Oil refinery wastewater treatment in the Niger Delta, Nigeria: current practices, challenges, and recommendations

Adsorption-Enhanced Ceramic Membrane Filtration Using Fenton Oxidation for Advanced Treatment of Refinery Wastewater: Treatment Efficiency and Membrane-Fouling Control

With the development of the refining industry, the treatment of refinery wastewater has become an urgent problem. In this study, a ceramic membrane (CM) was combined with Fenton-activated carbon (AC) adsorption to dispose of refinery wastewater. The effect of the combined process was analyzed using excitation-emission matrix (EEM), ultraviolet-visible (UV-vis) and Fourier transform infrared spectroscopies (FTIR). Compared with direct filtration, the combined process could significantly improve the removal of organic pollution, where the removal rate of the COD and TOC could be 70% and the turbidity removal rate was above 97%. It was found that the effluent could meet the local standards. In this study, the membrane fouling was analyzed for the impact of the pretreatment on the membrane direction. The results showed that Fenton-AC absorption could effectively alleviate membrane fouling. The optimal critical flux of the combined process was increased from 60 to 82 L/(m²·h) compared with direct filtration. After running for about 20 d, the flux remained at about 55 L/(m²·h) and the membrane-fouling resistance was only 1.2 × 10¹² m^-1. The Hermia model revealed that cake filtration was present in the early stages of the combined process. These results could be of great use in improving the treatment efficiency and operation cycle of refinery wastewater.

Pitfalls of Wastewater Treatment in Oil Refinery Enterprises in Kazakhstan—A System Approach

The present article is an assessment of wastewater treatment processes in the oil refinery sector in Kazakhstan by comparing relevant experience of developed and developing countries. The legislation in this sphere, the treatment methods, the discharge process and the effect on the environment were evaluated following international and national regulations. In our study, the wastewater systems in three factories in Kazakhstan were assessed. Results show that, even though the environmental regulation in Kazakhstan promotes the polluter pays principle and follows the World Health Organization (WHO) recommendations, the oil refinery plants in Kazakhstan still contain exceeding concentrations of pollutants in their effluents. One issue is that the local legislation allows disposal of wastewater to natural or artificial ponds as long as the concentrations of pollutants in effluents are less than the already existing concentrations in the pond. Consequently, the factories can use ponds with an initially high concentration of contaminants. The high initial concentration of pollutants in the pond water is due to wastewater discharged before the implementation of current environmental regulations. This issue in the current legislation leads to the situation where there is no incentive for efficient wastewater treatment. The national law also lacks regulations regarding which methodology should be used to assess the pollutants in the wastewater. Thus, the control by national environmental office for each enterprise is negotiated separately between the factory and the governmental body. This gives the factory a strong position to define the parameters assessing the effluents. This has led to none of the factories measuring, e.g., heavy metals in discharged wastewater. Total petroleum hydrocarbons (TPH) concentration in wastewater is often exceeded at each factory and there is no analysis done for different hydrocarbon fraction. To overcome the issues described in the present study, we strongly recommended a unified and transparent methodology for the country’s oil refinery industry to assess important pollutants in discharged wastewater.

Crude oil removal from aqueous solution using raw and carbonized Xanthoceras sorbifolia shells

Fruit shell residue from Xanthoceras sorbifolia was investigated as a potential biosorbent to remove crude oil from aqueous solution. The shell powder and its carbonized material were compared while assessing various factors that influenced oil removal capacity. The structure and sorption mechanism were characterized using scanning electron microscopy and Fourier-transform infrared spectroscopy. The oil removal capacity of the raw material (75.1 mg g^-1) was better than the carbonized material (49.5 mg g^-1). The oil removal capacity increased with greater saponin content, indicating that hydrophobic and lipophilic surface characteristics of the saponins improved adsorption by the raw X. sorbifolia shell. An orthogonal experimental design was used to optimize the adsorption. Using 4 g L^-1 of raw X. sorbifolia shell (particle size of < 0.15 mm), the highest crude oil removal efficiency was obtained using an initial oil concentration of 400 mg L^-1, adsorption temperature of 30 °C, adsorption time of 10 min at a shaking speed of 150 rpm. The adsorption of crude oil onto X. sorbifolia shell was best described using a pseudo-second-order kinetic model. Raw X. sorbifolia shell material was more efficient than the carbonized material at crude oil removal from aqueous solution. This was attributable to the functional groups of saponins in raw X. sorbifolia shell. This study highlights that some agricultural and forest residues could be a promising source of low-cost biosorbents for oil contaminants from water-without requiring additional processing such as carbonization.

Photocatalytic Degradation of 4-Nitrophenol by C, N-TiO2: Degradation Efficiency vs. Embryonic Toxicity of the Resulting Compounds

The photocatalytic activity of TiO₂ based photocatalysts can be improved by structural modification and elemental doping. In this study, through rational design, one type of carbon and nitrogen co-doped TiO₂ (C, N-TiO₂) photocatalyst with mesoporous structure was synthesized with improved photocatalytic activity in degrading 4-nitrophenol under simulated sunlight irradiation. The photocatalytic degradation efficiency of the C, N-TiO₂ was much higher than the anatase TiO₂ (A-TiO₂) based on absorbance and HPLC analyses. Moreover, using zebrafish embryos, we showed that the intermediate degradation compounds generated by photocatalytic degradation of 4-nitrophenol had higher toxicity than the parent compound. A repeated degradation process was necessary to render complete degradation and non-toxicity to the zebrafish embryos. Our results demonstrated the importance of evaluating the photocatalytic degradation efficiency in conjunction with the toxicity assessment of the degradation compounds.