A New Class of MnCeOx Materials for the Catalytic Gas Exhausts Emission Control: A Study of the CO Model Compound Oxidation

Effect of Hematite Doping with Aliovalent Impurities on the Electrochemical Performance of α-Fe2O3@rGO-Based Anodes in Sodium-Ion Batteries

The effect of the type of dopant (titanium and manganese) and of the reduced graphene oxide content (rGO, 30 or 50 wt %) of the α-Fe₂O₃@rGO nanocomposites on their microstructural properties and electrochemical performance was investigated. Nanostructured composites were synthesized by a simple one-step solvothermal method and evaluated as anode materials for sodium ion batteries. The doping does not influence the crystalline phase and morphology of the iron oxide nanoparticles, but remarkably increases stability and Coulombic efficiency with respect to the anode based on the composite α-Fe₂O₃@rGO. For fixed rGO content, Ti-doping improves the rate capability at lower rates, whereas Mn-doping enhances the electrode stability at higher rates, retaining a specific capacity of 56 mAhg^-1 at a rate of 2C. Nanocomposites with higher rGO content exhibit better electrochemical performance.

Efficient Waste to Energy Conversion Based on Co-CeO2 Catalyzed Water-Gas Shift Reaction

Waste to energy technology is attracting attention to overcome the upcoming environmental and energy issues. One of the key-steps is the water-gas shift (WGS) reaction, which can convert the waste-derived synthesis gas (H2 and CO) to pure hydrogen. Co–CeO2 catalysts were synthesized by the different methods to derive the optimal synthetic method and to investigate the effect of the preparation method on the physicochemical characteristics of Co–CeO2 catalysts in the high-temperature water-gas shift (HTS) reaction. The Co–CeO2 catalyst synthesized by the sol-gel method featured a strong metal to support interaction and the largest number of oxygen vacancies compared to other catalysts, which affects the catalytic activity. As a result, the Co–CeO2 catalyst synthesized by the sol-gel method exhibited the highest WGS activity among the prepared catalysts, even in severe conditions (high CO concentration: ~38% in dry basis and high gas hourly space velocity: 143,000 h−1).

“Intelligent” Pt Catalysts Based on Thin LaCoO3 Films Prepared by Atomic Layer Deposition

LaCoO3 films were deposited onto MgAl2O4 powders by atomic layer deposition (ALD) and then used as catalyst supports for Pt. X-ray diffraction (XRD) showed that the 0.5 nm films exhibited a perovskite structure after redox cycling at 1073 K, and scanning transmission electron microscopy and elemental mapping via energy-dispersive X-ray spectroscopy (STEM/EDS) data demonstrated that the films covered the substrate uniformly. Catalysts prepared with 3 wt % Pt showed that the Pt remained well dispersed on the perovskite film, even after repeated oxidations and reductions at 1073 K. Despite the high Pt dispersion, CO adsorption at room temperature was negligible. Compared with conventional Pt on MgAl2O4, the reduced forms of the LaCoO3-containing catalyst were highly active for the CO oxidation and water gas shift (WGS) reactions, while the oxidized catalysts showed much lower activities. Surprisingly, the reduced catalysts were much less active than the oxidized catalysts for toluene hydrogen. Catalysts prepared from thin films of Co3O4 or La2O3 exhibited properties more similar to Pt/MgAl2O4. Possible reasons for how LaCoO3 affects properties are discussed.