Simultaneous analysis of nuclear and mitochondrial DNA, mRNA and miRNA from backspatter from inside parts of firearms generated by shots at "triple contrast" doped ballistic models

Forensically relevant anatomical brain regions cannot be sub-differentiated by RNA expression analysis

The contextualization of biological traces generated by severe head injuries can be beneficial for criminal investigations. Here we aimed to identify and validate mRNA candidates for a robust sub-differentiation of forensically and traumatologically relevant brain regions. To this purpose, massively parallel sequencing of whole transcriptomes in sample material taken from four different areas of the cerebral cortex (frontal, temporal, parietal, occipital lobe) was performed, followed by bioinformatical data analysis, classification, and biostatistical candidate selection. Candidates were evaluated by Multiplex-RT-PCR and capillary electrophoresis. Only a weak relative upregulation and solely for candidates expressed in the parietal lobe was observed. Two candidates with upregulation in the cerebellar region (PVALB and CDR2L) were chosen for further investigation; however, PVALB could not reliably and repeatedly be detected in any lobe whereas CDR2L was detectable in all lobes. Consequently, we suggest that differences in mRNA expression between four regions of the cerebral cortex are too small and less pronounced to be useful for and applicable in forensic RNA analysis. We conclude that sub-differentiation of these brain regions via RNA expression analysis is generally not feasible within a forensic scope.

Ten years of molecular ballistics-a review and a field guide

Molecular ballistics combines molecular biological, forensic ballistic, and wound ballistic insights and approaches in the description, collection, objective investigation, and contextualization of the complex patterns of biological evidence that are generated by gunshots at biological targets. Setting out in 2010 with two seminal publications proving the principle that DNA from backspatter collected from inside surfaces of firearms can be retreived and successfully be analyzed, molecular ballistics covered a lot of ground until today. In this review, 10 years later, we begin with a comprehensive description and brief history of the field and lay out its intersections with other forensic disciplines like wound ballistics, forensic molecular biology, blood pattern analysis, and crime scene investigation. In an application guide section, we aim to raise consciousness to backspatter traces and the inside surfaces of firearms as sources of forensic evidence. Covering crime scene practical as well as forensic genetic aspects, we introduce operational requirements and lay out possible procedures, including forensic RNA analysis, when searching for, collecting, analyzing, and contextualizing such trace material. We discuss the intricacies and rationales of ballistic model building, employing different tissue, skin, and bone simulants and the advantages of the “triple-contrast” method in molecular ballistics and give advice on how to stage experimental shootings in molecular ballistic research. Finally, we take a look at future applications and prospects of molecular ballistics.

A distant relationship?-investigation of correlations between DNA isolated from backspatter traces recovered from firearms, wound profile characteristics, and shooting distance

In molecular ballistics, where traces originating from the use of firearms against biological targets are investigated, "backspatter" traces are of particular importance. This biological material comprising blood and tissue from the victim is propelled back from the bullet entry site towards the direction of the shooter and can consolidate and persist on the inner and outer surfaces of the firearm, from where it can be collected and analyzed. Thus, a connection between the weapon and the victim can be established solely by molecular biological trace analysis. For the criminalistic investigation of gun-related crimes, the determination of the distance between the weapon and the victim can be of critical importance in reconstructing the circumstances of a crime. In this study, we investigated possible correlations between the shooting distance and the amount of backspatter in/on the used firearm. To this purpose, we employed a previously established skull model and performed shootings in triplicates from various distances up to 50 cm with two types of handguns (pistol and revolver). Backspatter was collected from various sampling locations, and DNA contents were quantified. A post-shooting wound channel evaluation was conducted by optical and radiological evaluation. The obtained DNA yields varied considerably between replicates from the same and from different distances. In contrast, apart from contact shots, no meaningful differences were observable in wound channel evaluations. In summary, no meaningful correlation between backspatter distribution and DNA yields, the shooting distance and the condition of the wound channel could be established.

Evaluation of the backspatter generation and wound profiles of an anatomically correct skull model for molecular ballistics

Molecular ballistics connects the molecular genetic analysis of biological traces with the wounding events and complex forensic traces investigated in terminal ballistics. Backspatter, which originates from a projectile hitting a biological target when blood and/or tissue is propelled back into the direction of the gun, is of particular interest; those traces can consolidate and persist on the outer and inner surfaces of firearms and serve as evidence in criminal investigations. Herein, we are the first to present an anatomically correct head model for molecular ballistic research based on a polyurethane skull replica enclosing tissue-simulating sponge material that is doped with "triple-contrast" mixture (EDTA-blood, acrylic paint, and an x-ray contrast agent). Ten percent ballistic gelatin was used as brain simulant. We conducted contact and intermediate-range shots with a Glock 19 pistol (9 mm Luger), a pump-action shotgun (12/70 slugs), and blank cartridge handguns. Each shot was documented by a high-speed camera at 35,000 fps. Apart from the blank cartridge guns, all gunshots penetrated the skull model and created backspatter, which was recovered from the distal part of the barrels and analyzed. The pistol contact shots and one of three shotgun shots yielded full STR profiles. While the shotgun slugs destroyed the skulls, the remaining models could be used for radiological and optical fracture and wound channel evaluation. Known backspatter mechanisms and their respective timing could be confirmed visually by video analysis. Our complete model setup proved to be well applicable to molecular ballistic research as well as wound channel and fracture pattern investigation.

Distortion of the temporary cavity and its influence on staining in firearm barrels

After contact shots to the head, biological traces can be found inside the barrel of the firearm. Experimental protocols to generate this sort of staining, using 12 cm gelatin cubes containing thin foil bags filled with acrylic paint, human blood, and radiocontrast agent, have been developed. Previous research on shots fired at a distance has shown the underlay sustaining these gelatin cubes has an influence on experimental results. This study was conducted to investigate the role of the sustaining base of the gelatin blocks during contact shots, and its influence on the staining result inside firearm barrels. Eighteen contact shots were performed using 22 LR, 32 ACP (7.65 Browning) and 9 mm Luger semi-automatic pistols. With each pistol, shots were fired onto six gelatin cubes; three placed upon a rigid platform and three upon an elastic underlay. The shots were recorded by a high-speed video camera as they penetrated the gelatin cube. Any staining present inside the firearm barrels after the shots were fired was documented by endoscopy. Cross sections of the gelatin blocks were then compared to the high-speed video. It was found that the nature of the staining inside the barrel was not influenced by the underlay sustaining the target model. In the experiment using a 9 mm Luger, the rigid counterfort provoked a visible distortion of the temporary cavity, but, cross sectional analysis of the gelatin cubes did not reveal a relevant influence of the sustaining underlay on the crack length in the gelatin. This could be explained by a secondary expansion of the temporary cavity left by the projectile as a consequence of subsequent inflow of muzzle gases.

RNA/DNA co-analysis from bloodstains on aged polyvinyl-alcohol gloves prepared for securing evidence from the hands of victims of fatal gunshot injuries

In contrast to cumulative techniques (e.g., tape-lift) for qualitative gunshot residues (GSR) analysis, topographic methods are commonly applied to preserve the integrity of evidence from a shooter's or victim's hand in cases of gun-related crimes. Topographic sampling techniques employing adhesive foils, latex, or the polyvinyl alcohol (PVAL) method enable unambiguous sampling of biological and non-biological trace material while preserving its spatial distribution and relation to each other. The PVAL method in particular allows for a topographically veridic and quantitative conservation of traces of GSR and biological stains that are embedded in the PVAL glove, because it completely removes these traces from the hand. The present study investigated the success rates of STR profiling and the detection of blood and brain-specific gene expression from minimal traces of blood splatter as well as parallel to the positive detection of gunshot residues embedded in 17 PVAL gloves taken from the hands of deceased persons in the context of homicide cases in the period between 1996 and 2003. The water-soluble PVAL matrix is shown to be fully compatible with successful STR profiling and the detection of blood- and brain-specific miRNA expression, even after up to 20 years of storage, demonstrating that this sampling technique offers advantages compared to other more simplistic sampling methods like taping.

The reference cube: A new ballistic model to generate staining in firearm barrels

After contact shots to the head biological traces can be found inside firearm barrels. So far silicone coated, gelatin filled box models were used to generate such staining according to the triple contrast method (mixture of acrylic paint, barium sulfate and blood sealed in a thin foil bag). This study was conducted to develop a transparent ballistic model allowing contact shots. Gelatin filled polyethylene bottles with and without a silicone coat were tested in comparison to non-covered gelatin blocks. Finally, thin foil bags of 5 cm × 5 cm dimension were glued on a synthetic absorbent kitchen wipe on top of which 1 L 10% gelatin solution was molded to create blocks of 8.5 cm length. A kitchen wipe with a paint pad on its inside formed the front of the cube. Three contact shots each with a 9 mm Luger pistol and a .38 special revolver were performed on all model variations. The staining was documented by endoscopy and swabs gathered from both ends of the barrel were analyzed by quantitative PCR. Reliable staining was achieved using the front covered gelatin block with comparable results to the silicone coated box model used before. For further research using ballistic models to simulate a human head a symmetric form of the gelatin block such as a cube is recommended.