Laser-Induced Acoustic Desorption Atmospheric Pressure Photoionization via VUV-Generating Microplasmas

Postionization Mass Spectrometry Imaging: Past, Present, and Future

Mass spectrometry imaging (MSI) technologies are widely used today to study the in situ spatial distributions for a variety of analytes. As these technologies advance, the pursuit of higher resolution in MSI has intensified. The limitation of direct desorption/ionization is its insufficient ionization, posing a constraint on the advancement of high-resolution MSI technologies. The introduction of postionization process compensates the low ionization efficiency caused by sacrificing the desorption area while pursuing high spatial resolution, resolving the conflict between high spatial resolution and high sensitivity in direct desorption/ionization method. Here, we discuss the sampling and ionization steps of MSI separately, and review the postionization methods in MSI according to three different sampling modes: laser sampling, probe sampling, and ion beam sampling. Postionization technology excels in enhancing ionization efficiency, boosting sensitivity, mitigating discrimination effect, simplifying sample preparation, and expanding the scope of applicability. These advantages position postionization technology as a promising tool for biomedical sciences, materials sciences, forensic analysis and other fields.

Vaporization of Intact Neutral Biomolecules Using Laser-Based Thermal Desorption

The production of a clean neutral molecular sample is a crucial step in many gas-phase spectroscopy and reaction dynamics experiments investigating neutral species. Unfortunately, conventional methods based on heating cannot be used with most nonvolatile biomolecules due to their thermal instability. In this paper, we demonstrate the application of laser-based thermal desorption (LBTD) to produce neutral molecular plumes of biomolecules such as dipeptides and lipids. Specifically, we report mass spectra of glycylglycine, glycyl-l-alanine, and cholesterol obtained using LBTD vaporization, followed by soft femtosecond multiphoton ionization (fs-MPI) at 400 nm. For all molecules, the signal from the intact precursor ion was observed, highlighting the softness and applicability of the LBTD and fs-MPI approach. In more detail, cholesterol underwent hardly any fragmentation. Both dipeptides fragmented significantly, although mostly through only a single channel, which we attribute to the fs-MPI process.

Insights into a Low-Rank Naomaohu Coal Structural Information by Multistage Fractions Coupled with LIAD-VUVPI-TOFMS

In-depth insights into the chemical composition and structural information of coal are an effective way to improve the efficiency of coal utilization. Laser-induced acoustic desorption coupling with vacuum ultraviolet photoionization time-of-flight mass spectrometry (LIAD-VUVPI-TOFMS) was applied to structural characterization of cyclohexane extracts of low-rank Naomaohu coal. The characterization of four types (12 model compounds) of mixed coal model compounds (three compounds per category)-saturated hydrocarbons, substitute aromatic hydrocarbons, aromatic hydrocarbons, and aromatic heteroatom rings-demonstrated that the approach can provide intact molecular weight information. The cyclohexanone extract (E _CYC) was obtained by microwave-assisted extraction and separated into four group components (F1-4) by column chromatography to achieve component classification and simplify analysis. The molecular weight and structure were obtained by LIAD-VUVPI-TOFMS and synchronous fluorescence spectroscopy, combined with microwave-assisted extraction and column chromatography to separate product characteristics. Chemical components of a total of 248 species were observed, of which 46 are derived from aliphatic hydrocarbons embedded in the coal skeleton structure, 132 species are derived from aromatic hydrocarbons embedded in the coal skeleton structure, 61 are derived from possible coal skeleton units (compounds have obvious stacking and bonding effects), and 9 could not be determined (aromatic hydrocarbons or a possible coal skeleton structure unit).

LASER DESORPTION/ABLATION POSTIONIZATION MASS SPECTROMETRY: RECENT PROGRESS IN BIOANALYTICAL APPLICATIONS

Lasers have long been used in the field of mass spectrometric analysis for characterization of condensed matter. However, emission of neutrals upon laser irradiation surpasses the number of ions. Typically, only one in about one million analytes ejected by laser desorption/ablation is ionized, which has fueled the quest for postionization methods enabling ionization of desorbed neutrals to enhance mass spectrometric detection schemes. The development of postionization techniques can be an endeavor that integrates multiple disciplines involving photon energy transfer, electrochemistry, gas discharge, etc. The combination of lasers of different parameters and diverse ion sources has made laser desorption/ablation postionization (LD/API) a growing and lively research community, including two-step laser mass spectrometry, laser ablation atmospheric pressure photoionization mass spectrometry, and those coupled to ambient mass spectrometry. These hyphenated techniques have shown potentials in bioanalytical applications, with major inroads to be made in simultaneous location and quantification of pharmaceuticals, toxins, and metabolites in complex biomatrixes. This review is intended to provide a timely comprehensive view of the broadening bioanalytical applications of disparate LD/API techniques. We also have attempted to discuss these applications according to the classifications based on the postionization methods and to encapsulate the latest achievements in the field of LD/API by highlighting some of the very best reports in the 21st century. © 2020 John Wiley & Sons Ltd.

Laser Desorption Combined with Laser Postionization for Mass Spectrometry

Lasers with pulse lengths from nanoseconds to femtoseconds and wavelengths from the mid-infrared to extreme ultraviolet (UV) have been used for desorption or ablation in mass spectrometry. Such laser sampling can often benefit from the addition of a second laser for postionization of neutrals. The advantages offered by laser postionization include the ability to forego matrix application, high lateral resolution, decoupling of ionization from desorption, improved analysis of electrically insulating samples, and potential for high sensitivity and depth profiling while minimizing differential detection. A description of postionization by vacuum UV radiation is followed by a consideration of multiphoton, short pulse, and other postionization strategies. The impacts of laser pulse length and wavelength are considered for laser desorption or laser ablation at low pressures. Atomic and molecular analysis via direct laser desorption/ionization using near-infrared ultrashort pulses is described. Finally, the postionization of clusters, the role of gaseous collisions, sampling at ambient pressure, atmospheric pressure photoionization, and the addition of UV postionization to MALDI are considered.

Sweep Jet Collection Laser-Induced Acoustic Desorption Atmospheric Pressure Photoionization for Lipid Analysis Applications

Laser-induced acoustic desorption coupled to microplasma-based atmospheric pressure photoionization (LIAD-APPI) using a nebulized sweep jet to aid in dopant introduction and ion transmission has been applied to the analysis of model, apolar lipid compounds. Specifically, several sterols, sterol esters, and triacylglycerols were detected using dopants such as anisole and toluene. Additionally, several triacylglycerols, sterols, carboxylic acids, and hopanoids were detected from complex mixtures of olive oil and Australian shale rock extract as a first demonstration of the applicability of LIAD-APPI on real-world samples. Detection limits using a sweep jet configuration for α-tocopherol and cholesterol were found to be 609 ± 61 and 292 ± 29 fmol, respectively. For sterol esters and triacylglycerols with a large number of double bonds in the fatty acid chain, LIAD-APPI was shown to yield greater molecular ion or [M+NH₄]⁺ abundances than those with saturated fatty acid chains. Dopants such as anisole and toluene, with ionization potentials (IPs) of 8.2 and 8.8 eV, respectively, were tested. A greater degree of fragmentation with several of the more labile test compounds was observed using toluene. Overall, LIAD-APPI with a nebulized sweep jet requires minimal sample preparation and is a generally useful and sensitive analysis technique for low-polarity mixtures of relevance to biochemical assays and geochemical profiling. Graphical Abstract.