Bismuth vanadate-based semiconductor photocatalysts: a short critical review on the efficiency and the mechanism of photodegradation of organic pollutants

Versatile application of BiVO4/TiO2 S-scheme photocatalyst: Photocatalytic CO2 and Cr(VI) reduction

Herein, the synthesis, characterization, and reduction properties of 2D TiO₂ aerogel powder decorated with BiVO₄ (TiO₂/BiVO₄) were investigated for versatile applications. First, 2D TiO₂ was prepared via lyophilization and subsequently modified with BiVO₄ using a wet impregnation method. The morphology, structure, composition, and optical properties were evaluated using transmission electron microscopy (TEM), X-ray diffractometry (XRD), laser-induced breakdown spectroscopy (LIBS), and diffuse reflectance spectroscopy (DRS), respectively. Significantly enhanced photocurrent densities (by 3-15 times) were obtained for TiO₂/BiVO₄ compared to those of pure TiO₂ and BiVO₄. The reduction of toxic Cr(VI) to Cr(III) was assessed, including the effect of pH on overall photocatalytic efficiency. Under acidic conditions (pH ∼ 2), Cr(VI) reduction efficiency reached 100% within 2 h. For photocatalytic CO₂ reduction, the highest yields of CH₄ and CO were obtained using TiO₂/BiVO₄. A higher efficiency for both applications was achieved because of the better separation of the electron-hole pairs in TiO₂/BiVO₄. The excellent stability of TiO₂/BiVO₄ over repeated runs highlights its potential for use in versatile environmental applications. The efficiency of TiO₂/BiVO₄ is due to the interplay of the structure, morphology, composition, and photoelectrochemical properties that favour the material for the presented herein photocatalytic applications.

Investigation of BiVO4-based advanced oxidation system for decomposition of organic compounds and production of reactive sulfate species

Growth of population and expansion of industries lead to increasing contamination of environment with various organic pollutants. If not properly cleaned, wastewater contaminates freshwater resources, aquatic environment and has huge negative impact on ecosystems, quality of drinking water and human health, therefore new and effective purification systems are in demand. In this work bismuth vanadate-based advanced oxidation system (AOS) for the decomposition of organic compounds and production of reactive sulfate species (RSS) was investigated. Pure and Mo-doped BiVO₄ coatings were synthesized using sol-gel process. Composition and morphology of coatings were characterized using X-ray diffraction and scanning electron microscopy techniques. Optical properties were analyzed using UV-vis spectrometry. Photoelectrochemical performance was studied using linear sweep voltammetry, chronoamperometry and electrochemical impedance spectroscopy. It was shown that increase in Mo content affects the morphology of BiVO₄ films, reduces charge transfer resistance and enhances the photocurrent in the solutions of sodium borate buffer (with and without glucose) and Na₂SO₄. Mo-doping of 5-10 at.% leads to 2- to 3-fold increase in photocurrents. Faradaic efficiencies of RSS formation ranged between 70 and 90 % for all samples irrespective of Mo content. All studied coatings demonstrated high stability in long-lasting photoelectrolysis. In addition, effective light-assisted bactericidal performance of the films in deactivation of Gram positive Bacillus sp. bacteria was demonstrated. Advanced oxidation system designed in this work can be applied in sustainable and environmentally friendly water purification systems.

Advanced oxidation processes for the removal of mono and polycyclic aromatic hydrocarbons - A review

Aromatic hydrocarbons (AHs) are toxic environmental contaminants presented in most of the environmental matrices. Advanced oxidation processes (AOPs) for the removal of AHs in the account of complete mineralization from various environmental matrices have been reviewed in this paper. An in-depth discussion on various AOPs for mono (BTEX) and polyaromatic hydrocarbons (PAHs) and their derivatives is presented. Most of the AOPs were effective in the removal of AHs from the aquatic environment. A comparative study on the degradation of various AHs revealed that the oxidation of the AHs is strongly dependent on the number of aromatic rings and the functional groups attached to the ring. The formation of halogenated and nitrated derivatives of AHs in the real contaminated water containing chloride, nitrite, and nitrate ions seems to be a challenge in using the AOPs in real systems. The phenolic compounds, quinone, alcohols, and aliphatic acids are the important byproducts formed during the oxidation of AHs, initiated by the attack of reactive oxygen species (ROS) on their electron-rich center. In conclusion, AOPs are the adaptable method for the removal of AHs from different environmental matrices. The persulfate-based AOPs were applied in the soil phase removal as an in situ chemical oxidation of AHs. Moreover, the combination of AOPs will be a conclusive solution to avoid or minimize unexpected or other toxic intermediate products and to obtain rapid oxidation of AHs.

Electrospun composite nanofibers as novel high-performance and visible-light photocatalysts for removal of environmental pollutants: A review

Environmental pollution caused by industries and human manipulations is coming a serious global challenge. On the other hand, the world is facing an energy crisis caused by population growth. Designing solar-driven photocatalysts which are inspired by the photosynthesis of plant leaves is a fantastic solution to use solar energy as green, available, and unlimited energy containing ∼50% visible light for the removal of environmental pollutants. The polymeric and non-polymeric-based electrospun composite nanofibers (NFs) are as innovative photocatalytic candidates which increase photocatalytic activity and transition from UV light to visible light and overcome the aggregation, photocorrosion, toxicity, and hard recycling and separation of the nanosized powder form of photocatalysts. The composite NFs are fabricated easily by either embedding the photocatalytic agents into the NFs during electrospinning or via their decorating on the surface of NFs post-electrospinning. Polyacrylonitrile-based, tungsten trioxide-based, zinc oxide-based, and titanium dioxide-based composite NFs were revealed as the most reported composite NFs. All the lately investigated electrospun composite NFs indicated long-term stability, high photocatalytic efficiency (∼> 80%) within a short time of light radiation (10-430 min), and high stability after several cycles of use. They were applied in various applications including degradation of dyes/antibiotics, water splitting, wastewater treatment, antibacterial usage, etc. The photogenerated species especially holes, O₂^∙-, and ^.OH were mostly responsible for the photocatalytic mechanism and pathway. The electrospun composite NFs have the potential to use in large-scale productions in condition that their thickness and recycling conditions are optimized, and their toxicity and detaching are resolved.

A facile synthesis of CuBi2O4 hierarchical dumbbell-shaped nanorod cluster: a promising photocatalyst for the degradation of caffeic acid

The present study reports on the synthesis of Cu-bismuth oxide (CuBi₂O₄)-based nanorods by using a simple co-precipitation method for the photocatalytic degradation of caffeic acid (CA). The incorporation of Cu metal ions during the synthesis of CuBi₂O₄ nanorods might be advantageous to avoid the aggregation and control the leach out of metal ions. The calculated bandgap values of ~ 1.04, 1.02, and 0.94 eV were observed for CuBi₂O₄ with different amounts of Cu 1.0, 0.50, and 0.25 g, respectively. Varying the quantity of Cu metal ions easily tuned the bandgap value within the CuBi₂O₄-based nanorods. However, a further decrease in the bandgap value increased the recombination rate, and the less photocatalyst performance was observed. The CA degradation could be explained based on the species distribution. The CA pKa was mainly located between pKa₁ and pKa₂ of 4.43 and 8.6, respectively. The Cu within the CuBi₂O₄-based nanorods changed the electronic properties and the antibacterial ability. Therefore, the synthesized CuBi₂O₄-based nanorod cluster might be a promising material for the photocatalytic degradation of CA.

Application of BiVO4–Microalgae Combined Treatment to Remove High Concentration Mixture of Sulfamethazine and Sulfadiazine

Sulfonamides (SAs) are the most common and bio-refractory antibiotics detected in surface water systems, which cause long-term toxic effects on aquatic organisms. This study used the combination of a BiVO4 photocatalyst and freshwater micro-green alga (Dictyosphaerium sp.) to remove sulfadiazine (SD) and sulfamethazine (SM2) at an initial concentration of 5 mg/L (1:1 v/v) for 7 days. We set up three gradient concentrations of BiVO4 (0.5, 1 and 2 g/L) combined with the same concentration (80 mg/L) of Dictyosphaerium sp. and then prepared corresponding concentrations of pure BiVO4 and pure microalgae as controls. We evaluated the ability of BiVO4 and Dictyosphaerium sp. combined technology to remove SAs by observing the removal efficiency of antibiotics and explained the degradation mechanism of antibiotics and the key role of microalgae by studying the changes of reactive oxygen species (ROS) and inorganic ions (nitrogen, sulfur). The results showed that the degradation rate of these two SAs in the 0.5 g/L BiVO4–algae group could reach >96% within 7 d, which was higher than that in the 2 g/L BiVO4 group (93%) and the algae group (28%). The increased degradation efficiency of SAs in BiVO4 and microalgae systems was mainly due to the increased amount of ROS. Meanwhile, more SAs were degraded to inorganic compounds such as NH4+-N, NO3−-N and SO42−-S under ROS stress. It was found that microalgae can absorb the degradation products of antibiotics such as NH4+-N for their own growth, thereby reducing the toxicity of antibiotic by-products. In addition, BiVO4 had no damaging effect on the autofluorescence intensity of the microalgae. Our study provides an efficient and eco-economic approach to remove antibiotics using visible-light irradiation in aquatic environments and provides new insights into the biological removal of other antibiotic contaminants in aquatic environments.

Recent Progress and Prospects in Catalytic Water Treatment

Presently, conventional technologies in water treatment are not efficient enough to completely mineralize refractory water contaminants. In this context, the implementation of catalytic processes could be an alternative. Despite the advantages provided in terms of kinetics of transformation, selectivity, and energy saving, numerous attempts have not yet led to implementation at an industrial scale. This review examines investigations at different scales for which controversies and limitations must be solved to bridge the gap between fundamentals and practical developments. Particular attention has been paid to the development of solar-driven catalytic technologies and some other emerging processes, such as microwave assisted catalysis, plasma-catalytic processes, or biocatalytic remediation, taking into account their specific advantages and the drawbacks. Challenges for which a better understanding related to the complexity of the systems and the coexistence of various solid-liquid-gas interfaces have been identified.

A sandwich-type photoelectrochemical aptasensor using Au/BiVO4 and CdS quantum dots for carcinoembryonic antigen assay

A novel sandwich-type photoelectrochemical (PEC) aptasensor for the carcinoembryonic antigen (CEA) assay was fabricated using the CEA aptamer, Au/BiVO₄ and CdS quantum dots (CdS QDs). In virtue of the localized surface plasmon resonance effect of Au nanoparticles, Au/BiVO₄ showed an effective utilization of visible light and excellent photoactivity, and was employed as the photoanode. After CdS QDs were conjugated to Au/BiVO₄ through the sandwich structure based on the hybridization of the CEA aptamer with two partially complementary single-stranded DNA molecules, the photocurrents were further enhanced by a resonance energy transfer between CdS QDs and Au nanoparticles. Meanwhile, the consumption of the photo-induced holes by ascorbic acid could also retard the combination of the electron-hole pairs and cause an increase of the photocurrents. However, the specific recognition of CEA by the CEA aptamer could destroy the sandwich structure and remarkably weaken the photocurrent response. Thus, the quantitative detection of CEA was connected with the decrease of the photocurrent. Benefitting from the above methods for signal enhancement, the PEC aptasensor showed a wide sensing range of 0.0001-10 ng mL^-1 and a low detection limit of 0.047 pg mL^-1 for CEA detection. The specificity, stability and recoveries of the PEC aptasensor were also excellent. Therefore, the construction of the present PEC aptasensor provides a universal and practical method for sensing other substances.

Binary and Ternary Vanadium Oxides: General Overview, Physical Properties, and Photochemical Processes for Environmental Applications

This review article is a comprehensive report on vanadium oxides which are interesting materials for environmental applications. Therefore, a general overview of vanadium and its related oxides are presented in the first two parts. Afterwards, the physical properties of binary and ternary vanadium oxides in single and mixed valence states are described such as their structural, optical, and electronic properties. Finally, the use of these vanadium oxides in photochemical processes for environmental applications is detailed, especially for the production of hydrogen by water splitting and the degradation of organic pollutants in water using photocatalytic and photo-Fenton processes. The scientific aim of such a review is to bring a comprehensive tool to understand the photochemical processes triggered by vanadium oxide based materials where the photo-induced properties are thoroughly discussed based on the detailed description of their intrinsic properties.

Plasmonic silver/silver oxide nanoparticles anchored bismuth vanadate as a novel visible-light ternary photocatalyst for degrading pharmaceutical micropollutants

The degradation of pharmaceutical micropollutants is an intensifying environmental problem and synthesis of efficient photocatalysts for this purpose is one of the foremost challenges worldwide. Therefore, this study was conducted to develop novel plasmonic Ag/Ag₂O/BiVO₄ nanocomposite photocatalysts by simple precipitation and thermal decomposition methods, which could exhibit higher photocatalytic activity for mineralized pharmaceutical micropollutants. Among the different treatments, the best performance was observed for the Ag/Ag₂O/BiVO₄ nanocomposites (5 wt.%; 10 min's visible light irradiation) which exhibited 6.57 times higher photodegradation rate than the pure BiVO₄. Further, the effects of different influencing factors on the photodegradation system of tetracycline hydrochloride (TC-HCl) were investigated and the feasibility for its practical application was explored through the specific light sources, water source and cycle experiments. The mechanistic study demonstrated that the photogenerated holes (h⁺), superoxide radicals (•O₂^-) and hydroxyl radicals (•OH) participated in TC-HCl removal process, which is different from the pure BiVO₄ reaction system. Hence, the present work can provide a new approach for the formation of novel plasmonic photocatalysts with high photoactivity and can act as effective practical application for environmental remediation.

Mechanistic investigation of photocatalytic degradation of organic dyes by a novel zinc coordination polymer

Mechanistic presentation of the photocatalytic degradation of organic dye molecules by absorbing UV-vis light energy that spans the florescent compound TIPA's HOMO to LUMO band gap.

Enhanced photocatalytic activity and charge transfer of a TiO2/BiVO4 nanostructured composite

The electron transfer from BiVO₄ to TiO₂ and the enhancement of ˙O²⁻ radical generation after TiO₂ deposition.