Capture of carbon dioxide by a nanosized tube of BeO: a DFT study

BeO nanotube as a promising material for anticancer drugs delivery system

In this research, the application of BeO nanotube (BeONT) as a nanocarrier for Fluorouracil (5-FU) anticancer drug has been studied by density functional theory (DFT) approach. The method ωB97XD with 6-31 G** basis set were employed. A precise surface study, shows that there are two directions for 5-FU adsorption that did not deliver any of the imaginary frequency vibrational spectra, identifying that all relaxation structures are at the lowest energy level. Based on our calculations, the energy of adsorption for 5FU@BeONT structures are range -120 to -168 kJ/mol, in the gas phase and -395 to 4-00 kJ/mol in the aqueous phase. The highest and the lowest values of adsorption energy are both in strong physical adsorption. Due to receiving an electronic charge from 5-FU, BeONT exhibited a p-type semiconducting feature for all positions. In addition, based on natural bond orbital (NBO) analysis, the direction of charge transfer was from fluorine's σ orbitals of the drug to n* orbitals (O and Be atoms) of BeONT with a considerable amount of transferred energy. BeONT can be employed as a potential strong carrier for 5-FU drugs for practical purposes based on our findings.

Identification of Nano-Metal Oxides That Can Be Synthesized by Precipitation-Calcination Method Reacting Their Chloride Solutions with NaOH Solution and Their Application for Carbon Dioxide Capture from Air-A Thermodynamic Analysis

Several metal oxide nanoparticles (NPs) were already obtained by mixing NaOH solution with chloride solution of the corresponding metal to form metal hydroxide or oxide precipitates and wash-dry-calcine the latter. However, the complete list of metal oxide NPs is missing with which this technology works well. The aim of this study was to fill this knowledge gap and to provide a full list of possible metals for which this technology probably works well. Our methodology was chemical thermodynamics, analyzing solubilities of metal chlorides, metal oxides and metal hydroxides in water and also standard molar Gibbs energy changes accompanying the following: (i) the reaction between metal chlorides and NaOH; (ii) the dissociation reaction of metal hydroxides into metal oxide and water vapor and (iii) the reaction between metal oxides and gaseous carbon dioxide to form metal carbonates. The major result of this paper is that the following metal-oxide NPs can be produced by the above technology from the corresponding metal chlorides: Al₂O₃, BeO, CaO, CdO, CoO, CuO, FeO, Fe₂O₃, In₂O₃, La₂O₃, MgO, MnO, Nd₂O₃, NiO, Pr₂O₃, Sb₂O₃, Sm₂O₃, SnO, Y₂O₃ and ZnO. From the analysis of the literature, the following nine nano-oxides have been already obtained experimentally with this technology: CaO, CdO, Co₃O₄, CuO, Fe₂O₃, NiO, MgO, SnO₂ and ZnO (note: Co₃O₄ and SnO₂ were obtained under oxidizing conditions during calcination in air). Thus, it is predicted here that the following nano-oxides can be potentially synthesized with this technology in the future: Al₂O₃, BeO, In₂O₃, La₂O₃, MnO, Nd₂O₃, Pr₂O₃, Sb₂O₃, Sm₂O₃ and Y₂O₃. The secondary result is that among the above 20 nano-oxides, the following five nano-oxides are able to capture carbon dioxide from air at least down to 42 ppm residual CO₂-content, i.e., decreasing the current level of 420 ppm of CO₂ in the Earth's atmosphere at least tenfold: CaO, MnO, MgO, CdO, CoO. The tertiary result is that by mixing the AuCl₃ solution with NaOH solution, Au nano-particles will precipitate without forming Au-oxide NPs. The results are significant for the synthesis of metal nano-oxide particles and for capturing carbon dioxide from air.

Transition metal doped ZnO nanoclusters for carbon monoxide detection: DFT studies

Metal doped ZnO nanomaterials have attracted considerable attention as a chemical sensor for toxic gases. Here, the electronic sensitivity of pristine and Sc-, Ti-, V-, Cr-, Mn-, and Fe-doped Zn12O12 nanoclusters toward CO gas is investigated using density functional theory calculations. It is found that replacing a Zn atom by a Sc or Ti atom does not change the sensitivity of cluster but doping V and Cr atoms significantly increase the sensitivity. Also, Mn, or Fe doping slightly improves the sensitivity. It is predicted that among all, the Cr-doped ZnO cluster may be the most favorable sensor for CO detection because its electrical conductivity considerably changes after the CO adsorption, thereby, generating an electrical signal. The calculated Gibbs free energy change for the adsorption of CO molecule on the Cr-doped cluster is about -51.2 kcal mol(-1) at 298.15 K and 1 atm, and the HOMO-LUMO gap of the adsorbent is changed by about 117.8 %.