Iron ore or manganese ore filled constructed wetlands enhanced removal performance and changed removal process of nitrogen under sulfamethoxazole and trimethoprim stress

The introduction of influent sulfamethoxazole loads induces changes in the removal pathways of sulfamethoxazole in vertical flow constructed wetlands featuring hematite substrate

High frequent detection of sulfamethoxazole (SMX) in wastewater cannot be effectively removed by constructed wetlands (CWs) with a traditional river sand substrate. The role of emerging substrate of hematite in promoting SMX removal and the effect of influent SMX loads remain unclear. The removal efficiency of SMX in hematite CWs was significantly higher than that in river sand CWs by 12.7-13.8% by improving substrate adsorption capacity, plant uptake and microbial degradation. With increasing influent SMX load, the removal efficiency of SMX in hematite CWs slightly increased, and the removal pathways varied significantly. The contribution of plant uptake was relatively small (< 0.1%) under different influent SMX loads. Substrate adsorption (37.8%) primarily contributed to SMX removal in hematite CWs treated with low-influent SMX. Higher influent SMX loads decreased the contribution of substrate adsorption, and microbial degradation (67.0%) became the main removal pathway. Metagenomic analyses revealed that the rising influent load increased the abundance of SMX-degrading relative bacteria and the activity of key enzymes. Moreover, the abundance of high-risk ARGs and sulfonamide resistance genes in hematite CWs did not increase with the increasing influent load. This study elucidates the potential improvements in CWs with hematite introduction under different influent SMX loads.

Autotrophic denitrification based on sulfur-iron minerals: advanced wastewater treatment technology with simultaneous nitrogen and phosphorus removal

Autotrophic denitrification technology has many advantages, including no external carbon source addition, low sludge production, high operating cost efficiency, prevention of secondary sewage pollution, and stable treatment efficiency. At present, the main research on autotrophic denitrification electron donors mainly includes sulfur, iron, and hydrogen. In these autotrophic denitrification systems, pyrite has received attention due to its advantages of easy availability of raw materials, low cost, and pH stability. When pyrite is used as a substrate for autotropic denitrification, sulfide (S2-) and ferrous ion (Fe2+) in the substrate will provide electrons to convert nitrate (NO3-) in sewage first to nitrite (NO2-), then to nitrogen (N2), and finally to discharge the system. At the same time, sulfide (S2-) loses electrons to sulfate (SO42-) and ferrous ion (Fe2+) loses electrons to ferric iron (Fe3+). Phosphates (PO43-) in wastewater are chemically combined with ferric iron (Fe3+) to form ferric phosphate (FePO4) precipitate. This paper aims to provide a detailed and comprehensive overview of the dynamic changes of nitrogen (N), phosphorus (P), and other substances in the process of sulfur autotrophic denitrification using iron sulfide, and to summarize the factors that affect wastewater treatment in the system. This work will provide a relevant research direction and theoretical basis for the field of sulfur autotrophic denitrification, especially for the related experiments of the reaction conversion of various substances in the system.

Optimization of process parameters for trimethoprim and sulfamethoxazole removal by magnetite-chitosan nanoparticles using Box-Behnken design

The contamination of the aquatic environment with antibiotics is among the major and developing problems worldwide. The present study investigates the potential of adsorbent magnetite-chitosan nanoparticles (Fe3O4/CS NPs) for removing trimethoprim (TMP) and sulfamethoxazole (SMX). For this purpose, Fe3O4/CS NPs were synthesized by the co-precipitation method, and the adsorbent characteristics were investigated using XRD, SEM, TEM, pHzpc, FTIR, and VSM. The effect of independent variables (pH, sonication time, adsorbent amount, and analyte concentration) on removal performance was modeled and evaluated by Box-Behnken design (BBD). The SEM image of the Fe3O4/CS adsorbent showed that the adsorbent had a rough and irregular surface. The size of Fe3O4/CS crystals was about 70 nm. XRD analysis confirmed the purity and absence of impurities in the adsorbent. TEM image analysis showed that the adsorbent had a porous structure, and the particle size was in the range of nanometers. In VSM, the saturation magnetization of Fe3O4/CS adsorbent was 25 emu g-1 and the magnet could easily separate the adsorbent from the solution. The results revealed that the optimum condition was achieved at a concentration of 22 mg L-1, a sonication time of 15 min, an adsorbent amount of 0.13 g/100 mL, and a pH of 6. Among different solvents (i.e., ethanol, acetone, nitric acid, and acetonitrile), significant desorption of TMP and SMX was achieved using ethanol. Also, results confirmed that Fe3O4/CS NPs can be used for up to six adsorption/desorption cycles. In addition, applying the Fe3O4/CS NPs on real water samples revealed that Fe3O4/CS NPs could remove TMP and SMX in the 91.23-95.95% range with RSD (n = 3) < 4. Overall, the Fe3O4/CS NPs exhibit great potential for removing TMP and SMX antibiotics from real water samples.

Effects of antibiotics on corncob supported solid-phase denitrification: Denitrification and antibiotics removal performance, mechanism, and antibiotic resistance genes

Solid-phase denitrification (SPD) has been used in wastewater treatment plant effluent to enhance nitrate removal, and antibiotics co-existing in the effluent is a common environmental problem. In this study, it was systematically investigated the effect of single trace sulfamethoxazole (SMX)/trimethoprim (TMP) and their mixture on microbial denitrification performance, the antibiotics removal, and antibiotics resistance genes (ARGs) in corncob supported SPD system. The average denitrification rate was improved by 46.90% or 61.09% with single 50 µg/L SMX or TMP, while there was no significant inhibition with mixed SMX and TMP. The abundance of dominant denitrifiers (Comamonadaceae family and Azospia) and fermentation bacteria (Ancalomicrobium) were consistent with the denitrification performance of different antibiotics groups. Single SMX and TMP achieved relatively higher denitrification gene and enzyme abundance. Mixed SMX and TMP improved the denitrification gene copies, but they reduced the key denitrification enzymes except for EC 1.7.7.2. Additionally, the removal efficiency of TMP (56.70% ± 3.18%) was higher than that of SMX (25.44% ± 2.62%) in single antibiotic group, and the existence of other antibiotics (i.e. SMX or TMP) had no significant impact on the TMP or SMX removal performance. Biodegradation was the main removal mechanism of SMX and TMP, while sludge and corncob adsorption contributed a little to their removal. SMX had the risk of sulfanilamide resistance genes (SRGs) dissemination. Furthermore, network analysis indicated that Niveibacterium and Bradyrhizobium were the potential hosts of SRGs, which promoted the horizontal transmission of ARGs.

Application of manganese oxides in wastewater treatment: Biogeochemical Mn cycling driven by bacteria

Manganese oxides (MnOx) are recognized as a strongest oxidant and adsorbent, of which composites have been proved to be effective in the removal of contaminants from wastewater. This review provides a comprehensive analysis of Mn biochemistry in water environment including Mn oxidation and Mn reduction. The recent research on the application of MnOx in the wastewater treatment was summarized, including the involvement of organic micropollutant degradation, the transformation of nitrogen and phosphorus, the fate of sulfur and the methane mitigation. In addition to the adsorption capacity, the Mn cycling mediated by Mn(II) oxidizing bacteria and Mn(IV) reducing bacteria is the driving force for the MnOx utilization. The common category, characteristics and functions of Mn microorganisms in recent studies were also reviewed. Finally, the discussion on the influence factors, microbial response, reaction mechanism and potential risk of MnOx application in pollutants' transformation were proposed, which might be the promising opportunities for the future investigation of MnOx application in wastewater treatment.

Evaluation of the Respective Contribution of Anode and Cathode for Triclosan Degradation in a Bioelectrochemical System

In this work, the bioelectrochemical system (BES) is a feasible alternative for successfully degrading typical refractory emerging contaminant triclosan (TCS). A single-chamber BES reactor with an initial TCS concentration of 1 mg/L, an applied voltage of 0.8 V, and a solution buffered with 50 mM PBS degraded 81.4±0.2% of TCS, exhibiting TCS degradation efficiency improvement to 90.6±0.2% with a biocathode formed from a reversed bioanode. Both bioanode and biocathode were able to degrade TCS with comparable efficiencies of 80.8±4.9% and 87.3±0.4%, respectively. Dechlorination and hydrolysis were proposed as the TCS degradation pathway in the cathode chamber, and another hydroxylation pathway was exclusive in the anode chamber. Microbial community structure analysis indicated Propionibacteriaceae was the predominant member in all electrode biofilms, and the exoelectrogen Geobacter was enriched in anode biofilms. This study comprehensively revealed the feasibility of operating BES technology for TCS degradation.