their binary or ternary solutions. This brief overview introduces the importance of the dynamics of immobilization and reactivity of the dyes, the vital roles of molecular conformation and functional groups on their diffusion onto the catalyst surface, and photocatalytic degradation, and provides an understanding of the simultaneous photocatalytic processes of multiple dyes in aqueous systems.

Auramine O UV Photocatalytic Degradation on TiO2 Nanoparticles in a Heterogeneous Aqueous Solution

Amongst the environmental issues throughout the world, organic synthetic dyes continue to be one of the most important subjects in wastewater remediation. In this paper, the photocatalytic degradation of the dimethylmethane fluorescent dye, Auramine O (AO), was investigated in a heterogeneous aqueous solution with 100 nm anatase TiO2 nanoparticles (NPs) under 365 nm light irradiation. The effect of irradiation time was systematically studied, and photolysis and adsorption of AO on TiO2 NPs were also evaluated using the same experimental conditions. The kinetics of AO photocatalytic degradation were pseudo-first order, according to the Langmuir–Hinshelwood model, with a rate constant of 0.048 ± 0.002 min−1. A maximum photocatalytic efficiency, as high as 96.2 ± 0.9%, was achieved from a colloidal mixture of 20 mL (17.78 μmol L−3) AO solution in the presence of 5 mg of TiO2 NPs. The efficiency of AO photocatalysis decreased nonlinearly with the initial concentration and catalyst dosage. Based on the effect of temperature, the activation energy of AO photocatalytic degradation was estimated to be 4.63 kJ mol−1. The effect of pH, additional scavengers, and H2O2 on the photocatalytic degradation of AO was assessed. No photocatalytic degradation products of AO were observed using UV–visible and Fourier transform infrared spectroscopy, confirming that the final products are volatile small molecules.

Dynamics and thermodynamics for competitive adsorptive removal of methylene blue and rhodamine B from binary aqueous solution onto durian rind

Concurrent adsorptive removal of methylene blue (MB) and rhodamine B (RhB) onto durian rind (DR) agricultural waste, from an aqueous binary solution as a model of wastewater containing multiple synthetic dyes, was investigated. The concurrent adsorption of the dyes followed pseudo-second-order kinetics. The adsorption isotherm was well simulated by the Langmuir model, implying a monolayer adsorption to the surface with a homogeneous binding energy. The adsorption process was governed by external mass transfer through two-step intraparticle diffusion of the dyes onto the adsorbent surface. The adsorption efficiency of MB (96.4%) is much higher than that of RhB (56.3%). This is attributed to the higher rate constant for the adsorption of MB (0.348 g mg^-1 min^-1) as compared to that of RhB (0.151 g mg^-1 min^-1). The adsorption behavior suggested that the two cationic dyes in the binary solution diffused and adsorbed independently and randomly onto the DR surface. The adsorption capacity of MB and RhB in the binary solution (47.4 mg g^-1 and 32.9 mg g^-1, respectively) is lower than those of their single solute solutions (93.3 mg g^-1 and 62.8 mg g^-1, respectively), suggesting a competitive effect in their concurrent adsorption. This was confirmed based on the adsorption characteristics of the binary solution with different molar ratios. The competitive effect was attributed to either non-interactive or repulsive electrostatic interactions between the positively charged dyes in the binary system. The domination of MB is attributed to its smaller molecular size, higher planarity, and faster adsorption kinetics compared with RhB.

Adsorption Behavior and Dynamic Interactions of Anionic Acid Blue 25 on Agricultural Waste

In this study, adsorption characteristics of a negatively charged dye, Acid Blue 25 (AB25), on pomelo pith (PP) was studied by varying the adsorption parameters, with the aim of evaluating the adsorption mechanism and establishing the role of hydrogen bonding interactions of AB25 on agricultural wastes. The kinetics, intraparticle diffusion, mechanism, and thermodynamics of the AB25 adsorption were systematically evaluated and analyzed by pseudo-first-order and pseudo-second-order kinetic models, the Weber-Morris intraparticle and Boyd mass transfer models, the Langmuir, Freundlich, Dubinin-Radushkevich, and Temkin isotherm models, and the Van't Hoff equation. It was found that AB25 adsorption followed pseudo-second-order kinetics, governed by a two-step pore-volume intraparticle diffusion of external mass transfer of AB25 onto the PP surface. The adsorption process occurred spontaneously. The adsorption mechanism could be explained by the Langmuir isotherm model, and the maximum adsorption capacity was estimated to be 26.9 mg g-1, which is comparable to many reported adsorbents derived from agricultural wastes. Changes in the vibrational spectra of the adsorbent before and after dye adsorption suggested that AB25 molecules are bound to the PP surface via electrostatic and hydrogen bonding interactions. The results demonstrated that the use of pomelo pith, similar to other agricultural wastes, would provide a basis to design a simple energy-saving, sustainable, and cost-effective approach to remove negatively charged synthetic dyes from wastewater.